Search NASA⌕ Search

SEARCH · Search NASA

Results for “steerable”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2019

Use of a steerable needle for CT-guided nerve plexus blockade

Purpose: Demonstrate the use of a new steerable needle for CT-guided neural plexus blockade to avoid traversing the kidneys. Materials and methods: Retrospective evaluation of 23 consecutive CT-guided neural plexus blockade procedures in which a new steerable needle was used in the last 13 and compared with the prior 10 procedures in which a standard needle was used. Results: Use of the steerable needle was beneficial to reach the target area without traversing a kidney or other organs in 6/13 (46%) procedures; in the other 7 procedures there was no benefit. A kidney was traversed in 0/13 procedures performed with the steerable needle. In contrast, a kidney was traversed in 4/10 (40%) procedures using a standard needle (P = 0.02). There was no significant difference in clinical benefit (P = 1.00) or complications (P = 0.56) between procedures using the steerable needle versus a standard needle. Three complications were observed (1 major and 2 minor) felt to be related to the injection and not the needle type. Conclusions: The utility of a steerable 21-gauge needle during neural plexus blockades was found to allow for avoidance of the kidneys when compared to a standard (non-steerable) needle. Interventional radiologists may find this needle and its future iterations useful for neural blockades, as well as other procedures, when intervening structures need to be avoided. Level of evidence: Level 3, Non-randomized controlled cohort.

62 RADIOLOGY AND NUCLEAR MEDICINE↗
NASA NTRS1983

Full versus limited versus no steerability

The range of phenomena of the MST radar technique to divide the steerability versus nonsteerability problem into two broad with a third subset that lies between these two limits are studied. Processes that vary on a horizontal scale which are comparable to the area of the probing radar beam can best be fully steerable beams. The use of fixed beam systems would be a long term study of the mean wind field. Orographic effects due to mountain ridges and/or land-sea interfaces demand steerable beams, particularly if the effects are three dimensional in character. In view of their lack of moving parts fixed beam systems are more reliable. It is assumed that the reliability of a system is inversely proportioned to the number of moving parts. This is not a problem for fixed beam systems.

Balsley, B. B.↗
NASA NTRS1982

Low gain and steerable vehicle antennas for communications with land mobile satellite

Current development activities at JPL for ground mobile vehicle antennas to be used with the Land Mobile Satellite Service (LMSS) system are described. Both low gain and electronically steerable high gain type antennas are discussed in terms of their design concept and RF performance. For the low gain type, three classes of antennas are under various stages of development. These are the crossed-drooping dipole, quadrifilar helix, and microstrip patch designs. The antennas are intended to provide circularly-polarized radiation with a minimum of 3-dB gain in the angular region from 19 degrees to 60 deg from the horizon in elevation plane and with an omnidirectional pattern in azimuthal plane. For the electronically steerable high gain type, circularly-polarized microstrip patch phased arrays formed on a planar surface and on the surface of a truncated cone are under study. The arrays are intended to provide a minimum of 12 dB gain in the same angular region in elevation plane at all azimuthal angles. This coverage is accomplished by scanning the high gain pencil beam in both elevation and azimuthal directions. Both types of antennas are to transmit at 821-831 MHz band and to receive at 866-876 MHz band. They must be of low cost design and reasonably conformal to the vehicle.

Woo, K.↗
NASA NTRS1986

A steerable radiator for spacecraft application

Future large space structures such as the Space Station will have high dissipation and long life requirements which dictate the requirements for steerable radiators. Several rotary coupling concepts were considered to accomplish heat transport across the steerable radiator system's rotating interface. Rotary fluid couplings were chosen over rotary contact couplings or flexible lines because of low temperature gradients and operational flexibility. A rotary fluid coupling has been designed for use on initial operating capability (IOC) and growth Space Station. Its internal seals have been demonstrated to a 10 year life with minimal (0.055 lbm NH3/year) leakage between internal passages. Materials compatibility tests have been conducted to demonstrate compatibility with ammonia. A seal leakage management system has been designed to: (1) monitor pressures between the internal seals, (2) remove leakage, and (3) store the leakage fluid in a reservoir.

Heizer, B. L.↗
NASA NTRS1990

An Optimal Design For Steerable Dish Antenna With BWG

New design proposed for highly-efficient 34-m-diameter millimeter-wavelength antennas of NASA's Deep Space Network. Incorporates axial beam waveguide, BWG, and improved structure to maintain shape and alignment of reflecting surfaces. General approach to conceptual construction of structure to modularize overall system so critical constraint conditions pertaining to microwave optics and structural performance satisfied. Design retrofitted to existing NASA Deep Space Network 34-m antennas, or used as basis to build large ground-based steerable antennas. Engineering concepts involved in design adapted to design of other large, steerable antennas for telecommunications, radio astronomy, and military uses.

Chuang, K. L.↗
NASA NTRS1965

The Goonhilly 85-ft. steerable dish aerial

The choice of the basic type of aerial for a satellite communication ground station is of major importance in view of its influence on the overall performance, cost and time to complete the installation. In the case of the Post Office satellite communication earth station at Goonhilly Downs, Cornwall, a decision was made early in 1961 to use an 85-ft diameter steerable paraboloidal dish aerial, without a radome for tests with the Telstar and Relay, and other communication satellites. Tests with smaller paraboloidal dish aerials with the feed in the aperture plane had shown that a satisfactory electrical performance could be obtained, and experience with the 250-ft diameter radio telescope at Jodrell Bank had shown that the mechanical problems could be overcome. An important factor in the present case was the limited time--less than one year--available for the design, manufacture, construction and testing of the aerial.

COMMUNICATIONS SATELLITE↗
DOE OSTI2025

Real-time steerable frequency-stepped Doppler backscattering (DBS) system for local helicon wave electric field measurements on the DIII-D tokamak

A new frequency-stepped Doppler backscattering (DBS) system has been integrated into a real-time steerable electron cyclotron heating launcher system to simultaneously probe local background turbulence (f < 10 MHz) and high-frequency (20–550 MHz) density fluctuations in the DIII-D tokamak. The launcher allows for 2D steering (horizontally and vertically) over wide angular ranges to optimize probe location and wavenumber response. The vertical steering can be optimized during a discharge in real time. The new DBS system employs a programmable frequency synthesizer with adjustable dwell time as a source to launch either O or X-mode polarized millimeter waves. This system can step in real-time over the entire E-band frequency range (60–90 GHz). This combination of capabilities allows for the diagnosis of the complex internal spatial structure of high power (>200 kW) helicon waves (476 MHz) injected from an external antenna during helicon current drive experiments in DIII-D. Broadband density fluctuations around the helicon frequency are observed during real-time scans of measurement location and wavenumber during these experiments. Analysis indicates that these broadband high-frequency fluctuations are a result of backscattering of the DBS millimeter-wave probe beam from plasma turbulence modulated by the helicon wave. It is observed that background turbulence is effectively locally “tagged” with the helicon wave electric field, forming images of the turbulent spectrum in the overall density fluctuation spectrum that appear as high-frequency sidebands of the turbulence. These observations of background turbulence and high-frequency fluctuations open up the possibility of monitoring local helicon wave amplitude by comparing the high-frequency signal amplitude to the simultaneously measured background turbulence. In combination with the real-time measurement location and wavenumber scanning capabilities (offered by real-time frequency-stepping and steering), this allows rapid determination of the spatial distribution of the helicon wave power during steady-state plasma operation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Second Target Station Project (STS) Steerable Optic Design & Testing Report

Multiple neutron scattering instrument concepts for the Spallation Neutron Source's Second Target Station (STS) incorporate advanced neutron optic designs which incorporate discrete mirrors rather than continuous neutron guides that were the standard for instruments in the First Target Station. These mirrors can be a few to several meters in length and must be stably supported and aligned as a single optic. In addition, due to the length of the STS instruments and the small size of the STS neutron beams, installation and alignment at the micron level of precision will be required, which is beyond the ability of today's survey & alignment technology. Thus, a means of remotely adjusting these mirrors with single digit micron resolution is needed. A Steerable Optic System was designed to provide the precision and resolution required to support and manipulate these large, heavy optics under beamline shielding. A mockup was developed to demonstrate and validate this system for use in neutron optic applications, and this document describes the design and testing results of that mockup.

43 PARTICLE ACCELERATORS↗
DOE OSTI2023

Analysis of Rotary Steerable Systems versus Conventional Mud Motors for Vertical and Horizontal Wells in the Caney Formation, Southwest Oklahoma

Rotary steerable systems (RSS) have transformed directional drilling over the years and are becoming widely accepted throughout the world. RSS technology has been proven to provide the required strength and agility in challenging and abrasive environments as well as provide a higher rate of penetration (ROP) by allowing more weight transfer to the bit. Due to the higher price of RSS, some companies have stayed loyal to the conventional bent housing (CBH) with a performance drilling motor, regardless of the RSS benefits. This paper examines the performance and cost benefits of standalone RSS (SA-RSS), motor driven RSS (MD-RSS), and CBH systems. Three wells drilled in the Caney formation in Southwestern Oklahoma were selected for the analysis. Results showed that using RSS in the 12.25” intermediate vertical section and the 8.75”/8.5” lateral section was more cost effective than a CBH system. The cost per foot for the CBH was 1.6 to 2.3 times higher than RSS in the vertical section and 1.7 times higher in the lateral section. The RSS ROP was 2.3 to 4.8 times faster than CBH in the vertical section and 1.6 times faster in the lateral section.

Hayes, John↗