Search NASA⌕ Search

SEARCH · Search NASA

Results for “magnetic systems”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Magnetohydrodynamics (MHD) Engineering Test Facility (ETF) 200 MWe power plant. Conceptual Design Engineering Report (CDER) supplement. Magnet system special investigations

The results of magnet system special investigations listed below are summarized: 4 Tesla Magnet Alternate Design Study; 6 Tesla Magnet Manufacturability Study. The conceptual design for a 4 Tesla superconducting magnet system for use with an alternate (supersonic) ETF power train is described, and estimated schedule and cost are identified. The magnet design is scaled from the ETF 6 T Tesla design. Results of a manufacturability study and a revised schedule and cost estimate for the ETF 6 T magnet are reported. Both investigations are extensions of the conceptual design of a 6 T magnet system performed earlier as a part of the overall MED-ETF conceptual design described in Conceptual Design Engineering Report (CDER) Vol. V, System Design Description (SDD) 503 dated September, 1981, DOE/NASA/0224-1; NASA CR-165/52.

Source record↗
NASA NTRS1974

Improved thermal isolation for superconducting magnet systems

Closed-cycle refrigerating system for superconductive magnet and maser is operated in vacuum environment. Each wire leading from external power source passes through cooling station which blocks heat conduction. In connection with these stations, switch with small incandescent light bulb, which generates heat, is used to stop superconduction.

Wiebe, E. R.↗
NASA NTRS1995

The LHC magnet system and its status of development

CERN is preparing for the construction of a new high energy accelerator/collider, the Large Hadron Collider (LHC). This new facility will mainly consist of two superconducting magnetic beam channels, 27 km long, to be installed in the existing LEP tunnel. The magnetic system comprises about 1200 twin-aperture dipoles, 13.145 m long, with an operational field of 8.65 T, about 600 quadrupoles, 3 m long, and a very large number of other superconducting magnetic components. A general description of the system is given together with the main features of the design of the regular lattice magnets. The paper also describes the present state of the magnet R & D program. Results from short model work, as well as from full scale prototypes will be presented, including the recently tested 10 m long full-scale prototype dipole manufactured in industry.

Bona, Maurizio↗
NASA NTRS1992

Progress of magnetic suspension systems and magnetic bearings in the USSR

This paper traces the development and progress of magnetic suspension systems and magnetic bearings in the USSR. The paper describes magnetic bearings for turbomachines, magnetic suspension systems for vibration isolation, some special measuring devices, wind tunnels, and other applications. The design, principles of operation, and dynamic characteristics of the system are presented.

Kuzin, A. V.↗
NASA NTRS1986

Open system magnetic evolution of the taos plateau volcanic field, Northern New Mexico. I - The petrology and geochemistry of the servilleta basalt

MULTIFIT, an embodiment of the conceptual structure needed in modeling multisource and multiprocess magmatic systems, is described. This program, which uses familiar materials balance methodology and the equilibrium form of the Rayleigh equations, links evolutionary arrays, which is turn collectively relate the starting and final compositions of a given magmatic system. Moreover, MULTIFIT incorporates variations within major element data arrays; the linkage between them can be tested using an extension of the least squares algorithm, which selects the best branch point according to the minimum-sum-of-squared-residuals criterion. Advantages and disadvantages of the materials balance approach used in this program are discussed, an example is provided, and equations utilized by MULTIFIT are summarized. While MULTIFIT may not be the best approach for poorly constrained models involving partial melting for complex mixing, it may ultimately prove useful for ascertaining trace element partition coefficients in magnetic systems.

Dungan, M. A.↗
NASA NTRS2001

Flightweight Electro-Magnet Systems

NASA has a need for lightweight high performance magnets to be used in propulsion systems involving plasmas. We report the design, construction, and testing of a six inch diameter by twelve inch long solenoid using high purity aluminum wire operating at a temperature of 77 Kelvin (K) for the current carrying element. High purity aluminum is the material of choice because of three properties that make it optimal for magnetic construction. At 77 K high purity aluminum has one of the lowest resistivities at 77 K of any metal (p = 0.254 muOMEGA-cm), thus reducing the power requirements for creating magnetic fields. Aluminum is a low-density (2.6989 g/cc) material and the end product magnet will be of low total mass compared to similar designs involving copper or other elements. The magneto-resistance of aluminum saturates at low magnetic fields and does not increase indefinitely as is the case in copper. The magnet consists of four layers of closely wound wire and is approximately 150 mm in diameter by 300 mm long. A cylinder made from G - 10 was machined with a spiral groove to hold the high purity Al wire and the wire wound on it. Following the winding, each layer was potted in STYCAST high thermal conductivity epoxy to provide insulation between the turns of the coil and mechanical strength. The magneto-resistance of the coil has been measured at the National High Magnetic Field Laboratory (NHMFL), Tallahassee, FL in externally applied fields to 10 tesla. Following these tests it was energized to the full 2 tesla field it can produce using the facilities of the NHMFL at the Los Alamos National Laboratory. The results of all of these tests will be presented.

Goodrich, Roy G.↗
NASA NTRS1991

Generation and behavior of solar system magnetic fields

A range of problems aimed primarily at elucidating the character and consequences of magnetic-field generation in the solar system and at testing ideas against known properties of natural magnetic fields are covered. Among the specific subjects currently under investigation are the magnetohydrodynamic (MHD) character of the protosolar nebula, including the generation and behavior of magnetic fields, the electrical conductivity of dusty nebular gas, transient magnetodynamic and electrodynamic nebular phenomena, and the generation and dynamical behavior of planetary magnetic fields. During the past year, the focus of this research was on disk magnetic field generation and transient MHD heating events possibly associated with the protoplanetary nebula.

Levy, Eugene H.↗
NASA NTRS1972

Development and fabrication of a chargeable magnet system for spacecraft control

The design of variable permanent magnets for use in magnetic balancing and control of earth orbiting spacecraft is discussed. These magnets can be used instead of air coils or electromagnets in applications where the objective is to produce, or eliminate, torque on the spacecraft through interaction with the earth's magnetic field. The configuration of the magnet for minimum size and weight is described.

Source record↗
NASA NTRS1984

Stellar fibril magnetic systems. I - Reduced energy state

The remarkable fibril structure of the magnetic fields at the surface of the sun (with fibrils compressed to 1,000-2,000 gauss) lies outside existing statistical theories of magnetohydrodynamic turbulence. The total energy of the fibril field is enhanced by a factor of more than 100 above the energy for the mean field in a continuum state. The magnetic energy density within a fibril is of the order of 100 times the local kinetic energy density, so that no simple application of equipartition principles is possible. It is pointed out that the total energy of the atmosphere (thermal + gravitational + magnetic) is reduced by the fibril state of the field by avoiding the magnetic inhibition of the convective overturning, suggesting that the formation of the observed intense fibril state may be in response to the associated energy reduction. Calculation of the minimum total energy of a polytropic atmosphere permeated by magnetic fibrils yields theoretical fibril fields of the order of 1-5 kilogauss when characteristics appropriate to the solar convective zone are introduced, in rough agreement with the actual fields of 1-2 kilogauss. The polytrope model, although crude, establishes that a large reduction in total energy is made possible by the fibril state.

Parker, E. N.↗
NASA NTRS1985

Stellar fibril magnetic systems. II - Two-dimensional magnetohydrodynamic equations. III - Convective counterflow

The dynamics of magnetic fibrils in the convective zone of a star is investigated analytically, deriving mean-field equations for the two-dimensional transverse motion of an incompressible fluid containing numerous small widely spaced circular cylinders. The equations of Parker (1982) are extended to account for the inertial effects of local flow around the cylinders. The linear field equation for the stream function at the onset of convection is then rewritten, neglecting large-scale heat transport, and used to construct a model of convective counterflow. The Kelvin impulse and fluid momentum, convective motion initiated by a horizontal impulse, and the effects of a viscous boundary layer are considered in appendices.

Parker, E. N.↗