Search NASA⌕ Search

SEARCH · Search NASA

Results for “dynamic behavior”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1966

Dynamic behavior of soap films.

Dynamic behavior of soap film stretched between two coaxial rings, assuming potential energy of this surface to be proportional to surface area

FILM↗
NASA NTRS1974

High speed photographic study of hot wire dynamic behavior

Investigation of hot wire dynamic behavior under high-current heating aimed at a better understanding of the ignition process, using high-speed photographic techniques for visual observation of the bridgewire itself during high current heating. Tests were conducted with Tophet A bridgewires in an air environment, as well as in a cell of distilled water at room temperature, and with a boron-potassium perchlorate-Viton pyrotechnic against the bridgewire behind a Plexiglas window.

Sernas, V.↗
NASA NTRS1971

Dynamic behavior of the mercury damper

The dynamic behavior of the mercury nutation damper is investigated. Particular attention is paid to the eccentric annular mercury configuration, which is the final continuous ring phase that occurs in the operation of all mercury dampers. In this phase, damping is poorest, and the system is closely linear. During the investigation, the hydrodynamic problem is treated as three dimensional, and extensive use is made of a variational principle of least-viscous frictional power loss. A variational principle of least-constraint is also used to advantage. Formulas for calculating the behavior of the mercury damper are obtained. Some confirmatory experiments were performed with transparent ring channels on a laboratory gyroscope. Selected movie frames taken during wobble damping are shown along with the results of film measurements.

Crout, P. D.↗
NASA NTRS1984

Dynamic Behavior of Spiral-Groove and Rayleigh-Step Self-Acting Face Seals

Tests were performed to determine the dynamic behavior and establish baseline dynamic data for five self-acting face seals employing Rayleigh-step lift-pads and inward pumping as well as outward-pumping spiral grooves for the lift-generating mechanism. The primary parameters measured in the tests were film thickness, seal seat axial motion, and seal frictional torque. The data show the dynamic response of the film thickness to the motion of the seal seat. The inward-pumping spiral-groove seals exhibited a high-amplitude film thickness vibratory mode with a frequency of four times the shaft speed. This mode was not observed in the other seals tested. The tests also revealed that high film thickness vibration amplitude produces considerably higher average film thickness than do low amplitude film thickness vibrations. The seals were tested at a constant face load of 73 N (16.4 lb) with ambient air at room temperature and atmospheric pressure as the fluid medium. The test speed range was from 7000 to 17000 rpm. Seal tangential speed range was 34.5 to 83.7 m/sec (113 to 274 ft/sec).

Dirusso, Eliseo↗
NASA NTRS1992

A comparison between theoretical prediction and experimental measurement of the dynamic behavior of spur gears

A comparison was made between computer model predictions of gear dynamics behavior and experimental results. The experimental data were derived from the NASA gear noise rig, which was used to record dynamic tooth loads and vibration. The experimental results were compared with predictions from the DSTO Aeronautical Research Laboratory's gear dynamics code for a matrix of 28 load speed points. At high torque the peak dynamic load predictions agree with the experimental results with an average error of 5 percent in the speed range 800 to 6000 rpm. Tooth separation (or bounce), which was observed in the experimental data for light torque, high speed conditions, was simulated by the computer model. The model was also successful in simulating the degree of load sharing between gear teeth in the multiple tooth contact region.

Rebbechi, Brian↗
NASA NTRS1960

Analytical Investigation of the Dynamic Behavior of a Nonlifting Manned Reentry Vehicle

An analytic investigation was made of the dynamic behavior of a nonlifting manned reentry vehicle as it descended through the atmosphere. The investigation included the effects of variations in the aerodynamic stability derivatives, the spin rate, reentry angle, and velocity. The effect of geostrophic winds and of employing a drogue parachute for stability purposes were also investigated. It was found that for the portion of the flight above a Mach number of 1 a moderate amount of negative damping could be tolerated but below a Mach number of 1 good damping is necessary. The low-speed stability could be improved by employing a drogue parachute. The effectiveness of the drogue parachute was increased when attached around the periphery of the rear of the vehicle rather than at the center. Neither moderate amounts of spin or the geostrophic winds had appreciable effects on the stability of the vehicle. The geostrophic winds and the reentry angle or velocity all showed important effects on the range covered by the reentry flight path.

Lichtenstein, Jacob H.↗