Search NASASearch

SEARCH · Search NASA

Results for “VSAT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records

Development and Performance of the ACTS High Speed VSAT

The Advanced Communication Technology Satellite (ACTS), developed by the U.S. National Aeronautics and Space Administration (NASA) has demonstrated the breakthrough technologies of Ka-band, spot beam antennas, and on-board processing. These technologies have enabled the development of very small aperture terminals (VSAT) and ultra-small aperture terminals (USAT) which have capabilities greater than were previously possible with conventional satellite technologies. However, the ACTS baseband processor (BBP) is designed using a time division multiple access (TDMA) scheme, which requires each earth station using the BBP to transmit data at a burst rate which is much higher than the user throughput data rate. This tends to mitigate the advantage of the new technologies by requiring a larger earth station antenna and/or a higher-powered uplink amplifier than would be necessary for a continuous transmission at the user data rate. Conversely, the user data rate is much less than the rate that can be supported by the antenna size and amplifier. For example, the ACTS TI VSAT operates at a burst rate of 27.5 Mbps, but the maximum user data rate is 1.792 Mbps. The throughput efficiency is slightly more than 6.5%. For an operational network, this level of overhead will greatly increase the cost of the user earth stations, and that increased cost must be repeated thousands of times, which may ultimately reduce the market for such a system. The ACTS High Speed VSAT (HS VSAT) is an effort to experimentally demonstrate the maximum user throughput data rate which can be achieved using the technologies developed and implemented on ACTS. Specifically, this was done by operating the system uplinks as frequency division multiple access (FDMA), essentially assigning all available TDMA time slots to a single user on each of two uplink frequencies. Preliminary results show that using a 1.2-m antenna in this mode, the HS VSAT can achieve between 22 and 24 Mbps out of the 27.5 Mbps burst rate, for a throughput efficiency of 80-88%. This paper describes the modifications made to the TI VSAT to enable it to operate at high speed, including hardware considerations, interface modifications, and software modifications. In addition, it describes the results of NASA HS VSAT experiments, continuing work on an improved user interface, and plans for future experiments.

Quintana, J.

ACTS High-Speed VSAT Demonstrated

The Advanced Communication Technology Satellite (ACTS) developed by NASA has demonstrated the breakthrough technologies of Ka-band transmission, spot-beam antennas, and onboard processing. These technologies have enabled the development of very small and ultrasmall aperture terminals (VSAT s and USAT's), which have capabilities greater than have been possible with conventional satellite technologies. The ACTS High Speed VSAT (HS VSAT) is an effort at the NASA Glenn Research Center at Lewis Field to experimentally demonstrate the maximum user throughput data rate that can be achieved using the technologies developed and implemented on ACTS. This was done by operating the system uplinks as frequency division multiple access (FDMA), essentially assigning all available time division multiple access (TDMA) time slots to a single user on each of two uplink frequencies. Preliminary results show that, using a 1.2-m antenna in this mode, the High Speed VSAT can achieve between 22 and 24 Mbps of the 27.5 Mbps burst rate, for a throughput efficiency of 80 to 88 percent.

Tran, Quang K.

VSAT networks - An overview

This paper examines the technology and constraints of very small aperture terminals (VSAT) networks, a special type of wide-area thin-route satellite network that represents a recent innovation in the field of satellite communications. VSAT network architectures suitable for both data and voice communications are studied in this paper. Several issues concerning the frequency of operations, that is, C-band versus Ku-band are examined, and trade-offs between nonspread spectrum and spread spectrum techniques, as well as modulation and multiple access schemes, are considered in detail. Link design examples are given to illustrate the performance of various types of VSAT networks.

Maggenti, Mark

A performance analysis of DS-CDMA and SCPC VSAT networks

Spread-spectrum and single-channel-per-carrier (SCPC) transmission techniques work well in very small aperture terminal (VSAT) networks for multiple-access purposes while allowing the earth station antennas to remain small. Direct-sequence code-division multiple-access (DS-CDMA) is the simplest spread-spectrum technique to use in a VSAT network since a frequency synthesizer is not required for each terminal. An examination is made of the DS-CDMA and SCPC Ku-band VSAT satellite systems for low-density (64-kb/s or less) communications. A method for improving the standardf link analysis of DS-CDMA satellite-switched networks by including certain losses is developed. The performance of 50-channel full mesh and star network architectures is analyzed. The selection of operating conditions producing optimum performance is demonstrated.

Hayes, David P.

Future benefits and applications of intelligent on-board processing to VSAT services

The trends and roles of VSAT services in the year 2010 time frame are examined based on an overall network and service model for that period. An estimate of the VSAT traffic is then made and the service and general network requirements are identified. In order to accommodate these traffic needs, four satellite VSAT architectures based on the use of fixed or scanning multibeam antennas in conjunction with IF switching or onboard regeneration and baseband processing are suggested. The performance of each of these architectures is assessed and the key enabling technologies are identified.

Price, Kent M.

Technology requirements for mesh VSAT applications

This paper first examines the trends and the roles of VSAT services in the year 2010 time frame based on an overall network and service model for that period. An estimate of the VSAT traffic is then made and the service and general network requirements are identified. In order to accommodate these traffic needs, four satellite VSAT architectures based on the use of fixed or scanning multibeam antennas in conjunction with IF switching or onboard regeneration and baseband processing are suggested. The performance of each of these architectures is assessed and the key enabling technologies are identified.

Kwan, R. K.

NASA Lewis Meshed VSAT Workshop meeting summary

NASA Lewis Research Center's Space Electronics Division (SED) hosted a workshop to address specific topics related to future meshed very small-aperture terminal (VSAT) satellite communications networks. The ideas generated by this workshop will help to identify potential markets and focus technology development within the commercial satellite communications industry and NASA. The workshop resulted in recommendations concerning these principal points of interest: the window of opportunity for a meshed VSAT system; system availability; ground terminal antenna sizes; recommended multifrequency for time division multiple access (TDMA) uplink; a packet switch design concept for narrowband; and fault tolerance design concepts. This report presents a summary of group presentations and discussion associated with the technological, economic, and operational issues of meshed VSAT architectures that utilize processing satellites.

Ivancic, William

Advanced satellite concepts for future generation VSAT networks

Advanced communication networks that use very-small-aperture terminals (VSATs) are considered. The techniques and technologies suitable for powerful satellites and system architectures for future VSAT networks are discussed. These include high effective isotropic radiated power, multiple-beam satellite antennas, and various access techniques. Examples of systems planned by the government and private industry are described.

Naderi, F. Michael

ACTS T1-VSAT - The intelligent earth station

The functional design of the software for NASA's Advanced Communication Technology Satellite (ACTS) T1-VSAT (Very Small Aperture Terminal) is described. The design provides a flexible interface to allow customized control of a satellite network and to provide external processes with access to network capabilities without requiring modification to the network hardware or software. Some of the envisioned features are: automatic number location; dynamic reconfiguration of the number plan tables; security features of call priority, call preemption, and remote verification; automatic reconfiguration of least cost routing tables; circuit availability verification prior to call setup; audio and video conferencing; on demand broadband dial-up service; on demand dial-up broadband broadcast service; and ISDN. A brief review is also given of the ACTS satellite and network, the network management, and the ACTS T1-VSAT earth station.

Manning, John R.

A Single Chip VLSI Implementation of a QPSK/SQPSK Demodulator for a VSAT Receiver Station

This thesis presents a VLSI implementation of a QPSK/SQPSK demodulator. It is designed to be employed in a VSAT earth station that utilizes the FDMA/TDM link. A single chip architecture is used to enable this chip to be easily employed in the VSAT system. This demodulator contains lowpass filters, integrate and dump units, unique word detectors, a timing recovery unit, a phase recovery unit and a down conversion unit. The design stages start with a functional representation of the system by using the C programming language. Then it progresses into a register based representation using the VHDL language. The layout components are designed based on these VHDL models and simulated. Component generators are developed for the adder, multiplier, read-only memory and serial access memory in order to shorten the design time. These sub-components are then block routed to form the main components of the system. The main components are block routed to form the final demodulator.

Kwatra, S. C.

Design Consideration on the ACTS T1-VSAT

The Advanced Communications Technology Satellite (ACTS) was developed by NASA as an experimental platform to demonstrate to industry the high risk technologies need for the next generation of communication satellites. The ACTS contains many state-of-the-art technologies including time division multiple accessing, adaptive error correction coding, multiple electronically steerable hopping beam antennas, spectrally efficient SMSK modulation, demand assignment multiple access protocol and on-board baseband circuit switching. An integral part of this testbed is the ACTS T1-very small aperture terminal (VSAT). The requirements imposed on the T1-VSAT demanded numerous design tradeoffs; balancing risk, cost, and implementation. Some of these considerations include: the method used for determining link quality, the development of a low cost and reliable Ka-band high power amplifier, the integration and testing environment for use in development and production and the low cost signal processing solution to high rate burst data. This paper discusses the tradeoffs considered in the selected implementation and the results obtained over the past two years of operation. Recommendations for improvements are also included.

Lilley, Richard D.

Advanced Communication Technology Satellite (ACTS) Very Small Aperture Terminal (VSAT) Network Control Performance

This paper discusses the performance of the network control function for the Advanced Communications Technology Satellite (ACTS) very small aperture terminal (VSAT) full mesh network. This includes control of all operational activities such as acquisition, synchronization, timing and rain fade compensation as well as control of all communications activities such as on-demand integrated services (voice, video, and date) connects and disconnects Operations control is provided by an in-band orderwire carried in the baseboard processor (BBP) control burst, the orderwire burst, the reference burst, and the uplink traffic burst. Communication services are provided by demand assigned multiple access (DAMA) protocols. The ACTS implementation of DAMA protocols ensures both on-demand and integrated voice, video and data services. Communications services control is also provided by the in-band orderwire but uses only the reference burst and the uplink traffic burst. The performance of the ACTS network control functions have been successfully tested during on-orbit checkout and in various VSAT networks in day to day operations. This paper discusses the network operations and services control performance.

Coney, T. A.

Advanced satellite system architecture for VSATs with ISDN compatibility

This paper describes a future communications satellite system architecture concept which allows the use of Very Small Aperature Terminals (VSATs) of 1.2 m to 1.8 m diameter and which provides access according to the international Integrated Services Digital Network (ISDN) standard. This satellite system design could make dial-up integrated voice and data service available nationwide and perhaps worldwide. The paper gives a conceptual system design based on the year 1995 technology for the communications satellite, the earth terminal, and the ground-based master control station and interface to the terrestrial ISDN network.

Jorasch, Ronald E.

A Code Phase Division Multiple Access (CPDMA) technique for VSAT satellite communications

A reference concept and implementation relevant to the application of Code Phase Division Multiple Access (CPDMA) to a high capacity satellite communication system providing 16 Kbps single hop channels between Very Small Aperture Terminals (VSAT's) is described. The description includes a potential implementation of an onboard CPDMA bulk demodulator/converter utilizing programmable charge coupled device (CCD) technology projected to be available in the early 1990's. A high level description of the system architecture and operations, identification of key functional and performance requirements of the system elements, and analysis results of end-to-end system performance relative to key figures of merit such as spectral efficiency are also provided.

Bruno, R.

Defocussing characteristics of the ACTS, T1-VSAT Earth terminal antennas

This report describes a study, the purpose of which was to determine the characteristics of two reflector antennas, as the reflector feed is moved away from the focus. The antennas are a 1.2 meter and a 2.44 meter reflector that will be used in the T1-VSAT earth terminals for the Advanced Communications Technology Satellite (ACTS). These terminals have been constructed in such a way that is inconvenient to use attenuators to control the gain of the signal that is directed toward the satellite. Feed defocusing was proposed as a simple, convenient way to achieve the required gain control. The study was performed in two parts. In order to determine the feasibility of the technique, a theoretical analysis was performed to obtain the gain, beamwidth and far-field pattern of the antennas, as a function of feed displacement. An experimental investigation followed in which patterns of the 1.2 meter antenna were obtained through measurement in the NASA Lewis Research Center, Near-Field Antenna Test Facility. Results of the theoretical and experimental investigation are presented for both uplink (30 GHz) and downlink (20 GHz) frequencies.

Lambert, Kevin M.

T1 VSAT Fade Compensation Statistical Results

New satellite communication systems are steadily seeking to use higher frequency bands to accommodate the requirements for additional capacity. At these higher frequencies, propagation impairments that did not significantly affect the signal at lower frequencies begin to have considerable impact. In Ka-band. the next logical commercial frequency band to be used for satellite communication, attenuation of the signal due to rain is a primary concern. An experimental satellite built by NASA, the Advanced Communication Technology Satellite (ACTS). launched in September 1993, is the first U.S. communication satellite operating in the Ka-band. In addition to higher carrier frequencies, a number of other new technologies, including on-board baseband processing. multiple beam antennas, and rain fade detection and compensation techniques, were designed into the ACTS. Verification experiments have been conducted since the launch to characterize the new technologies. The focus of this paper is to characterize the method used by the ACTS TI Very Small Aperture Terminal (TI VSAT) ground stations in detecting the presence of fade in the communication signal and to adaptively compensate for it by the addition of burst rate reduction and forward error correction. Measured data obtained from the ACTS program was used to validate the compensation technique. A software process was developed and demonstrated to statistically characterize the increased availability achieved by the compensation techniques in terms of the bit error rate time enhancement factor. Several improvements to the ACTS technique are discussed and possible implementations for future Ka band system are offered.

Johnson, Sandra K.