Search NASA⌕ Search

SEARCH · Search NASA

Results for “shock data analysis”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Pyrotechnic shock measurement and data analysis requirements

A study of laboratory measurement and analysis of pyrotechnic shock prompted by a discrepancy in preliminary Mariner Jupiter/Saturn shock test data is reported. It is shown that before generating shock response plots from any recorded pyrotechnic event, a complete review of each instrumentation and analysis system must be made. In addition, the frequency response capability of the tape recorder used should be as high as possible; the discrepancies in the above data were due to inadequate frequency response in the FM tape recorders. The slew rate of all conditioning amplifiers and input converters must be high enough to prevent signal distortion at maximum input voltage; amplifier ranges should be selected so that the input pulse is approximately 50% of full scale; the Bessel response type should be chosen for digital shock analysis if antialiasing filters are employed; and transducer selection must consider maximum acceleration limit, mounted resonance frequency, flat clean mounting surfaces, base bending sensitivity, and proper torque.

Albers, L.↗
NASA NTRS2010

On the Shock-Response-Spectrum Recursive Algorithm of Kelly and Richman

The monograph Principles and Techniques of Shock Data Analysis written by Kelly and Richman in 1969 has become a seminal reference on the shock response spectrum (SRS) [1]. Because of its clear physical descriptions and mathematical presentation of the SRS, it has been cited in multiple handbooks on the subject [2, 3] and research articles [4 10]. Because of continued interest, two additional versions of the monograph have been published: a second edition by Scavuzzo and Pusey in 1996 [11] and a reprint of the original edition in 2008 [12]. The main purpose of this note is to correct several typographical errors in the manuscript's presentation of a recursive algorithm for SRS calculations. These errors are consistent across all three editions of the monograph. The secondary purpose of this note is to present a Matlab implementation of the corrected algorithm.

Martin, Justin N.↗
NASA NTRS1975

Pyrotechnic shock measurement and data analysis requirements

An investigation of laboratory measurement and analysis of pyrotechnic shock is described which was prompted when two separate facilities produced discrepant pyrotechnic-shock data while testing Mariner Jupiter/Saturn 1977 spacecraft hardware. Both testing facilities are thoroughly examined to find a possible cause for the discrepancies, and it is noted that one facility incorporated an FM tape recorder operating at 60 in./sec with a frequency response of 20 kHz while the other incorporated a tape recorder operating at 120 in./sec with a frequency response of 80 kHz. It is found that the discrepancies were a direct result of the inadequate recording frequency response of the tape recorders. Other factors involved in obtaining more accurate data are discussed.

Albers, L.↗
NASA NTRS1975

Pyrotechnic shock measurement and data analysis requirements

An investigation is described into the laboratory measurement and analysis of pyrotechnic shock which was prompted at JPL when two separate facilities generated discrepant pyrotechnic shock data while testing Mariner Jupiter/Saturn 1977 spacecraft hardware. Both of the testing facilities were surveyed. The only difference noted was in the FM tape recorders used to record the data. One facility used a tape recorder operating at 60 in./sec with a frequency response of 20 kHz; the other used a tape recorder operating at 120 in./sec with a frequency response of 80 kHz. The accelerometers, cables, charge amplifiers, and mechanical setups were identical.

Albers, L.↗
NASA NTRS1975

Development of solar wind shock models with tensor plasma pressure for data analysis

The development of solar wind shock models with tensor plasma pressure and the comparison of some of the shock models with the satellite data from Pioneer 6 through Pioneer 9 are reported. Theoretically, difficulties were found in non-turbulent fluid shock models for tensor pressure plasmas. For microscopic shock theories nonlinear growth caused by plasma instabilities was frequently not clearly demonstrated to lead to the formation of a shock. As a result no clear choice for a shock model for the bow shock or interplanetary tensor pressure shocks emerged.

Abraham-Shrauner, B.↗
NASA NTRS2009

Pyroshock Simulation Systems: Are We Correctly Qualifying Flight Hardware for Pyroshock Environments?

There are several methods of shock testing that are commonly used by the aerospace industry to qualify flight hardware to pyroshock environments. In some cases the shock results and in particular the shock response spectra computed from these tests were interpreted in such a way as to satisfy the testing requirements and were often considered successful for flight hardware qualification. However, close scrutiny of these acquired shock data suggest gross violation of the pyroshock qualification requirements. There are several issues, both in terms of the shock generation mechanisms and the shock signature acquisition and analysis that have led to improper qualification of flight hardware. In this paper some factors contributing to the misinterpretation of the shock data are reviewed. First, issues with the hardware fixturing and instrumentation that may lead to incorrect shock testing are discussed. Second, issues facing the shock simulation systems and pyrotechnic testing are reviewed. Finally, issues pertaining to the data acquisition and analysis are briefly discussed.

instrumentation↗
NASA NTRS1987

Measurement, data analysis and prediction of pyrotechnic shock from pin-pullers and separation joints

To evaluate the potential for spacecraft damage caused by activation of pyrotechnic mechanisms, pyrotechnic shock tests were conducted on three configurations: pin-pullers on an orthogonal double Hopkinson bar arrangement, pin-pullers on a mock-up of the HALOE (Halogen Occultation Experiment) structure, and a section of separation joint on a single Hopkinson bar. Strains and accelerations were measured. The strains were converted to output stresses, forces and moments. Acceleration shock response spectra are presented for both acceleration- and force-time signals. The devices were attached to the Hopkinson bars with adaptors, which are typical of attachments used in practice. In order to predict the effect of the adaptors, finite element models of the adaptor-bar combinations were analyzed and results are presented with regard to grid size, time interval, and frequency range required to predict the response to pulses of 10 and 100 microsecond duration.

Evans, Maria J.↗
NASA NTRS1986

Radiative Viscous Shock Layer Analysis of Fire, Apollo, and PAET Flight Data

Equilibrium, radiating viscous shock layer solutions are obtained for a number of trajectory points of the Fire II, Apollo 4, and PAET experimental flight vehicles. Convective heating rates calculated by a benchmark code agree well with two engineering correlations, except at high altitudes corresponding to low densities. Calculated radiation intensities are compared with the flight radiometer data and with inviscid flow results. Differences as great as 70% are observed between measured data and the viscous calculations. Because of boundary-layer absorption, viscous effects reduce the intensity to the wall by as much as 30% compared with inviscid intensities. Preliminary chemical and thermal nonequilibrium flow calculations along a stagnation streamline for a PAET trajectory predict an enhancement to the radiation owing to the chemical relaxation. Stagnation point solutions are also presented for future aeroassisted orbital transfer vehicle geometries with nose radii of 0.3-15 m.

Balakrishnan, A.↗
NASA NTRS1984

Comparison of viscous-shock-layer heating analysis with Shuttle flight data in slip flow regime

Comparison of STS-2 Shuttle flight heating data along the windward centerline has been made with two-dimensional nonequilibrium viscous shock-layer solutions obtained with shock and wall-slip conditions at an altitude range of 90 to 110 km. The shock slip condition used is the modified Rankine-Hugoniot relations of Cheng as used by Davis, and the wall-slip conditions are based on the first order consideration derived from kinetic theory as given by Scott and Hendricks. The results indicate that the calculated heating distributions with slip boundary conditions agree better with the flight data than those without slip conditions. The agreement improves when the accommodation coefficient or freestream density is decreased to one-half, suggesting the possibility of less than full accommodation for the tile surface and (or) an overestimate of freestream density using the Jacchia-Roberts model. Heating reduction due to the slip effect becomes very pronounced as the flow becomes more rarefied, and the effect is more significant for the stagnation region than the aft region of the vehicle.

Shinn, J. L.↗
NASA NTRS1985

Radiative viscous-shock-layer analysis of Fire, Apollo, and PAET flight data

Equilibrium, radiating viscous-shock-layer solutions are obtained for a number of trajectory points of the Fire II, Apollo 4, and PAET experimental flight vehicles. Convective heating rates calculated by a benchmark code agree well, except at high altitudes corresponding to low densities, with two engineering correlations. Calculated radiation intensities are compared with the flight radiometer data and with inviscid flow results. Differences as great as 70 percent are observed between measured data and the viscous calculations. Viscous effects reduce the intensity toward the wall, because of boundary-layer absorption, by as much as 30 percent, compared with inviscid intensities. Preliminary chemical and thermal nonequilibrium flow calculations along a stagnation streamline for a PAET trajectory predict enhancement of radiation owing to chemical relaxation. Stagnation point solutions are also presented for future air-assisted orbital transfer vehicle geometries with nose radii ranging from 0.3 to 15 m.

Balakrishnan, A.↗
NASA NTRS1996

Pioneer Venus Data Analysis

Analysis and interpretation of data from the Orbiter Retarding Potential Analyzer (ORPA) onboard the Pioneer Venus Orbiter is reported. By comparing ORPA data to proton data from the Orbiter Plasma Analyzer (OPA), it was found that the ORPA suprathermal electron densities taken outside the Venusian ionopause represent solar wind electron densities, thus allowing the high resolution study of Venus bow shocks using both magnetic field and solar wind electron data. A preliminary analysis of 366 bow shock penetrations was completed using the solar wind electron data as determined from ORPA suprathermal electron densities and temperatures, resulting in an estimate of the extent to which mass loading pickup of O+ (UV ionized O atoms flowing out of the Venus atmosphere) upstream of the Venus obstacle occurred. The pickup of O+ averaged 9.95%, ranging from 0.78% to 23.63%. Detailed results are reported in two attached theses: (1) Comparison of ORPA Suprathermal Electron and OPA Solar Wind Proton Data from the Pioneer Venus Orbiter and (2) Pioneer Venus Orbiter Retarding Potential Analyzer Observations of the Electron Component of the Solar Wind, and of the Venus Bow Shock and Magnetosheath.

Jones, Douglas E.↗
NASA NTRS1984

Pyrotechnic shock: A literature survey of the Linear Shaped Charge (LSC)

Linear shaped charge (LSC) literature for the past 20 years is reviewed. The following topics are discussed: (1) LSC configuration; (2) LSC usage; (3) LSC induced pyroshock; (4) simulated pyrotechnic testing; (5) actual pyrotechnic testing; (6) data collection methods; (7) data analysis techniques; (8) shock reduction methods; and (9) design criteria. Although no new discoveries have been made in LSC research, charge shapes are improved to allow better cutting performance, testing instrumentation is refined, and some new explosives, for use in LSC, are formulated.

Smith, J. L.↗
NASA NTRS1998

Far UV Observations of Interstellar Shocks

This grant covered analysis of Hopkins Ultraviolet Telescope data from the Astro-2 mission. The proposed research was aimed primarily at SNR shock waves, but the ASTRO-2 GO program was intended to make the GOs part of the instrument teams. The grant therefore covered extensive travel to Marshall Space Flight Center for mission simulations and the mission itself. In keeping with the unique nature of the ASTRO-2 GO program, I participated actively in the instrument team's investigations of HH objects and cataclysmic variables. Over the course of the Astro-2 mission, we obtained good observations of the supernova remnants SN1006 (1 position), Vela (3 positions), the Cygnus Loop (7 positions) and 0519-69 in the LMC (1 position) as part of this GI program, along with Puppis A (1 position), Vela (1 position), the Cygnus Loop (7 positions) and the Schweizer- Middleditch star (HUT PI program on SNRS). We also observed the Herbig-Haro object HH2 and about a dozen cataclysmic variables, including magnetic systems and dwarf novae. This GI grant covered modest travel for data analysis. We anticipate submitting papers on the non-radiative shock in northern Cygnus Loop, on the LMC Balmer-dominated remnant LMC 0519-69, on the radiative shocks in the Eastern Cygnus Loop (the XA region), and on the cataclysmic variable YZ Cnc over the course of the coming year. We have obtained extensive supporting data from ground-based telescopes for the Cygnus Loop spectra.

Raymond, John C.↗
NASA NTRS1992

Absence of upstream energetic ions under turbulent radial interplanetary magnetic field

Two cases of observations on board the IMP 8 spacecraft of upstream energetic ions were used to test the viability of the Fermi mechanism as an efficient accelerator of particles with E not less than 50 keV at the earth's bow shock, under conditions which are more constrained than those applied in all previously published detailed analyses of upstream ion events. In addition to the nearly radial IMF, the following particle and field conditions were present: (1) in situ cyclotron-resonant wave activity, (2) a seed energetic particle population, and (3) small (not above 25 deg) theta(Bn) at the points of connection of the spacecraft to the bow shock. The analysis of data from days 67, 1979 and 303, 1980 showed that, despite these conditions, no ion enhancements attributable to the Fermi process could be detected.

Sarris, E. T.↗