Effect of thrust per element on combustion stability characteristics of hydrogen oxygen rocket engines
Coaxial injector thrust effects on combustion stability of hydrogen-oxygen rocket engine
Hannum, N. P.↗
SEARCH · Search NASA
Results for “THRUST EFFECT”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Thrust reversing effects on horizontal tail effectiveness of twin-engine fighter aircraft
The Langley Research Center has conducted an experimental program to determine the interference effects of thrust reversing on horizontal tail effectiveness of a twin engine, general research fighter model at approach (Mach number 0.15) and in-flight (Mach number 0.60 and 0.90) speeds. Twin vertical tails were tested at three longitudinal locations. Two nonaxisymmetric nozzle reverser concepts were studied. The effects of thrust reversing on horizontal tail effectiveness were found to be very dependent upon vertical tail locations. At approach speeds thrust reverser operation usually resulted in large variations in horizontal tail effectiveness as either nozzle pressure ratio or model angle of attack was varied. Either increases or decreases in tail effectiveness ocurred due to reverse operation depending upon tail location. At in-flight conditions there were always decreases in tail effectiveness due to reverser operation regardless of vertical tail location.
Capone, F. J.↗
Interference effects of thrust reversing on horizontal tail effectiveness of twin-engine fighter aircraft at Mach numbers from 0.15 to 0.90
An investigation was conducted in the Langley 16 foot Transonic Tunnel to determine the interference effects of thrust reversing on horizontal tail effectiveness of a twin engine, general research fighter model at approach and in-flight speeds. Twin vertical tails at three longitudinal locations were tested at a cant angle of 0 deg. One configuration was also tested at a cant angle of 20 deg. Two nonaxisymmetric nozzle reverser concepts were studied. Test data were obtained at Mach numbers of 0.15, 0.60, and 0.90 and at angles of attack from -3 to 9 deg. Nozzle pressure ratios varied from jet off to 7.0, depending upon Mach number. At landing approach speed (Mach number 0.15), thrust reverser operation usually resulted in large variations (up to 70% increase) in horizontal tail effectiveness as nozzle pressure ratio was varied at zero angle of attack or as angle of attack was varied at constant nozzle pressure ratio. There was always a decrease in effectiveness at Mach numbers of 0.60 and 0.90 as a result of reverser operation.
Capone, F. J.↗
Thrust reversing effects on twin-engine aircraft having nonaxisymmetric nozzles
The effects of thrust reversing on stability, control and vertical tail loads of advanced fighter aircraft are reviewed. Several static test stand and wind tunnel investigations of nonaxisymmetric nozzles with integral thrust reversers are presented, and it is found that base drag on the aft face of reverser panels of blockers provides a significant contribution to in-flight thrust reverser performance. The location of tail surfaces relative to the thrust reverser has significant impact on control surface effectiveness, and depending on thrust reverser location, large vertical tail side force can result from the use of in-flight thrust reversers. It is concluded that highly effective nonaxisymmetric nozzle reversers can be designed to achieve a 50% static reverse thrust.
Capone, F. J.↗
Thrust-induced effects on low-speed aerodynamics of fighter aircraft
Results of NASA Langley has conducted wind-tunnel investigations of several fighter configurations conducted to determine the effects of both thrust vectoring and spanwise blowing are reviewed. A recent joint NASA/Grumman Aerospace Corporation/U.S. Air Force Wright Aeronautical Laboratory wind-tunnel investigation was conducted to examine the effects of spanwise blowing on the trailing-edge flap system. This application contrasts with the more familiar method of spanwise blowing near the wing leading edge. Another joint program among NASA/McDonnell Aircraft Company/U.S. Air Force Wright Aeronautical Laboratory investigated the effects of reverse thrust on the low-speed aerodynamics of an F-15 configuration. The F-15 model was fitted with a rotating van thrust reverser concept which could simulate both in-flight reversing for approach and landing or full reversing for ground roll reduction. The significant results of these two joint programs are reported.
Banks, D. W.↗
Effect of thrust and altitude in steep approaches on ground track noise
Thrust and altitude effects on ground track noise during steep approaches of four engine, medium range, turbojet transports
Zalovcik, J. A.↗
Vacuum chamber pressure effects on thrust measurements
Tests were conducted to investigate the effect of vacuum facility pressure on the performance of small thruster nozzles. Thrust measurements of two converging-diverging nozzles with an area ratio of 140 and an orifice plate flowing unheated nitrogen and hydrogen were taken over a wide range of vacuum facility pressures and nozzle throat Reynolds numbers. In the Reynolds number range of 2200 to 12,000 there was no discernable viscous effect on thrust below an ambient to total pressure ratio of 1000. In nearly all cases, flow separation occurred at a pressure ratio of about 1000. This was the upper limit for obtaining an accurate thrust measurement for a conical nozzle with an area ratio of 140.
Sovey, J. S.↗
Thrust-induced effects on subsonic longitudinal aerodynamic characteristics of a vectored-engine-over-wing configuration
An investigation was conducted in the Langley 4 by 7 Meter Tunnel of the thrust induced effects on the longitudinal aerodynamic characteristics of a vectored-engine-over-wing fighter aircraft. The investigation was conducted at Mach numbers from 0.14 to 0.17 over an angle-of-attack range from -2 deg to 26 deg. The major model variables were the spanwise blowing nozzle sweep angle and main nozzle vector angle along with trailing edge, flap deflections. The overall thrust coefficient (main and spanwise nozzles) was varied from 0 (jet off) to 2.0. The results indicate that the thrust-induced effects from the main nozzle alone were small and mainly due to boundary-layer control affecting a small area behind the nozzle. When the spanwise blowing nozzles were included, the induced effects were larger than the main nozzle alone and were due to both boundary layer control and induced circulation lift. No leading edge vortex effects were evident.
Quinto, P. F.↗
An analysis of thrust-induced effects on the longitudinal aerodynamics of STOL fighter configurations
An analysis of the thrust-induced longitudinal aerodynamic characteristics of three fighter-type configurations is presented. A brief discussion of the take-off and landing requirements for the next generation fighter aircraft leads to the conclusion that advances in lift coefficient and thrust reversing will be required to allow short-field operation. Typical power-on longitudinal aerodynamic data for the three fighter configurations, indicating different approaches to meeting the high-lift coefficient requirement, are discussed. Thrust reversing is not addressed in this paper. The power-on data are analyzed to determine what power effects are present, that is, direct thrust, boundary-layer control, vortex flows, or supercirculation. The results of the analysis indicate, for the configurations studied, that induced effects are small compared to direct thrust and that boundary-layer control, rather than leading-edge vortex flows or supercirculation, is the only significant thrust-induced effect.
Paulson, J. W., Jr.↗
Vacuum chamber pressure effects on thrust measurements of low Reynolds number nozzles
Tests were conducted to investigate the effect of vacuum facility pressure on the performance of small thruster nozzles. Thrust measurements of two converging-diverging nozzles with an area ratio of 140 and an orifice plate flowing unheated nitrogen and hydrogen were taken over a wide range of vacuum facility pressures and nozzle throat Reynolds numbers. In the Reynolds number range of 2200 to 12 000 there was no discernable viscous effect on thrust below an ambient to total pressure ratio of 1000. In nearly all cases, flow separation occurred at a pressure ratio of about 1000. This was the upper limit for obtaining an accurate thrust measurement for a conical nozzle with an area ratio of 140.
Sovey, J. S.↗
Vacuum chamber pressure effects on thrust measurements of low Reynolds number nozzles
Tests were conducted to investigate the effect of vacuum facility pressure on the performance of small thruster nozzles. Thrust measurements of two converging-diverging nozzles with an area ratio of 140 and an orifice plate flowing unheated nitrogen and hydrogen were taken over a wide range of vacuum facility pressures and nozzle throat Reynolds numbers. In the Reynolds number range of 2200 to 12,000 there was no discernable viscous effect on thrust below an ambient to total pressure ratio of 1000. In nearly all cases, flow separation occurred at a pressure ratio of about 1000. This was the upper limit for obtaining an accurate thrust measurement for a conical nozzle with an area ratio of 140.
Sovey, J. S.↗
The Effect on Thrust Minus Base Drag of Exchanging Base Area for Nozzle Expansion in Supersonic Nozzles at Transonic Mach Numbers
A wind-tunnel investigation to determine the effect on thrust minus base drag of exchanging base area for nozzle overexpansion on a cylindrical afterbody with a single supersonic nozzle has been conducted a t Mach numbers from 0.9 t o 1.4. The throat-to-base diameter ratio has been varied from 0.320 to 0.550; the jet-to-base diameter ratio has been varied from 0.320 to 1, resulting in a jet Mach number variation of 1.0 to 3.897. The jet total-pressure ratio ranged from 2 to approximately 22. The results indicated that a proper balance between nozzle over-expansion and base area exists, which will produce the maximum afterbody net-thrust factor over a given operating range. For a given Mach number and throat-to-base diameter ratio, the optimum values of jet-to-base diameter ratio corresponding to the peak values of the net-thrust factor are, in general, larger than the values at the jet design pressure ratio and tend to increase with increasing j e t total-pressure ratio in a manner similar to the design values. Also, for given values of throat-to-base diameter ratio and jet total-pressure ratio, the optimum value of jet-to-base diameter ratio changed as the free-stream Mach number was varied from transonic to low supersonic speeds. The magnitude of the changes varied with jet total-pressure ratio and throat-to-base diameter ratio.
Slocumb, Travis H.↗
Thrust law effects on the longitudinal stability of hypersonic cruise
In the present analytical treatment of the cruising flight stability of an aerospacecraft in nearly circular orbit, on the basis of a thrust law which arbitrarily depends on altitude, speed, and angle of attack, attention is given to thrust law effects on the translational (height and phugoid) and rotational (angle of attack) modes. The partial derivatives of the propulsive forces in conjunction with the aerodynamic forces, with respect to speed and altitude, are noted to exert a major influence on the stability of translational dynamics; the partial derivative of the component of propulsive and aerodynamic forces which is perpendicular to vehicle velocity (with respect to the angle of attack) is a primary determinant of the damping of angle-of-attack oscillations, while the partial derivative of the sum about the center of mass of aerodynamic and propulsive pitching moments, with respect to the angle of attack, determines the corresponding period.
Markopoulos, Nikos↗
Thrust-induced effects on low-speed aerodynamics of fighter aircraft
The design and technology requirements for STOL fighter aircraft as defined in NASA studies are reviewed. The research has concentrated on advanced high-lift systems using mechanical flaps, methods of obtaining longitudinal trim during the use of thrust vectoring, and thrust reversal to shorten ground roll distances. Several early configurations are described, and investigations of the effect of thrust reversal on the low-speed aerodynamics of the F-15 are detailed. Although the NASA design was a wing-canard configuration, similarities in a Grumman baseline STOL aircraft allowed incorporation of the Grumman nacelle, primary nozzles, spanwise blowing nozzles, and trailing-edge flap systems.
Banks, D. W.↗
Effect of thrust vectoring and wing maneuver devices on transonic aeropropulsive characteristics of a supersonic fighter
The aeropropulsive characteristics of an advanced fighter designed for supersonic cruise were determined in the Langley 16-Foot Transonic Tunnel. The objectives of this investigation were to evaluate the interactive effects of thrust vectoring and wing maneuver devices on lift and drag and to determine trim characteristics. The wing maneuver devices consisted of a drooped leading edge and a trailing-edge flap. Thrust vectoring was accomplished with two dimensional (nonaxisymmetric) convergent-divergent nozzles located below the wing in two single-engine podded nacelles. A canard was utilized for trim. Thrust vector angles of 0 deg, 15 deg, and 30 deg were tested in combination with a drooped wing leading edge and with wing trailing-edge flap deflections up to 30 deg. This investigation was conducted at Mach numbers from 0.60 to 1.20, at angles of attack from 0 deg to 20 deg, and at nozzle pressure ratios from about 1 (jet off) to 10. Reynolds number based on mean aerodynamic chord varied from 9.24 x 10 to the 6th to 10.56 x 10 to the 6th.
Capone, F. J.↗
Exploratory Study of Ground Proximity Effects on Thrust of Annular and Circular Nozzles
The proximity of the ground to an annular nozzle can result in thrust augmentation of up to 50 percent. The magnitude of thrust augmentation was a function of ground-to-nozzle distance, nozzle configuration, and nozzle pressure ratio. With a conventional circular nozzle a thrust reduction of 15 to 40 percent due to ground effect was obtained. The degree of thrust reduction was primarily a function of nozzle pressure ratio and ground-to-nozzle distance.
BOOSTER SYSTEMS AUXILIARY - GAS TURBINES↗
Port geometry effects on thrust reverser static performance
An investigation has been conducted to provide some insight into the effect of several geometric parameters on the internal performance of thrust reverser ports for nonaxisymmetric nozzles using a single port test apparatus. This test apparatus simulates thrust reversal (conceptually) which would occur in the convergent section of the forward flight nozzle or in the constant area duct just upstream. The port opening had an aspect ratio of 6.1 (throat width/throat height) and had constant passage area from the geometric throat to the exit. The geometric parameters investigated were port angle, port corner radius, port location, and flow blocker angle. The apparatus had a single port so that thrust (vector) angle could be obtained from force balance measurements. The tests were conducted in the Static Test Stand of the Langley 16-Foot Transonic Tunnel at nozzle pressure ratios from 1.5 to 8.0 using high pressure air for propulsion simulation. Port angles (measured forward from a horizontal reference line) investigated were 75, 90, 120 and 135 deg. Sharp and rounded port corners were investigated for each port angle. Discharge coefficient, thrust ratio, and passage static pressures were measured.
Re, R. J.↗
Effects of thrust reversing in ground proximity
The changes in stability and control characteristics encountered by a thrust reversing aircraft during its final approach, landing, and ground roll are described. These changes include a strong pitch-up accompanied by the loss of horizontal tail and aileron control effectiveness. The magnitude of reverser induced changes in ground effect are much larger than corresponding changes in free air. Some unexpected unsteady motions exhibited in wind tunnel by an aircraft model with reversers operating in ground proximity are also described. The cause of this oscillatory behavior was determined to be an unsteady interaction between the wall jets formed by impingement of reverser jets on the ground and the on-coming free stream. Time histories of rolling moments measured by the wind tunnel balance or support system were removed and frequencies were scaled by Strouhal number to full scale. Corrected time series were used to simulate the motion of a fighter aircraft with thrust reversers in ground effect. The simulation predicted large roll angles and nose down attitude at touchdown. Some phenomena of jet attachment to solid surfaces are discussed and areas for future research are recommended.
Joshi, P. B.↗