Search NASA⌕ Search

SEARCH · Search NASA

Results for “resonance decay”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records

Resonant decay of global MHD modes at 'thick' interfaces

A global surface mode can exist on a 'surface' which is not a true discontinuity, but without sufficient dissipation it is not a normal mode and it decays in time via resonance absorption. The decay rate can be calculated analytically when the 'surface' is thin. The goal of this paper is to numerically estimate the decay rate when the surface is not thin. A cold plasma in a uniform magnetic field is considered in which density varies linearly across the 'surface'. In this linearized calculation, the global surface mode is driven in steady state by an antenna located in one of the uniform regions external to the surface. The frequency is a free parameter, and resonance curves are computed numerically without approximations. The widths of the resonance curves are used to estimate the free decay times of undriven surface modes, via the uncertainty principle. When applied to the active solar corona, the decay rates are large enough to account for the coronal heating, but it should be kept in mind that the role of nonlinearity in resonance absorption is still undetermined.

Hollweg, Joseph V.↗

Improved L-C resonant decay technique for Q measurement of quasilinear power inductors: New results for MPP and ferrite powdered cores

The L-C resonant decay technique for measuring circuit Q or losses is improved by eliminating the switch from the inductor-capacitor loop. A MOSFET switch is used instead to momentarily connect the resonant circuit to an existing voltage source, which itself is gated off during the decay transient. Very reproducible, low duty cycle data could be taken this way over a dynamic voltage range of at least 10:1. Circuit Q is computed from a polynomial fit to the sequence of the decaying voltage maxima. This method was applied to measure the losses at 60 kHz in inductors having loose powder cores of moly permalloy and an Mn-Zn power ferrite. After the copper and capacitor losses are separated out, the resulting specific core loss is shown to be roughly as expected for the MPP powder, but anomalously high for the ferrite powder. Possible causes are mentioned.

Niedra, Janis M.↗

Eta Meson Production in Proton-Proton and Nuclear Collisions

Total cross sections for eta meson production in proton - proton collisions are calculated. The eta meson is mainly produced via decay of the excited nucleon resonance at 1535 MeV. A scalar quantum field theory is used to calculate cross sections, which also include resonance decay. Comparison between theory and experiment is problematic near threshold when resonance decay is not included. When the decay is included, the comparison between theory and experiment is much better.

Norbury, John W.↗

Pion production via isobar giant resonance formation and decay

A spin, isotopic-spin formalism for the production of pions due to decays of isobar giant resonances formed in peripheral heavy-ion collisions is presented. The projectile nucleus isobar giant resonance state is assumed to coherently form and then incoherently decay to produce the pions. Total spin and isotopic spin for the system are conserved through the concomitant excitation of the target nucleus to an isobaric analog giant resonance state. Comparisons of the predicted total pion cross sections, over a range of energies, are made with heavy-ion pion data.

Townsend, L. W.↗

Spectra, composition, and interactions of nuclei with magnet interaction chambers

Emulsion chambers will be flown in the Astromag Facility to measure the cosmic ray composition and spectra to 10 exp 15 eV total energy and to definitively study the characteristics of nucleus-nucleus interactions above 10 exp 12 eV/n. Two configurations of emulsion chambers will be flown in the SCIN/MAGIC experiment. One chamber has an emulsion target and a calorimeter similar to those recently flown on balloons for composition and spectra measurements. The other has an identical calorimeter and a low-density target section optimized for performing rigidity measurements on charged particles produced in interactions. The transverse momenta of charged and neutral mesons, direct hadronic pairs from resonance decays and interference effects, and possible charge clustering in high-density states of matter will be studied.

Parneil, T. A.↗

The 15th order resonance on the decaying orbit of TETR-3

The orbit of TETR-3 (1971-83B), inclination: 33 deg, passed through resonance with 15th order geopotential terms in February 1972. The resonance caused the orbit inclination to increase by 0.015 deg. Analysis of 48 sets of mean Kepler elements for this satellite in 1971-1972 (across the resonance) has established strong constraints for high degree, 15th order gravitational terms (normalized). This result combined with previous results on high inclination 15th order and other resonant orbits suggests that the coefficients of the gravity field beyond the 16th degree are significantly smaller than Kaula's rule.

Wagner, C. A.↗

15th order resonance terms using the decaying orbit of TETR-3

Fifteenth-order commensurability of the orbit of TETR-3 (1971-83B) is studied. The study is designed to obtain good discrimination of 15th-order resonances through a better range of inclinations. The first low inclination orbit, 33 deg, is used for this purpose; it is very sensitive to the high degree terms which were rather poorly represented by previously analyzed orbits.

Wagner, C. A.↗

EPR Imaging at a Few Megahertz Using SQUID Detectors

An apparatus being developed for electron paramagnetic resonance (EPR) imaging operates in the resonance-frequency range of about 1 to 2 MHz well below the microwave frequencies used in conventional EPR. Until now, in order to obtain sufficient signal-to-noise radios (SNRs) in conventional EPR, it has been necessary to place both detectors and objects to be imaged inside resonant microwave cavities. EPR imaging has much in common with magnetic resonance imaging (MRI), which is described briefly in the immediately preceding article. In EPR imaging as in MRI, one applies a magnetic pulse to make magnetic moments (in this case, of electrons) precess in an applied magnetic field having a known gradient. The magnetic moments precess at a resonance frequency proportional to the strength of the local magnetic field. One detects the decaying resonance-frequency magnetic- field component associated with the precession. Position is encoded by use of the known relationship between the resonance frequency and the position dependence of the magnetic field. EPR imaging has recently been recognized as an important tool for non-invasive, in vivo imaging of free radicals and reduction/oxidization metabolism. However, for in vivo EPR imaging of humans and large animals, the conventional approach is not suitable because (1) it is difficult to design and construct resonant cavities large enough and having the required shapes; (2) motion, including respiration and heartbeat, can alter the resonance frequency; and (3) most microwave energy is absorbed in the first few centimeters of tissue depth, thereby potentially endangering the subject and making it impossible to obtain adequate signal strength for imaging at greater depth. To obtain greater penetration depth, prevent injury to the subject, and avoid the difficulties associated with resonant cavities, it is necessary to use lower resonance frequencies. An additional advantage of using lower resonance frequencies is that one can use weaker applied magnetic fields: For example, for a resonance frequency of 1.4 MHz, one needs a magnetic flux density of 0.5 Gauss approximately the flux density of the natural magnetic field of the Earth.

Hahn, Inseob↗

Spillway Preheating

In traditional models only an order one fraction of energy is transferred from the inflaton to radiation through nonperturbative resonance production in preheating immediately after inflation, due to backreaction effects. We propose a particle production mechanism that could improve the depletion of the inflaton energy density by up to four orders of magnitude. The improvement comes from the fast perturbative decays of resonantly produced daughter particles. They act as a “spillway” to drain these daughter particles, reducing their backreaction on the inflaton and keeping the resonant production effective for a longer period. Thus we dub the scenario “spillway preheating”. We also show that the fraction of energy density remaining in the inflaton has a simple inverse power-law scaling in the scenario. In general, spillway preheating is a much more efficient energy dissipation mechanism, which may have other applications in model building for particle physics.

Cosmology of Theories beyond the SM↗

Theoretical study of the spectroscopy of ZrO

The absorption bands of ZrO have been observed in stars, particularly S stars. Here, theoretical transition probabilities are presented for the dipole-allowed transitions between the six lowest singlet and triplet states of ZrO. The results should be sufficiently reliable to provide opacity data for use in modeling stellar atmospheres. The theoretical radiative lifetime for the e 3Pi state is less than the experimental value as measured by the decay of resonant fluorescence. However, the theoretical electronic transition moments for the gamma system and the B 1Pi - X 1Sigma(+) system are much smaller than those deduced from emission studies. The calculated lifetime for the C 1Sigma(+) state is in excellent agreement with the laser-induced fluorescence studies. The as yet unobserved E 1Phi - A 1Delta band system is found to be relatively strong.

Langhoff, Stephen R.↗

Dynamics of a phase conjugate resonator - Transient build-up and decay rates

The standard four wave mixing model in a sluggish photorefractive medium is employed to calculate the transient response of a phase conjugate resonator. General trends are revealed and discussed in view of the possible utilization of the system in image processing. Experimental results are given to confirm qualitatively the predicted behavior.

Liu, S. R.↗

Photoionization of the Fe lons: Structure of the K-Edge

X-ray absorption and emission features arising from the inner-shell transitions in iron are of practical importance in astrophysics due to the Fe cosmic abundance and to the absence of traits from other elements in the nearby spectrum. As a result, the strengths and energies of such features can constrain the ionization stage, elemental abundance, and column density of the gas in the vicinity of the exotic cosmic objects, e.g. active galactic nuclei (AGN) and galactic black hole candidates. Although the observational technology in X-ray astronomy is still evolving and currently lacks high spectroscopic resolution, the astrophysical models have been based on atomic calculations that predict a sudden and high step-like increase of the cross section at the K-shell threshold (see for instance. New Breit-Pauli R-matrix calculations of the photoionization cross section of the ground states of Fe XVII in the region near the K threshold are presented. They strongly support the view that the previously assumed sharp edge behaviour is not correct. The latter has been caused by the neglect of spectator Auger channels in the decay of the resonances converging to the K threshold. These decay channels include the dominant KLL channels and give rise to constant widths (independent of n). As a consequence, these series display damped Lorentzian components that rapidly blend to impose continuity at threshold, thus reformatting the previously held picture of the edge. Apparent broadened iron edges detected in the spectra of AGN and galactic black hole candidates seem to indicate that these quantum effects may be at least partially responsible for the observed broadening.

Palmeri, P.↗