Search NASA⌕ Search

SEARCH · Search NASA

Results for “TELLURIDES”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records

Thermal conductivity of bulk nanostructured lead telluride

Thermal conductivity of lead telluride with embedded nanoinclusions was examined using Monte Carlo simulations with intrinsic phonon transport properties obtained from first-principles-based lattice dynamics. The nanoinclusion/matrix interfaces were set to completely reflect phonons to model the maximum interface-phonon-scattering scenario. The simulations with the geometrical cross section and volume fraction of the nanoinclusions matched to those of the experiment show that the experiment has already reached the theoretical limit of thermal conductivity. The frequency-dependent analysis additionally identifies that the thermal conductivity reduction is dominantly attributed to scattering of low frequency phonons and demonstrates mutual adaptability of nanostructuring and local disordering.

36 MATERIALS SCIENCE↗

Synthesis and evaluation of lead telluride/bismuth antimony telluride nanocomposites for thermoelectric applications

Heterogeneous nanocomposites of p-type bismuth antimony telluride (Bi{sub 2-x}Sb{sub x}Te{sub 3}) with lead telluride (PbTe) nanoinclusions have been prepared by an incipient wetness impregnation approach. The Seebeck coefficient, electrical resistivity, thermal conductivity and Hall coefficient were measured from 80 to 380 K in order to investigate the influence of PbTe nanoparticles on the thermoelectric performance of nanocomposites. The Seebeck coefficients and electrical resistivities of nanocomposites decrease with increasing PbTe nanoparticle concentration due to an increased hole concentration. The lattice thermal conductivity decreases with the addition of PbTe nanoparticles but the total thermal conductivity increases due to the increased electronic thermal conductivity. We conclude that the presence of nanosized PbTe in the bulk Bi{sub 2-x}Sb{sub x}Te{sub 3} matrix results in a collateral doping effect, which dominates transport properties. This study underscores the need for immiscible systems to achieve the decreased thermal transport properties possible from nanostructuring without compromising the electronic properties. - Graphical abstract: PbTe nanoparticles introduced into p-type Bi{sub 2}Te{sub 3} by incipient wetness results in decreased lattice thermal conductivity, but also acts as an electronic dopant, resulting in an overall decrease in thermoelectric performance. Highlights: Black-Right-Pointing-Pointer Composites of PbTe nanoparticles in Bi{sub 2-x}Sb{sub x}Te{sub 3} were formed by incipient wetness. Black-Right-Pointing-Pointer PbTe nanoparticles leads to decreased {kappa}{sub l}, consistent with phonon scattering. Black-Right-Pointing-Pointer PbTe nanoparticles lead to decreased S and {rho}, due to increased carriers. Black-Right-Pointing-Pointer Collateral doping from PbTe leads to decreased ZT with increasing concentration. Black-Right-Pointing-Pointer Immiscible systems are preferred for improved ZT.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Transient Response of Cadmium Telluride Modules to Light Exposure: Preprint

Commercial cadmium telluride (CdTe) photovoltaic (PV) modules from three different manufacturers were monitored for performance changes during indoor and outdoor light-exposure. Short-term transients in Voc were recorded on some modules, with characteristic times of ~1.1 hours. Outdoor performance data shows a similar drop in Voc after early morning light exposure. Preliminary analysis of FF changes show light-induced changes on multiple time scales, including a long time scale.

14 SOLAR ENERGY↗

Structure and dynamics of cadmium telluride studied by x-ray and inelastic neutron scattering

We present a combined study of density functional theory, x-ray diffraction, and inelastic neutron scattering examining the temperature dependent structure and lattice dynamics of commercially available cadmium telluride. A subtle change in the structure is evinced near 80 K, which manifests also in the measured phonon density of states. There is no change to the long-range ordered structure. The implications of the change in relation to structural defects are discussed.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Electronic characterization of defects in narrow gap semiconductors: Comparison of electronic energy levels and formation energies in mercury cadmium telluride, mercury zinc telluride, and mercury zinc selenide

The project has evolved to that of using Green's functions to predict properties of deep defects in narrow gap materials. Deep defects are now defined as originating from short range potentials and are often located near the middle of the energy gap. They are important because they affect the lifetime of charge carriers and hence the switching time of transistors. We are now moving into the arena of predicting formation energies of deep defects. This will also allow us to make predictions about the relative concentrations of the defects that could be expected at a given temperature. The narrow gap materials mercury cadmium telluride (MCT), mercury zinc telluride (MZT), and mercury zinc selenide (MZS) are of interest to NASA because they have commercial value for infrared detecting materials, and because there is a good possibility that they can be grown better in a microgravity environment. The uniform growth of these crystals on earth is difficult because of convection (caused by solute depletion just ahead of the growing interface, and also due to thermal gradients). In general it is very difficult to grow crystals with both radial and axial homogeneity.

Patterson, James D.↗

Electronic Characterization of Defects in Narrow Gap Semiconductors-Comparison of Electronic Energy Levels and Formation Energies in Mercury Cadmium Telluride, Mercury Zinc Telluride, and Mercury Zinc Selenide

We have used a Green's function technique to calculate the energy levels and formation energy of deep defects in the narrow gap semiconductors mercury cadmium telluride (MCT), mercury zinc telluride (MZT) and mercury zinc selenide (MZS). The formation energy is calculated from the difference between the total energy with an impurity cluster and the total energy for the perfect crystal. Substitutional (including antisite), interstitial (self and foreign), and vacancy deep defects are considered. Relaxation effects are calculated (with molecular dynamics). By use of a pseudopotential, we generalize the ideal vacancy model so as to be able to consider relaxation for vacancies. Different charge states are considered and the charged state energy shift (as computed by a modified Haldane-Anderson model) can be twice that due to relaxation. Different charged states for vacancies were not calculated to have much effect on the formation energy. For all cases we find deep defects in the energy gap only for cation site s-like orbitals or anion site p-like orbitals, and for the substitutional case only the latter are appreciably effected by relaxation. For most cases for MCT, MZT, MZS, we consider x (the concentration of Cd or Zn) in the range appropriate for a band gap of 0.1 eV. For defect energy levels, the absolute accuracy of our results is limited, but the precision is good, and hence chemical trends are accurately predicted. For the same reason, defect formation energies are more accurately predicted than energy level position. We attempt, in Appendix B, to calculate vacancy formation energies using relatively simple chemical bonding ideas due to Harrison. However, these results are only marginally accurate for estimating vacancy binding energies. Appendix C lists all written reports and publications produced for the grant. We include abstracts and a complete paper that summarizes our work which is not yet available.

Patterson, James D.↗

Cd-rich and Te-rich low-temperature photoluminescence in cadmium telluride

Low-temperature photoluminescence emission spectra were measured in cadmium telluride (CdTe) samples in which composition was varied to promote either Cd or Te-rich stoichiometry. The ability to monitor stoichiometry is important, since it has been shown to impact carrier recombination. Te-rich samples show transitions corresponding to acceptor-bound excitons (∼1.58 eV) and free-electron to acceptor transitions (∼1.547 eV). In addition to acceptor-bound excitons, Cd-rich samples show transitions assigned to donor-bound excitons (1.591 eV) and Te vacancies at 1.552 eV. Photoluminescence is a noninvasive way to monitor stoichiometric shifts induced by post-deposition anneals in polycrystalline CdTe thin films deposited by close-spaced sublimation.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Understanding the role of selenium in defect passivation for highly efficient selenium-alloyed cadmium telluride solar cells

Electricity produced by cadmium telluride (CdTe) photovoltaic modules is the lowest-cost electricity in the solar industry, and now undercuts fossil fuel-based sources in many regions of the world. This is due to recent efficiency gains brought about by alloying selenium into the CdTe absorber, which has taken cell efficiency from 19.5% to its current record of 22.1%. Although the addition of selenium is known to reduce the bandgap of the absorber material, and hence increase the cell short-circuit current, this effect alone does not explain the performance improvement. Here, by means of cathodoluminescence and secondary ion mass spectrometry, we show that selenium enables higher luminescence efficiency and longer diffusion lengths in the alloyed material, indicating that selenium passivates critical defects in the bulk of the absorber layer. Here, this passivation effect explains the record-breaking performance of selenium-alloyed CdTe devices, and provides a route for further efficiency improvement that can result in even lower costs for solar-generated electricity.

14 SOLAR ENERGY↗

Toward Nanostructured Thermoelectrics. Synthesis and Characterization of Lead Telluride Gels and Aerogels

The synthesis and characterization of lead telluride (PbTe) gels and aerogels with nanostructured features of potential benefit for enhanced thermoelectrics is reported. In this approach, discrete thiolate-capped PbTe nanoparticles were synthesized by a solution-based approach followed by oxidation-induced nanoparticle assembly with tetranitromethane or hydrogen peroxide to form wet gels. Drying of the wet gels by supercritical CO₂ extraction yielded aerogels, whereas xerogels were produced by ambient pressure bench top drying. The gels consist of an interconnected network of colloidal nanoparticles and pores with surface areas up to 74 m² g -1 . The thermal stability of the nanostructures relative to nanoparticles was probed with the help of in situ transmission electron microscopy (TEM), thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC). The aerogels were observed to sublime at a higher temperature and over a larger range (425–500 °C) relative to the precursor nanoparticles. TGA-DSC suggests that organic capping groups can be removed in the region 250–450 °C, and melting of PbTe nanoparticles occurs near the temperature for bulk materials (ca. 920 °C). The good thermal stability combined with the presence of nanoscale interfaces suggests PbTe gels may show promise in thermoelectric devices.

36 MATERIALS SCIENCE↗

Investigation of cadmium telluride grown by molecular-beam epitaxy using micro-Raman spectroscopy below and above the laser damage threshold

The effects of visible laser light on cadmium telluride (CdTe), grown by molecular beam epitaxy, are studied at low (48 μ W/ μ m 2 ) and high (480 μ W/ μ m 2 ) laser power densities using micro-Raman spectroscopy. The Raman spectrum of CdTe shows no notable change at low power density ~48 μ W/ μ m 2 for prolonged laser exposure. At higher power density ~480 μ W/ μ m 2 , the Raman spectrum is significantly changed and strong Te-related peaks appear in the spectrum, even for short laser exposure times suggesting that photo-induced Te enrichment happens at the CdTe surface at high laser power density. The temperature rise is estimated from observed shifts in the Te and CdTe optical phonon peaks and modeled using finite-element simulations. At laser power 480 μ W/ μ m 2 , the CdTe exhibits a rise of ~44 °C above room temperature while the observed change in Te temperature is significantly higher, ~179 °C. Furthermore, the approach illustrates steps needed to establish the laser damage threshold for CdTe.

36 MATERIALS SCIENCE↗

Off-stoichiometric silver antimony telluride: An experimental study of transport properties with intrinsic and extrinsic doping

AgSbTe{sub 2} is a thermoelectric semiconductor with an intrinsically low thermal conductivity and a valence band structure that is favorable to obtaining a high thermoelectric figure of merit zT. It also has a very small energy gap Eg ∼ 7.6 ± 3 meV. As this gap is less than the thermal excitation energy at room temperature, near-intrinsic AgSbTe{sub 2} is a two carrier system having both holes (concentration p) and electrons (n). Good thermoelectric performance requires heavy p-type doping (p > > n). This can be achieved with native defects or with extrinsic doping, e.g. with transition metal element. The use of defect doping is complicated by the fact that many of the ternary Ag-Sb-Te and pseudo-binary Sb{sub 2}Te{sub 3}-Ag{sub 2}Te phase diagrams are contradictory. This paper determines the compositional region most favorable to creating a single phase material. Through a combination of intrinsic and extrinsic doping, values of zT > 1 are achieved, though not on single-phased material. Additionally, we show that thermal conductivity is not affected by defects, further demonstrating that the low lattice thermal conductivity of I-V-VI{sub 2} materials is due to an intrinsic mechanism, insensitive to changes in defect structure.

36 MATERIALS SCIENCE↗