SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
In this paper, a VLSI Reed-Solomon (RS) decoder architecture for concatenate-coded space and spread spectrum communications, is presented. The known decoding procedures for RS codes are exploited and modified to obtain a repetitive and recursive decoding technique which is suitable for VLSI implementation and pipeline processing.
This development has resulted in a fast lock-up, 8-MHz bandwidth, 8-KHz data rate, spread spectrum communication link breadboard that is implemented using surface wave devices as the primary signal generators and signal processing elements. It uses surface wave tapped delay lines (SWTDL's) in the transmitter to generate the signals and in the receiver to match filter detect them. The system also incorporates a re-entry delay line (circulating integrator) which increases the effective code length per data bit by eight-fold.
A fast lock-up, 8-MHz bandwidth 8,000 bit per second data rate spread spectrum communication link breadboard is described that is implemented using surface wave devices as the primary signal generators and signal processing elements. It uses surface wave tapped delay lines in the transmitter to generate the signals and in the receiver to detect them. The breadboard provides a measured processing gain for Gaussian noise of 31.5 dB which is within one dB of the theoretical optimum. This development demonstrates that spread spectrum receivers implemented with surface wave devices have sensitivities and complexities comparable to those of serial correlation receivers, but synchronization search times which are two to three orders of magnitude smaller.
The design and operation of spread-spectrum (SS) communication systems are examined in an introductory text intended for graduate engineering students and practicing engineers. Chapters are devoted to an overview of SS systems, the historical origins of SS, basic concepts and system models, antijam communication systems, pseudonoise generators, coherent direct-sequence systems, noncoherent frequency-hopped systems, coherent and differentially coherent modulation techniques, pseudonoise acquisition and tracking in direct-sequence receivers, time and frequency synchronization of frequency-hopped receivers, low-probability-of-intercept communication, and multiple-access communication. Graphs, diagrams, and photographs are provided.
During 1978 and 1979, an Air Force C-135 test aircraft was flown to various locations in the North and South Atlantic and Pacific Oceans for satellite communications experiments. A part of the equipment tested on the aircraft was the SEACOM spread spectrum modem. The SEACOM modem operated at X band frequency from the aircraft via the DSCS II satellite to a ground station. For data to be phased successfully, it was necessary to maintain independent time and frequency accuracy over relatively long periods of time (up to two weeks) on the aircraft and at the ground station. To achieve this goal, two Efratom atomic frequency standards were used. The performance of these frequency standards as used in the spread spectrum modem is discussed, including the effects of high relative velocity, synchronization and the effects of the frequency standards on data performance is discussed. The aircraft environment, which includes extremes of temperature, as well as long periods of shutdown followed by rapid warmup requirements, is also discussed.
Existing high-frequency (HF) radio platforms offer robust performance against the volatile HF propagation channel. However, the growing traffic across the band contests the reliability of these systems. While techniques to mitigate the effects of narrowband interference have been thoroughly explored, they are insufficient against wideband interference or when the transmission band is occupied by numerous scattered users. To improve reliability in these congested channel conditions, we propose a filter-bank based multicarrier spread-spectrum waveform with noncontiguous subcarrier bands. Using noncontiguous subcarrier bands enables the system to at once leverage the robustness of a wideband system while retaining the frequency agility of a narrowband system. In this study, we modify a filter-bank transmitter structure to accommodate noncontiguous subcarrier bands and consider several immediate impacts of this change, such as elevated peak-to-average-power ratios (PAPRs). A receiver architecture to process the noncontiguous spread-spectrum signal is also introduced, along with details regarding wideband channel estimation. Finally, we develop efficient transmitter and receiver structures to support practical system implementations. We conclude by comparing the performance of contiguous and noncontiguous systems through both simulation and over-the-air testing. The results show that the noncontiguous system remains robust in typical HF channels while significantly outperforming the contiguous system in congested spectral conditions.
A communication system which would effect channel coding for frequency-hopped multiple-access is described. It is shown that in theory coding can increase the spectrum utilization efficiency of a system with mutual interference to 100 percent. Various coding strategies are discussed and some initial comparisons are given. Some of the problems associated with implementing the type of system described here are discussed.
The spread spectrum technique is attractive for application to mobile satellite communications, because of its random access capability, immunity to inter-system interference, and robustness to overloading. A novel direct sequence spread spectrum communication equipment is developed for land mobile satellite applications. The equipment is developed based on a matched filter technique to improve the initial acquisition performance. The data rate is 2.4 kilobits per sec. and the PN clock rate is 2.4552 mega-Hz. This equipment also has a function of measuring the multipath delay profile of land mobile satellite channel, making use of a correlation property of a PN code. This paper gives an outline of the equipment and the field test results with ETS-V satellite.
This paper will present some preliminary results from a propagation experiment which employed NASA's TDRSS and an 8 MHz chip rate spread spectrum signal. Channel fade statistics were measured and analyzed in 21 representative geographical locations covering urban/suburban, open plain, and forested areas. Cumulative distribution Functions (CDF's) of 12 individual locations are presented and classified based on location. Representative CDF's from each of these three types of terrain are summarized. These results are discussed, and the fade depths exceeded 10 percent of the time in three types of environments are tabulated. The spread spectrum fade statistics for tree-lined roads are compared with the Empirical Roadside Shadowing Model.
This work involves the analysis of a communication system that uses the NASA Tracking and Data Relay Satellite/Space Network (TDRSS/SN) to provide range safety and flight termination system support for expendable launch vehicles and the space shuttle. We examined the high-alphabet scheme for flight termination, and considered an analogous digital system. We also considered the bit-rate needed for a flight termination system using the TDRSS system based on the received signal-to-noise ratio, and link margin. We found that a TDRSS spread-spectrum communication system operating in the vicinity of 150 bits/second could satisfy the requirements for flight termination.
This work involves the analysis of a communication system that uses the NASA Tracking and Data Relay Satellite/space Network (TDRSS/SN) to provide range safety and flight termination system support for expendable launch vehicles and the space shuttle. We examined the high-alphabet scheme for flight termination, and considered an analogous digital system. We also considered the bit-rate needed for a flight termination system using the TDRSS system based on the received signal-to-noise ratio, and link margin. We found that a TDRSS spread-spectrum communication system operating in the vicinity of 150 bits/second could satisfy the requirements for flight termination.
Design information and test results for a breadboard implementation of a digital matched filter for PN sequences are reported. The device is intended to expedite acquisition in PN spread-spectrum communication systems.
A hardware simulation which emulates an automatically acquiring transmit receive spread spectrum communication and tracking system and developed for use in future NASA programs involving digital communications is considered. The system architecture and tradeoff analysis that led to the selection of the system to be simulated is presented.
In a spread-spectrum communication system, a data sequence of +1's and -1's is expanded into a sequence of +x's (bottom bar) and -x's (bottom bar) where x (bottom bar) is a length n sequence of +1's and -1's. A sub-baud code is the assignment of a different such baud sequence to each of M users with the objective of reducing interference between users. It is shown that this interference can be described in terms of the even and odd correlation functions between pairs of sequences. A technique for deriving sub-baud codes from cyclic error-correcting codes is given, and a theorem proved which bounds the quality of the resultant code. A specific such cyclic code construction procedure is given which, for any M, yields a sub-baud code for which the mutual interference can be made arbitrarily small by choosing n sufficiently large.
A relationship between coarse acquisition (coarse alignment of two pseudonoise codes to within approximately one code symbol) and fine acquisition (tracking) in a pseudonoise modulated spread spectrum communication system is studied. A convenient technique for determining mean acquisition time and hold-in time (mean time to lose lock) after acquisition, using a delay lock loop, is elaborated. An analysis procedure for handling the transition from search to lock is developed and applied to a problem containing representative Space Shuttle data (signal parameters and synchronizer parameters).
This paper investigates several key questions concerning the mechanization and design of a Costas receiver for reconstruction of a carrier from a suppressed carrier signal. For baseband NRZ encoded data symbols and a soft bandpass limiter preceding the loop, several design issues which are considered herein and which affect acquisition and tracking performance are: (1) The choice of an IF bandwidth. (2) The optimum choice of the Costas arm filter bandwidths as well as the spectral roll-off characteristics. (3) The optimum choice of loop bandwidth to data rate ratio for a given signal-to-noise ratio. (4) The signal suppression factor and the combined limiter-squaring loss. (5) The variations in loop bandwidth and damping with signal level. (6) The choice of the limiter transfer characteristic. (7) Performance degradation due to the presence of a limiter. Various new results in system design are presented and typical numerical results are given and graphically demonstrated in SNR regions of practical interest. The theory is applicable to the design of carrier reconstruction loops required in the implementation of spread spectrum communication receivers.
Recent applications have developed for spread spectrum communications, hardware data transfer, high rate digital systems, etc. that use channels for which errors tend to occur in short bursts in addition to those at random, i.e., compound channels. Viterbi decoding algorithms are generally very good for random error channels but are not as efficient for burst errors or for compound channels. This paper presents the results of a computer simulation study of the performance of various Viterbi decoders when receiving data corrupted with burst and random errors on the same channel. Simulations were performed using hard-decision CPSK.
New good (K, 1/N) convolutional codes for 8 or = to K or = to 13 and 2 or = to N or = to 8 were found and tabulated which require minimum signal-to-noise ratio (SNR) for given desired bit error rates (BER) with Viterbi decoding. The transfer function bound was used for the BER evaluations. These low-rate codes are expected to have a number of applications, especially for systems having large bandwidth-bit time products such as deep space and spread spectrum communication systems.