Search NASA⌕ Search

SEARCH · Search NASA

Results for “dielectric response”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records

The study of electrical conduction mechanisms

The dielectric response of lunar fines 74241,2 is presented in the audio-frequency range and under lunarlike conditions. Results suggest that volatiles are released during storage and transport of the lunar sample. Apparently, subsequent absorption of volatiles on the sample surface alter its dielectric response. The assumed volatile influence disappear after evacuation. A comparison of the dielectric properties of lunar and terrestrial materials as a function of density, temperature, and frequency indicates that if the lunar simulator analyzed were completely devoid of atmospheric moisture it would present dielectric losses smaller than those of the lunar sample. It is concluded that density prevails over temperature as the controlling factor of dielectric permittivity in the lunar regolith and that dielectric losses vary slowly with depth.

Morrison, H. F.↗

Lunar powder simulator under lunarlike conditions - Dielectric properties

A powered basalt simulating lunar regolith material was subjected to temperature variations similar to those found in the lunar surface during a lunation. To obtain the dielectric response under simulated lunar conditions, all measurements were made in appropriate vacuums which, in addition, allowed for an evaluation of moisture effects in the powdered sample. It is found that during approximately seven tenths of a lunation the dielectric response of a 5- to 10-cm surface layer should be fairly constant. During the remaining three tenths, it should undergo rapid changes. Changes in the dielectric properties of the surface layer should be controlled by temperature. In the subjacent layers such changes are thought to be controlled by the increasing density of the regolith.

Alvarez, R.↗

Responses of Dielectrics to Space Radiation

Nature, extent, and possible prevention of radiation damage discussed. Report summarizes likely effects of high-energy radiation in outer space on variety of commercially-available dielectric materials used in spacecraft. Effects reported on basis of recent Galileo tests, unpublished tests involving proton or electron irradiation, and published information. In general, organic materials with carbon or inorganic fillers most resistant to radiation.

Bouquet, F. L.↗

Physical and Electrical Characterization of Aluminum Polymer Capacitors

Polymer aluminum capacitors from several manufacturers with various combinations of capacitance, rated voltage, and ESR values were physically examined and electrically characterized. The physical construction analysis of the capacitors revealed three different capacitor structures, i.e., traditional wound, stacked, and laminated. Electrical characterization results of polymer aluminum capacitors are reported for frequency-domain dielectric response at various temperatures, surge breakdown voltage, and other dielectric properties. The structure-property relations in polymer aluminum capacitors are discussed.

Liu, David↗

Physical and Electrical Characterization of Polymer Aluminum Capacitors

Polymer aluminum capacitors from several manufacturers with various combinations of capacitance, rated voltage, and ESR values were physically examined and electrically characterized. The physical construction analysis of the capacitors revealed three different capacitor structures, i.e., traditional wound, stacked, and laminated. Electrical characterization results of polymer aluminum capacitors are reported for frequency-domain dielectric response at various temperatures, surge breakdown voltage, and other dielectric properties. The structure-property relations in polymer aluminum capacitors are discussed.

Liu, David↗

Dielectric comparison of lunar and terrestrial fines at lunar conditions

The dielectric properties of lunar fines 74241,2 in the audio-frequency range under lunarlike conditions are presented. Results suggest that volatiles are released during storage and transport of the lunar sample. Apparently, subsequent adsorption of volatiles on the sample surface alters its dielectric response. The assumed volatile influence disappears after evacuation. A comparison of the dielectric properties of lunar and terrestrial materials as a function of density, temperature, and frequency indicates that if the terrestrial sample analyzed were completely devoid of atmospheric moisture, it would present dielectric losses smaller than those of the lunar sample. It is concluded that density prevails over temperature as the controlling factor of dielectric permittivity in the lunar regolith and that dielectric losses vary slowly with depth.

Alvarez, R.↗

Molecular Modeling of the Poling of Piezoelectric Polyimides

The computational method described in this paper allows the calculation of the dielectric relaxation strength of an amorphous polymer based solely upon its chemical structure. The 4,4' oxydiphthalic anhydride (ODPA) dianhydride and bis-aminophenoxybenzene (APB) diamine based polyimides, (beta-CN) APB-ODPA and APB-ODPA were studied. Amorphous cells were constructed and then poled using molecular dynamics. Dielectric relaxation strengths of Delta(epsilon) = 17.8 for (beta-CN) APB-ODPA and Delta(epsilon) = 7.7 for APB-ODPA were predicted. These values are in excellent agreement with the experimental values. It was found that both the pendant nitrile dipole and the backbone anhydride residue dipole make significant contributions to the polyimides dielectric response. Specifically, it was shown that the difference in the magnitude of the dielectric relaxations is directly attributable to the nitrile dipole. The size of the relaxations indicate an absence of cooperative dipolar motions, The model was used to explain these results in terms of the average orientation of the nitrile and anhydride dipoles to within 51 deg. and 63 deg., respectively, of the applied electric field.

Young, J. A.↗

Correlation of dynamic dielectric measurements with viscosity in polymeric resin systems

Dynamic dielectric analysis has been used to study curing polymer systems and thermoplastics. Measurements have been made over a frequency range of six decades. This wide range of frequencies increases the amount of information which can be obtained. The data are analyzed in terms of the frequency dependence of the specific conductivity sigma and the relaxation time tau, parameters which are characteristic of the cure state of the material and independent of size of the sample. Dynamic dielectric measurements have been correlated with viscosity for the polysulfone thermoplastic UDEL-P1700 and with viscosity and ultrasonic measurements on the DGEBA-type epoxy Epon 828 cured with Agent U. The experimental results suggest that when ionic processes dominate the dielectric response, the intensive property sigma is a good monitor of the resin's viscosity. The results show that the dielectric relaxation time tau can be used to monitor the state of the system and the extent and rate of the reaction.

Kranbuehl, D.↗

Linear mixing rule in screened binary ionic mixtures

The validity of the linear mixing rule is examined for the following two cases (1) when the response of the electron gas is taken into account in the effective ionic interaction and (2) when finite-temperature effects are included in the dielectric response of the electrons, i.e., when the ions interact with both temperature- and density-dependent screened Coulomb potentials. It is found that the linear mixing rule remains valid when the electron response is taken into account in the interionic potential at any density, even though the departure from linearity can reach a few percent for the asymmetric mixtures in the region of weak degeneracy for the electron gas. A physical explanation of this behavior is proposed which is based on a simple additional length scale.

Chabrier, G.↗

Permafrost - Relation between ice content and dielectric losses at 100 K

The dielectric response of permafrost at 100 K and vacuums of around 10 ntorr is analyzed, varying its percent ice content from 1 to 18.6. The distributions obtained correspond to dielectric relaxations of the Cole-Cole type, with maximum losses occurring in the 30- to 600-Hz frequency range. The logarithms of such maxima depend linearly on the permafrost ice content, two regions of linear variation being defined above and below 3.6% ice content. Such relations point out the feasibility of determining ice content in permafrost by electromagnetic means.

Alvarez, R.↗

Low frequency dielectric relaxation in boracites

In order to elucidate the nature of the imperfections which adversely affect pyroelectric processes in boracites, the thermal and dispersive characteristics of the low frequency dielectric response in iron-iodide boracite (Fe3B7O13I) and copper-chloride boracite (Cu3B7O13Cl) have been investigated. These characteristics were measured as a function of crystallographic orientation and applied field in both the ferroelectric and paraelectric states. The low frequency dielectric relaxation of 100 line oriented multi-domain copper-chloride boracite clearly indicates the dipole nature of the lattice imperfections. The activation energies calculated from a noninteracting Debye model, are 0.53 eV in the ferroelectric phase and 0.10 eV in the paraelectric phase.

Kim, Q.↗

Observations and interpretation of the infrared spectrum of HD 44179

Infrared spectra of HD 44179 have been obtained for the 3040-, 1150-, and 890-kayser emission features. The strengths of the features put constraints on the possible constituents of the materials responsible for each emission feature. The 3040-kayser feature can be due to emission either from a solid (if it arises from a different region than the 890-kayser feature) or from a gas-phase molecule. The 8-13-micron spectrum is fitted with a simple model employing carbonates plus a dielectric in emission and silicates in absorption. It is suggested that amorphous carbon is the dielectric responsible for the featureless underlying continuum.

Bregman, J. D.↗

Temperature Dependence of the Microwave Dielectric Behavior of Selected Materials

A very sensitive thermal bath is designed to study the effect of temperature on the microwave dielectric response of a sample of nickel oxide and cobalt oxide. The sample under study is placed in a microwave resonant cavity in the TE(sub 011) mode. The perturbations of the electric field are recorded in terms of the frequency shifts and the width changes of the microwave resonant signal as seen on the oscilloscope. The real and imaginary parts of the dielectric constant are calculated by using the values of the frequency shifts and width changes in the Slater's perturbation equations. The dielectric behavior of nickel oxide and cobalt oxide and also their mixture is studied at a microwave frequency of 9.2 GHz as a function of temperature. A computer program is written to analyze the dielectric constant values at different temperatures. The resonant cavity seems to be very sensitive in studying the dielectric relaxation mechanism in these materials. The dielectric behavior is also analyzed using Debye's equations, and relaxation times for these materials are calculated at microwave frequencies.

Dahiya, Jai N.↗