Search NASA⌕ Search

SEARCH · Search NASA

Results for “skin effect”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records

Anisotropic Nanomechanics of Boron Nitride Nanotubes: Nanostructured "Skin" Effect

The stiffness and plasticity of boron nitride nanotubes are investigated using generalized tight-binding molecular dynamics and ab-initio total energy methods. Due to boron-nitride BN bond buckling effects, compressed zigzag BN nanotubes are found to undergo novel anisotropic strain release followed by anisotropic plastic buckling. The strain is preferentially released towards N atoms in the rotated BN bonds. The tubes buckle anisotropically towards only one end when uniaxially compressed from both. A "skin-effect" model of smart nanocomposite materials is proposed which will localize the structural damage towards the 'skin' or surface side of the material.

Srivastava, Deepak↗

Risetime distortion of Shuttle Ku-band payload 50 MBPS data due to coaxial cable skin effects

This paper discusses distortion of digital signals generated in the Space Shuttle Ku-band communications systems. Specifically, the degradation considered is due to coaxial cables which interface data and clock from a source located in the payload bay to the KuSPA (Ku-Band Signal Processor Assembly) located in the avionics bay of the Shuttle. Due to the length (nearly 100 feet) and relatively narrow bandwidth of the cable, the clock and data waveforms are significantly affected by this transmission medium. This paper presents a closed form model that closely approximates the distortion of the waveforms measured in laboratory tests.

Schadelbauer, S.↗

Radiation effects control: Eyes, skin

Adverse effects on the lens of the eye and the skin due to exposure to proton radiation during manned space flight were evaluated. Actual proton irradiation which might be encountered in space was simulated. Irradiation regimes included single acute exposures, daily fractionated exposures, and weekly fractionated exposures. Animals were exposed and then maintained and examined periodically until data sufficient to meet the objective were obtained. No significant skin effects were noted and no serious sight impairment was exhibited.

Hightower, D.↗

Effect of skin wettedness on sweat gland response

Investigation of the effect of skin wettedness upon sweating rate. Several techniques were used to gain a better understanding of the quantitative nature of this effect. The results include the finding that the evaporative power of the environment has a profound effect on the relationship between body temperature and sweating rate.

Nadel, E. R.↗

Analyzing The Effect of Skin Postbuckling on General Stresses, Strains and Stability of Composite Structures

The present paper is a final technical report within the NCCW-1-233 research program (dated June 1, 1997) accomplished as a part of co-operation between United States' NASA and Russia's Goskomoboronprom in aeronautics, and continues similar NCCW-73 and NCC-1-233 programs accomplished in 1996 and 1997, respectively. The report concludes studies in two domains, "Analyzing the effect of skin postbuckling on general stresses and strains in a composite structure" and "Evaluating the effect of skin postbuckling behavior on general stability of a composite structure"; the work was fulfilled in compliance with NCC-1-233 requirements (as of June 1, 1997). Also, the present studies may be regarded as a partial generalization of efforts in [1, 2] conducted within the above programs in what concerns postbuckling behavior of composite structures.

Zamula, G. N.↗

Wall mass transfer and pressure gradient effects on turbulent skin friction

The effects of mass injection and pressure gradients on the drag of surfaces were studied theoretically with the aid of boundary-layer and Navier-Stokes codes. The present investigation is concerned with the effects of spatially varying the injection in the case of flat-plate drag. Effects of suction and injection on wavy wall surfaces are also explored. Calculations were performed for 1.2 m long surfaces, one flat and the other sinusoidal with a wavelength of 30.5 cm. Attention is given to the study of the effect of various spatial blowing variations on flat-plate skin friction reduction, local skin friction coefficient calculated by finite difference boundary-layer code and Navier-Stokes code, and the effect of phase-shifting sinusoidal mass transfer on the drag of a sinusoidal surface.

Watson, R. D.↗

Design and fabrication of an aeroelastic flap element for a Short TakeOff and Landing (STOL) aircraft model

A flap element typifying a third element in the flap system of a short takeoff and landing aircraft was designed, fabricated, and instrumented. It was delivered to NASA for flight-simulated testing. The flap element was aluminum skin-stringer-rib construction with adhesive laminated skins. The tests conducted were as follows: (1) sonic check, (2) thermal expansion, (3) end fitting stiffness, (4) material properties, (5) maximum bending stress in the skin, and (6) effective skin width and stringer spacing.

Belleman, G. W.↗

Satellite and Skin Layer Effects on the Accuracy of Sea Surface Temperature Measurements from the GOES Satellites

The latest Geostationary Operational Environmental Satellites (GOES) have facilitated significant improvements in our ability to measure sea surface temperature (SST) from geostationary satellites. Nonetheless, difficulties associated with sensor calibration and oceanic near-surface temperature gradients affect the accuracy of the measurements and our ability to estimate and interpret the diurnal cycle of the bulk SST. Overall, measurements of SST from the GOES Imagers on the GOES 8-10 satellites are shown to have very small bias (less than 0.02 K) and rms differences of between 0.6 and 0.9 K relative to buoy observations. Separate consideration of individual measurement times, however, demonstrates systematic bias variations of over 0.6 K with measurement hour. These bias variations significantly affect both the amplitude and shape of estimates of the diurnal SST cycle. Modeled estimates of the temperature difference across the oceanic cool skin and diurnal thermocline show that bias variations up to 0.3 K can result from variability in the near-surface layer. Oceanic near-surface layer and known "satellite midnight" calibration effects, however, explain only a portion of the observed bias variations, suggesting other possible calibration concerns. Methods of explicitly incorporating skin layer and diurnal thermocline effects in satellite bulk SST measurements were explored in an effort to further improve the measurement accuracy. While the approaches contain more complete physics, they do not yet significantly improve the accuracy of bulk SST measurements due to remaining uncertainties in the temperature difference across the near-surface layer.

Wick, Gary A.↗

Modeling of electrically thick materials theoretical and experimental aspects

The shielding effectiveness of modern aircraft depends upon the nature and the electromagnetic properties of the materials used. It was shown that thin materials are modeled well by a sheet surface impedance. Unfortunately, this formalism fails in the high frequency domain (when skin effect occurs) and when the materials are physically thick. The purpose is to propose a general formalism that renders the skin effect and can be used with multilayered samples. These electrically thick materials are studied using symmetrical boundary conditions applied to tangential fields. The domain of validity of the method is discussed and experimental validations are presented.

Gobin, V.↗

Correlation of AH-1G helicopter flight vibration data and tailboom static test data with NASTRAN analytical results

Level flight airframe vibration at main rotor excitation frequencies was calculated. A NASTRAN tailboom analysis was compared with test data for evaluation of methods used to determine effective skin in a semimonocoque sheet-stringer structure. The flight vibration correlation involved comparison of level flight vibration for two helicopter configurations: clean wing, at light gross weight and wing stores at heavy gross weight. In the tailboom correlation, deflections and internal loads were compared using static test data and a NASTRAN analysis. An iterative procedure was used to determine the amount of effective skin of buckled panels under compression load.

Cronkhite, J. D.↗

Investigation of the three-dimensional turbulent flow downstream of swept slot injection in hypersonic flow

Results of an experimental and numerical investigation of tangential swept slot injection (sweep angles of 22.5 and 45 deg) into a thick turbulent boundary layer at Mach 6 are presented. Film cooling effectiveness, skin friction, and flow structure downstream of the swept slot injection are investigated. The data are compared to that for unswept slots, and it is found that cooling effectiveness and skin-friction reductions are not significantly affected by sweeping the slot. Predictions of cooling effectiveness and skin friction obtained by a numerical finite-difference technique agree reasonably well with experimental surface variables. As in previous supersonic two-dimensional slot research, reduced mixing was found downstream of the slot lip in the present three-dimensional case.

Hefner, J. N.↗

Improved TWTs for electronic countermeasure application

Some efforts in the development of a multistage depressed collector (MSDC) are reviewed. The MSDC is to operate in an electronic countermeasure system (ECM) with minimum overall efficiency in the range 35 to 50%. The effects of interception, harmonic output, and skin effect losses on the design of high-efficiency tubes with a MSDC are briefly discussed. Future experimental work will attempt to put a multistage depressed collector on a 400-watt CW 4.8 to 9.6-GHz helix TWT. By using a unique valve assembly, different collector configurations can be tested while maintaining the circuit under vacuum. The work will determine the sensitivity of overall tube efficiency to the number of collector, length of the collector, aperture size, and plate angle.

Laycock, D. E.↗

Downstream influence of swept slot injection in hypersonic turbulent flow

Results of an experimental and numerical investigation of tangential swept slot injection into a thick turbulent boundary layer at Mach 6 are presented. Film cooling effectiveness, skin friction, and flow structure downstream of the swept slot injection were investigated. The data were compared with that for unswept slots, and it was found that cooling effectiveness and skin friction reductions are not significantly affected by sweeping the slot.

Hefner, J. N.↗

Distribution system simulator

In a series of tests performed under the Department of Energy auspices, power line carrier propagation was observed to be anomalous under certain circumstances. To investigate the cause, a distribution system simulator was constructed. The simulator was a physical simulator that accurately represented the distribution system from below power frequency to above 50 kHz. Effects such as phase-to-phase coupling and skin effect were modeled. Construction details of the simulator, and experimental results from its use are presented.

Bahrami, K. A.↗

Intelligent Image Analysis for Image-Guided Laser Hair Removal and Skin Therapy

We present the development of advanced automatic target recognition (ATR) algorithms for the hair follicles identification in digital skin images to accurately direct the laser beam to remove the hair. The ATR system first performs a wavelet filtering to enhance the contrast of the hair features in the image. The system then extracts the unique features of the targets and sends the features to an Adaboost based classifier for training and recognition operations. The ATR system automatically classifies the hair, moles, or other skin lesion and provides the accurate coordinates of the intended hair follicle locations. The coordinates can be used to guide a scanning laser to focus energy only on the hair follicles. The intended benefit would be to protect the skin from unwanted laser exposure and to provide more effective skin therapy.

laser hair removal↗

Radiometric Stability in 16 years of AIRS Hyperspectral Infrared Data (SPIE OP-431-20)

With global warming at the rate of 10 mK/yr, it is important to at least characterize any trend in the AIRS data, which may impact the use of AIRS data for climate change research. We evaluated the stability of the AIRS v5 calibration for seven atmospheric window channels between 2002 and 2018 under tropical ocean clear conditions. Trends for the channels between 961, 1128 and 1231 cm-1 channels are typically +3 mK/yr; for 790 and 901 cm-1 the trend is 6 mK/yr, i.e. the observations are increasingly getting warmer than expected. The trends are day/night consistent. The trend for the 2508 and 2616 cm-1 channels is close to 10 mK/yr at night, but closer to 6 mK/yr during the day. On an absolute scale these trends are small, but not when viewed in the context of global warming at a 10 mK/yr rate. While the warming trends are consistent with increased scattering from the scan mirrors, which create an error in reading the Onboard Blackbody Calibration, the resulting changes in the gain are a factor of about five larger than observed changes in the gain. The effects of scattering due to scan mirror contamination are evident at extremely cold temperatures, but scattering does not produce the observed warming at warm temperatures. It is possible that much of the observed warming in the AIRS window channels is a geophysical effect related to the warming of the oceans, resulting in a shift in the diurnal cycle and skin effect correction. This requires more careful evaluation.

Manning, Evan M.↗