Search NASA⌕ Search

SEARCH · Search NASA

Results for “Topographic effects”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1980

The contribution of the diffuse light component to the topographic effect on remotely sensed data

The topographic effect is measured by the difference between the global radiance from inclined surfaces as a function of their orientation relative to the sensor position and light source. The short wave radiant energy incident on a surface is composed of direct sunlight, scattered skylight, and light reflected from surrounding terrain. The latter two components are commonly known as the diffuse component. The contribution of the diffuse light component to the topographic effect was examined and the significance of this diffuse component with respect to two direct radiance models was assessed. Diffuse and global spectral radiances were measured for a series of slopes and aspects of a uniform and surface in the red and photographic infrared parts of the spectrum, using a nadir pointing two channel handheld radiometer. The diffuse light was found to produce a topographic effect which varied from the topographic effect for direct light. The topographic effect caused by diffuse light was found to increase slightly with solar elevation and wavelength for the channels examined. The correlations between data derived from two simple direct radiance simulation models and the field data were not significantly affected when the diffuse component was removed from the radiances. Radiances from a 60 percent reflective surface, assuming no atmospheric path radiance, the diffuse light topographic effect contributed a maximum range of 3 pixel values in simulated LANDSAT data from all aspects with slopes up to 30 degrees.

Justice, C.↗
NASA NTRS1981

An examination of spectral band ratioing to reduce the topographic effect on remotely sensed data

Spectral-band ratioing of radiance data is examined as a means of reducing the topographic effect in multispectral data. A ground-based nadir-pointing two-channel radiometer filtered for the red and photographic IR portions of the spectrum was used to measure the topographic effect associated with a uniform surface inclined from horizontal to 60 deg at 16 compass points and for several solar elevations. It is found that ratioing reduced the topographic effect in the field-measured radiance data by an average of 83%, that the remaining topographic effect could be further reduced by subtracting the scattered-light component of the global irradiance before ratioing, and that ratioing was not effective in reducing the topographic effect on shaded surfaces illuminated solely by scattered light. It is concluded that additional variations in ratios can be expected for Landsat data owing to sensor calibration and quantization.

Holben, B.↗
NASA NTRS1980

Application of digital terrain data to quantify and reduce the topographic effect on LANDSAT data

Integration of LANDSAT multispectral scanner (MSS) data with 30 m U.S. Geological Survey (USGS) digital terrain data was undertaken to quantify and reduce the topographic effect on imagery of a forested mountain ridge test site in central Pennsylvania. High Sun angle imagery revealed variation of as much as 21 pixel values in data for slopes of different angles and aspects with uniform surface cover. Large topographic effects were apparent in MSS 4 and 5 was due to a combination of high absorption by the forest cover and the MSS quantization. Four methods for reducing the topographic effect were compared. Band ratioing of MSS 6/5 and MSS 7/5 did not eliminate the topographic effect because of the lack of variation in MSS 4 and 5 radiances. The three radiance models examined to reduce the topographic effect required integration of the digital terrain data. Two Lambertian models increased the variation in the LANDSAT radiances. The nonLambertian model considerably reduced (86 per cent) the topographic effect in the LANDSAT data. The study demonstrates that high quality digital terrain data, as provided by the USGS digital elevation model data, can be used to enhance the utility of multispectral satellite data.

Justice, C. O.↗
NASA NTRS1980

The topographic effect on spectral response from nadir-pointing sensors

It is difficult to interpret multispectral Landsat earth resources data in areas of rugged and mountainous terrain because of the topographic effect on the sensor response. The objectives of this study were to examine and quantify the topographic effect on the sensor response from a uniform sand surface, to assess a simple theoretical incidence model for modeling the radiance from the surface, and to simulate Landsat sensor response due to the topographic effect. A field experiment was designed to collect data from a large range of slope angles and aspects at a range of solar elevations, using a hand-held radiometer. Analysis of these data showed that the magnitude of the topographic effect varied as a function of the solar elevation, the azimuthal orientation of the slope, and the slope inclination. The field measured variations in spectral response were found to have generally strong correlations with the theoretical model, and it was shown that the applicability of the Lambertian assumption varied within and between data sets. It is concluded that if slope angle, aspect, and solar zenith angle and azimuth are known, a technique incorporating a model to reduce the topographic effect prior to multispectral classification may be developed.

Holben, B. N.↗
NASA NTRS1981

Application of digital terrain data to quantify and reduce the topographic effect on Landsat data

Landsat multispectral scanner (MSS) data are integrated with 30 m US Geological Survey digital terrain data to quantify and reduce topographic effects on imagery of a forested mountain ridge in central Pennsylvania. Spectral band ratioing slightly decreased variation of Landsat data for 50% of the transects and could not eliminate direct-light topographic effects. A Lambertian model increased topographic effect, and a modified Lambertian model decreased variation produced by the original model, but gave higher variances than found in the raw Landsat data. A non-Lambertian model, however, decreased variation by 86%, reducing topographic effects. The study demonstrated that high quality digital terrain data can be used to develop and test improved radiative transfer models, and enhance the utility of MSS data.

Justice, C. O.↗
NASA NTRS1979

Evaluation and modeling of the topographic effect on the spectral response from NADIR pointing sensors

A field experiment, using a hand-held radiometer, was designed and conducted to assess a simple theoretical incidence model for simulating the topographic effect of a uniform sand surface. Seven data sets were taken to compare effects of solar elevation and azimuth encountered at different times of year. Analysis of these data showed considerable variation in radiance values for different slope angles and aspects and that these values varied considerably with changes in solar elevation and azimuth. The field measured variations in spectral response were found to have generally strong correlations with the theoretical model. The reason for the occurrence of lower correlations are given and methods for improving the model are suggested. A model to simulate LANDSAT sensor response was applied to two subsets of the field data to establish the magnitude of the topographic effect on satellite data.

Holben, B. N.↗
NASA NTRS1986

Topographic effect on tilt, strain, and displacement measurements

An approximate analytical method is used to give simple expressions for the effect of arbitrarily shaped topography on vertical, horizontal and surface tilt measurements. Corrections to tilt fields are found to be directly proportional to the local slope of the topography. Comparison is made between expressions for tilt and those for strain and displacement. Although the topographic effects on secular tilt, strain, and vertical displacement are not yet measurable, the topographic effect on precision tidal tilt and strain measurements can be significant.

Meertens, Charles M.↗
NASA NTRS1979

Examination of Lambertian and Non-lambertian Models for Simulating the Topographic Effect on Remotely Sensed Data

As a preliminary step to developing a technique to eliminate the topographic effect from remotely sensed data, two radiance simulation models were examined and compared. A Lambertian and a non-Lambertian model were tested using hand-held radiometer measurements from a uniform surface at different slope angle aspect orientations. Linear correlation coefficients for the non-Lambertian model and the field spectra were calculated to be greater than 0.92 for all cases; whereas correlation coefficients for the Lambertian model ranged from 0.06 to 0.98. An assumption regarding an empirical constant within the non-Lambertian equation was found to be invalid and the model was improved by using subsets of the data to derive the empirical value.

Justice, C.↗
NASA NTRS1983

Techniques for the correction of topographical effects in scanning Auger electron microscopy

A number of ratioing methods for correcting Auger images and linescans for topographical contrast are tested using anisotropically etched silicon substrates covered with Au or Ag. Thirteen well-defined angles of incidence are present on each polyhedron produced on the Si by this etching. If N1 electrons are counted at the energy of an Auger peak and N2 are counted in the background above the peak, then N1, N1 - N2, (N1 - N2)/(N1 + N2) are measured and compared as methods of eliminating topographical contrast. The latter method gives the best compensation but can be further improved by using a measurement of the sample absorption current. Various other improvements are discussed.

Prutton, M.↗
NASA NTRS1995

Dynamics of the Antarctic Circumpolar Current. Evidence for Topographic Effects from Altimeter Data and Numerical Model Output

Geosat altimeter data and numerical model output are used to examine the circulation and dynamics of the Antarctic Circumpolar Current (ACC). The mean sea surface height across the ACC has been reconstructed from height variability measured by the altimeter, without assuming prior knowledge of the geoid. The results indicate locations for the Subantarctic and Polar Fronts which are consistent with in situ observations and indicate that the fronts are substantially steered by bathymetry. Detailed examination of spatial and temporal variability indicates a spatial decorrelation scale of 85 km and a temporal e-folding scale of 34 days. Empirical Orthogonal Function analysis suggests that the scales of motion are relatively short, occuring on 1000 km length-scales rather than basin or global scales. The momentum balance of the ACC has been investigated using output from the high resolution primitive equation model in combination with altimeter data. In the Semtner-Chervin quarter-degree general circulation model topographic form stress is the dominant process balancing the surface wind forcing. In stream coordinates, the dominant effect transporting momentum across the ACC is bibarmonic friction. Potential vorticity is considered on Montgomery streamlines in the model output and along surface streamlines in model and altimeter data. (AN)

Gille, Sarah T.↗
NASA NTRS1993

Modeling of topographic effects on Antarctic sea ice using multivariate adaptive regression splines

The role of seafloor topography in the spatial variations of the southern ocean sea ice cover as observed (every other day) by the Nimbus 7 scanning multichannel microwave radiometer satellite in the years 1980, 1983, and 1984 is studied. Bottom bathymetry can affect sea ice surface characteristics because of the basically barotropic circulation of the ocean south of the Antarctic Circumpolar current. The main statistical tool used to quantify this effect is a local nonparametric regression model of sea ice concentration as a function of the depth and its first two derivatives in both meridional and zonal directions. First, we model the relationship of bathymetry to sea ice concentration in two sudy areas, one over the Maud Rise and the other over the Ross Sea shelf region. The multiple correlation coefficient is found to average 44% in the Maud Rise study area and 62% in the Ross Sea study area over the years 1980, 1983, and 1984. Second, a strategy of dividing the entire Antarctic region into an overlapping mosaic of small areas, or windows is considered. Keeping the windows small reduces the correlation of bathymetry with other factors such as wind, sea temperature, and distance to the continent. We find that although the form of the model varies from window to window due to the changing role of other relevant environmental variables, we are left with a spatially consistent ordering of the relative importance of the topographic predictors. For a set of three representative days in the Austral winter of 1980, the analysis shows that an average of 54% of the spatial variation in sea ice concentration over the entire ice cover can be attributed to topographic variables. The results thus support the hypothesis that there is a sea ice to bottom bathymetry link. However this should not undermine the considerable influence of wind, current, and temperature which affect the ice distribution directly and are partly responsible for the observed bathymetric effects.

De Veaux, Richard D.↗
NASA NTRS1974

Surface topographical effects on the structural growth of thick sputtered metal and alloy coatings

Thick sputtered S-Monel, silver, and 304 stainless steel coatings were deposited on mica and metal substrates with various surface finishes to investigate the structural growth of the coating by scanning electron microscopy. The geometry and the surface structure of the nodules are characterized. Compositional changes within the coating were analyzed by X-ray dispersion microscopy. Defects in the surface finish (i.e., scratches, inclusions, etc.) act as preferential nucleation sites and form isolated and complex nodules and various surface overgrowths in the coating. The nodule boundaries are very vulnerable to chemical etching and these nodules do not disappear after full annealing. Further, they have undesirable effects on mechanical properties; cracks are initiated at the nodules when the coating is stressed by mechanical forces. These effects are illustrated by micrographs. Nodular growth within a coating can be minimized or eliminated by reducing the surface roughness.

Spalvins, T.↗
NASA NTRS1974

Surface topographical effects on the structural growth of thick sputtered metal and alloy coatings

Thick sputtered S-Monel, silver, and 304 stainless steel coatings were deposited on mica and metal substrates with various surface finishes to investigate the structural growth of the coating by scanning electron microscopy. The geometry and the surface structure of the nodules are characterized. Compositional changes within the coating were analyzed by X-ray dispersion miscroscopy. Defects in the surface finish act as preferential nucleation sites and form isolated and complex nodules and various surface overgrowths in the coating. The nodule boundaries are very vulnerable to chemical etching, and these nodules do not disappear after full annealing. Further, they have undesirable effects on mechanical properties; cracks are initiated at the nodules when the coating is stressed by mechanical forces.

Spalvins, T.↗
NASA NTRS2000

Topographic Effects on Geologic Mass Movements

This report describes research directed toward understanding the response of volcanic lahars and lava flows to changes in the topography along the path of the flow. We have used a variety of steady-state and time-dependent models of lahars and lava flows to calculate the changes in flow dynamics due to variable topography. These models are based on first-order partial differential equations for the local conservation of volume. A global volume conservation requirement is also imposed to determine the extent of the flow as a function of time and the advance rate. Simulated DEMs have been used in this report.

Baloga, Stephen M.↗
NASA NTRS1992

Radar interferometry studies of the earth's topography

Digital elevation models (DEMs) which have been acquired using the TOPSAR interferometric radar sensor are directly applicable to geological and geophysical studies. Attention is presently given to three illustrative examples of the use of DEMs: the correction of remote-sensing observations for local slope and topographic effects, topographic expressions of erosion and uplift in alluvial fans, and volcanology. The greatest advantages of TOPSAR over conventional photogrammetry include rapidity of data collection, high spatial and vertical resolution, and the ability to obtain contiguous data independent of cloud cover.

Evans, Diane L.↗