SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Longitudinal thermomolecular flow theories at intermediate pressures, comparing similarities and discrepancies in forces acting on hangdowns or samples in microbalance measurements
An overview of the aerodynamic performance, longitudinal trim, and control surface effectiveness as developed from the second Shuttle flight is presented, along with comparisons with preflight predictions. The Orbiter enters the atmosphere at Mach 29 and descends through all the Mach speeds until touchdown. Control mechanisms for the Orbiter are outlined, noting the lessening of angle of attack as the terminal configuration is reached. Methods of developing the wind tunnel predictions are reviewed, including performance in different altitudes and speed regimes, and the impetus to decouple the flight control system from aerodynamics with respect to uncertainties. Preflight predictions agreed well with the lift/drag ratio above Mach 1, but higher L/D was exhibited than predicted below Mach 1. A deficiency in the wind tunnel environment was concluded for the inaccuracies in the predictions for hypersonic trim characteristics.
The Space Shuttle orbiter flight test program has required the aerodynamicist to take a new approach in determining flight characteristics. A conventional flight test program of slowly and cautiously approaching more severe flight conditions was not possible with the orbiter. On the first four orbital flights, The orbiter entered the atmosphere at approximately Mach 29 and decelerated through the Mach range (the subsonic portion of flight had also been flown by another orbiter vehicle during the Approach and Landing Test Program). Certification for these flights was achieved by an extensive wind tunnel test and analysis program. The initial series of flights of the orbiter were heavily instrumented for the purpose of obtaining accurate aerodynamic data. The flight data derived from the entry Mach range provided comparisons between flight and wind tunnel derived predicted data in the areas of both aerodynamic performance and longitudinal trim.
Radar reflection properties of baffles and fences for suppression of ground reflected signal
Longitudinal aerodynamic characteristics of delta wings with curved & straight leading edges from mach 3 to 6
Previously cited in issue 10, p. 1557, Accession no. A82-24655
Explore the source record for details and available documents.
Explore the source record for details and available documents.
A simulator comparison of the velocity vector control wheel steering (VCWS) system and a decoupled longitudinal control system is presented. The piloting task was to use the electronic attitude direction indicator (EADI) to capture and maintain a 3 degree glide slope in the presence of wind shear and to complete the landing using the perspective runway included on the EADI. The decoupled control system used constant prefilter and feedback gains to provide steady state decoupling of flight path angle, pitch angle, and forward velocity. The decoupled control system improved the pilots' ability to control airspeed and flight path angle during the final stages of an approach made in severe wind shear. The system also improved their ability to complete safe landings. The pilots preferred the decoupled control system in severe winds and, on a pilot rating scale, rated the approach and landing task with the decoupled control system as much as 3 to 4 increments better than use of the VCWS system.
Accounts are presented of representative applications to missile bodies of arbitrary shape of methods based on the steady form of the full potential equation. The NCOREL and SIMP full-potential codes are compared, and their results are evaluated for the cases of an arrow wing and a wing-body configuration. Attention is given to the effect of cross-sectional and longitudinal geometries. Comparisons of surface pressure and longitudinal force and moment data for circular and elliptic bodies have shown that the full-potential methods yielded excellent results in attached-flow conditions. Results are presented for a conical star body, waveriders, the Shuttle Orbiter, and a highly swept wing-body cruising at Mach 4.
Some recent experience at Ames Research Center in the estimation of aerodynamic coefficients for the Lear-Jet and the Augmentor Wing Jet STOL Research Aircraft is reviewed. The coefficients estimated from flight data are compared with values based on large-scale wind-tunnel tests. The results obtained by the regression and quasilinearization identification techniques are also compared. The regression method generally provides the lower standard deviation in the coefficient estimates and provides the better fit to the wind-tunnel values. The addition of nonlinear terms in the aerodynamic equations decreases the difference between the estimated and measured time histories but also increases the standard deviation in the estimated coefficient values.
An analytical method is presented for predicting the lift coefficient, the pitching moment coefficient, and the drag coefficient of light, twin-engine, propeller-driven airplanes. The method was applied to the Advanced Technology Light Twin-Engine airplane. The calculated characteristics were then correlated against full scale wind tunnel data. The analytical method was found to predict the drag and pitching moment fairly well. However, the lift prediction was extremely poor.
Longitudinal aerodynamic performance comparisons between flight extracted and predicted values are presented for the first eight NASA Space Shuttle entry missions. Challenger results are correlated with the ensemble five flight Columbia experience and indicate effects due to differing angle-of-attack and body flap deflection profiles. An Appendix is attached showing the results of each flight using both the LaRC LAIRS and NOAA atmospheres. Discussions are presented which review apparent density anomalies observed in the flight data, with particular emphasis on the suggested shears and turbulence encountered during STS-2 and STS-4. Atmospheres derived from Shuttle data are presented which show structure different than that remotely sensed and imply regions of unstable air masses as a plausible explanation. Though additional aerodynamic investigations are warranted, an added benefit of Shuttle flight data for atmospheric research is discussed, in particular, as applicable to future NASA space vehicles such as AOTVs and tethered satellites.
A comparison of longitudinal and lateral directional stability and control characteristics of the Phase B Grumman H-33 orbiter configuration obtained from 6 tests conducted in 4 different facilities is presented. The H-33 orbiter configuration does not include drop tanks. Slope data are used as the medium for comparison. The slope data were computed using the SADSAC system and have been reduced to a common reference system. Data used for comparison were selected based on common configurations wherever possible. Where direct configuration comparisons were not possible, the parameters selected for comparison are regarded as insensitive to the noted differences. Factors considered in comparing the various data were scaling effects, balance operating ranges, balance sensitivities and control deflection accuracies. All factors considered, the comparison among data obtained from the various facilities is excellent. The minor differences in stability and control characteristics are well within the accuracy band of preliminary design model construction specifications.
NASA Space Shuttle aerodynamic and aerothermodynamic research is but one part of the most comprehensive end-to-end flight test program ever undertaken considering: the extensive pre-flight experimental data base development; the multitude of spacecraft and remote measurements taken during entry flight; the complexity of the Orbiter aerodynamic configuration; the variety of flight conditions available across the entire speed regime; and the efforts devoted to flight data reduction throughout the aerospace community. Shuttle entry flights provide a wealth of research quality data, in essence a veritable flying wind tunnel, for use by researchers to verify and improve the operational capability of the Orbiter and provide data for evaluations of experimental facilities as well as computational methods. This final report merely summarizes the major activities conducted by the AMA, Inc. under NASA Contract NAS1-16087 as part of that interesting research. Investigators desiring more detailed information can refer to the glossary of AMA publications attached herein as Appendix A. Section I provides background discussion of software and methodology development to enable Best Estimate Trajectory (BET) generation. Actual products generated are summarized in Section II as tables which completely describe the post-flight products available from the first three-year Shuttle flight history. Summary results are presented in Section III, with longitudinal performance comparisons included as Appendices for each of the flights.
Freeway crash prediction models are the basic of traffic safety research, yet crash occurrence and the influencing factors change over time. In order to make sure the implemented safety models fit the current traffic environment, this study conducts a comparative analysis of 2017 and 2020 datasets collected from freeways in Suzhou, China. Herein, considering the spatial correlation among analysis units and the hierarchical data structure, a Bayesian conditional autoregressive negative binomial (CAR-NB) model and a Bayesian hierarchical CAR-NB (HCAR-NB) model were used to explore the safety influencing factors, and a traditional NB model was developed for further comparison. To update the HCAR-NB model from 2017 to 2020, Bayesian inference with informative priors was used to improve its goodness of fit and efficiency. Preliminary results showed that 1) the HCAR-NB model outperformed the NB model and CAR-NB model in prediction accuracy, and 2) the number of crashes was significantly correlated with average speed, speed variance, road segment length, number of lanes, and presence of ramps. The potential for safety improvement (PSI) method was applied to the modeling results to identify hotspots for the two years. The results confirmed that the hotspots spatiotemporally shifted among the freeways. The proposed crash prediction model and updating method are expected to assist implementation of informed countermeasures for freeway safety improvement.
Results from recent investigations in the Langley V/STOL tunnel of an externally blown flap and an upper surface blown flap configuration in ground proximity are presented. Comparisons of longitudinal aerodynamic characteristics indicate that in ground proximity, drag is reduced for both configurations, but changes in lift are configuration dependent. Steady state analyses of the landing approach indicate an increase in flight path angle for both configurations in ground proximity because of the drag reduction. Dynamic analyses with a fixed-base simulator indicate that the resultant flight path during landing approach is dependent on the initial flight path angle and the control technique used.
An analytical analysis of conditions producing pilot induced oscillations (PIO's) was made for the space shuttle orbiter in a landing approach configuration for the task of milling the elevation angle of the line of sight to a target vehicle. The analysis yielded a value of PIO frequency and a value for the amount of total system time delay (pilot + control system) that can be tolerated before instability results. Calculations were performed showing the effect of varying the range to the target and of varying the handling qualities of the orbiter vehicle. Analytical predictions were compared with simulation results obtained using a visual motion simulator.