Search NASASearch

SEARCH · Search NASA

Results for “superhot”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

An extended superhot solar flare X-ray source

A superhot hard X-ray source in a solar flare occulted by the solar limb was identified. Its hard X-ray image was found to show great horizontal extent but little vertical extent. An H alpha brightening at the same limb position about an hour later suggests a multi-component loop prominence system, so that it appears that a superhot source can evolve in the same manner as a normal solar soft X-ray source. The assignment of plausiable values to physical parameters in the source suggests (from the simplest form of classical thermal-conduction theory) that either new physics will be required to suppress conduction, or else that gradual energy release well after the impulsive phase of the flare must occur. In this respect too, the superhot source appears to resemble ordinary soft X-ray sources, except of course that its temperature is higher.

Hudson, H. S.

Comparison of hard X-ray spectra obtained by spectrometers on Hinotori and SMM and detection of 'superhot' component

Hard X-ray spectra in solar flares obtained by the broadband spectrometers aboard Hinotori and SMM are compared. Within the uncertainty brought about by assuming the typical energy of the background X-rays, spectra by the Hinotori spectrometer are usually consistent with those by the SMM spectrometer for flares in 1981. On the contrary, flares in 1982 persistently show 20-50-percent higher flux by Hinotori than by SMM. If this discrepancy is entirely attributable to errors in the calibration of energy ranges, the errors would be about 10 percent. Despite such a discrepancy in absolute flux, in the the decay phase of one flare, spectra revealed a hard X-ray component (probably a 'superhot' component) that could be explained neither by emission from a plasma at about 2 x 10 to the 7th K nor by a nonthermal power-law component. Imaging observations during this period show hard X-ray emission nearly cospatial with soft X-ray emission, in contrast with earlier times at which hard and soft X-rays come from different places.

Nitta, Nariaki

Is the 'superhot' hard X-ray component in solar flares consistent with a thermal source?

It has been shown by Brown and Emslie (1988) that any optically thin thermal bremsstrahlung source must emit an energy spectrum L(epsilon)(keV/s per keV) which has the property that higher derivatives alternate in sign. In this short note, this test is applied to the 'superhot' component discussed by Lin et al. (1981) in order to determine whether a strictly thermal interpretation of this component is valid. All statistically significant higher derivatives do indeed have the correct sign; this strengthens the identification of this component as due to a thermal source.

Emslie, A. Gordon

The super-hot thermal component in the decay phase of solar flares

Solar X-ray observations from balloons and from the SMM and Hinotori spacecraft have revealed evidence for a superhot thermal component with a temperature of more than about 3 x 10 to the 7th K in many solar flares, in addition to the usual 10-20 x 10 to the 6th K soft X-ray flare plasma. The decay phase of 35 solar flare X-ray events observed by ISEE-3 during 1980 was systematically studied. Based on fits to the continuum X-ray spectrum in the 4.8-14 keV range and to the intensity of the 1.9 A feature of iron lines, it was found that 15 (about 43) of the analyzed events have a superhot thermla component in the decay phase of the flare. In this paper, the important properties of the superhot thermal component in the decay phase are summarized. It is found that an additional input of energy is required to maintain the superhot thermal components. Finally, it is suggested that the superhot thermal component in the decay phase is created through the reconnection of the magnetic field during the decay phase of solar flares.

Lin, H.-A.

The temperature of solar flares determined from X-ray spectral line ratios

The effect on derived solar flare plasma temperatures of (1) a power-law distribution of emission measure as a function of temperature, (2) a high-temperature isothermal source coupled to a low-temperature power-law distribution of emission measure, and (3) two isothermal sources is calculated for line ratios involving the ions S XV, Ca XIX, Ca XX, Fe XXV, Ni XXVII, and Fe XXVI. It is shown that if the Fe XXV temperature is less than about 25 million K, as is true for the majority of flares, then about 75 percent or more of the emission measure is produced by plasma at temperatures equal to or less than the Fe XXV temperature plus about 3 million K. If the Fe XXV temperature is 20 million K or higher, this percentage can be larger. This result is obtained even if a superhot component exists that extends up to several hundred million degrees. Temperatures determined from Fe XXVI demonstrate the presence of a superhot component.

Doschek, G. A.

Methods and first results of plasma non-isothermal parameters measurements in meteor trails

There is no reliable experimental evidence so far of either the presence or absence of nonisothermal effects in newly formed meteor trails. Neither is there a common opinion on the most effective mechanism of electron cooling. According to the laboratory experimental data collisions of atomic and molecular particles of all kinds having velocities of 10 to 70/kms often yields 1 eV electrons and not infrequently some have energies reaching several electron volts. These highest energy electrons are referred to as superhot electrons. The method of measurement and the results of these measurements in meteor trails are discussed.

Kostylev, K. K.

Joule heating and runaway electron acceleration in a solar flare

The hard and soft x ray and microwave emissions from a solar flare (May 14, 1980) were analyzed and interpreted in terms of Joule heating and runaway electron acceleration in one or more current sheets. It is found that all three emissions can be generated with sub-Dreicer electric fields. The soft x ray emitting plasma can only be heated by a single current sheet if the resistivity in the sheet is well above the classical, collisional resistivity of 10(exp 7) K, 10(exp 11)/cu cm plasma. If the hard x ray emission is from thermal electrons, anomalous resistivity or densities exceeding 3 x 10(exp 12)/cu cm are required. If the hard x ray emission is from nonthermal electrons, the emissions can be produced with classical resistivity in the current sheets if the heating rate is approximately 4 times greater than that deduced from the soft x ray data (with a density of 10(exp 10)/cu cm in the soft x ray emitting region), if there are at least 10(exp 4) current sheets, and if the plasma properties in the sheets are characteristic of the superhot plasma observed in some flares by Lin et al., and with Hinotori. Most of the released energy goes directly into bulk heating, rather than accelerated particles.

Holman, Gordon D.

Ceramic composition

Novel transformation toughened ceramic compositions comprising finely divided Zr0 2 -Hf0 2 solid solution particles dispersed in a Al 2 0 3 -Cr 2 0 3 (alumina) or 3Al 2 0 3 .2Si0 2 -3Cr 2 0 3 .2Si0 2 (mullite) solid solution matrix phase. It is found that increased hardness and modulus associated with higher relative Cr 2 0 3 content (e.g. 20 mole % ) in the matrix phase and increased fracture toughness associated with higher relative Hf0 2 content ( e.g. 10 to 20 mole % ) in the disperse phase represent viable and improved ceramic compositions. Such transformation toughened ceramic compositions are considered useful in superhot light diesel engine applications, high temperature gas turbines and ultrahigh temperature ceramic heat exchangers.

Tseng-Ying Tien

Flare fragmentation and type III productivity in the 1980 June 27 flare

Observations of the solar flare on June 27, 1980 were presented, 16:14-16:33 UT, which was observed by a balloon-borne 300 sq cm phoswich hard X-ray detector and by the IKARUS radio spectrometer. This flare shows intense hard X-ray (HXR) emission and an extreme productivity of (at least 754) type III bursts at 200-400 MHz. A linear correlation was found between the type III burst rate and the HXR fluence. The occurrence of about 10 type III bursts/second, and also the even higher rate of millisecond spikes, suggests a high degree of fragmentation in the acceleration region. This high quantization of injected beams, assuming the thick-target model, shows up in a linear relationship between hard X-ray fluence and the type III rate, but not as fine structures in the HXR time profile. The generation of a superhot isothermal HXR component in the decay phase of the flare coincides with the fade-out of type III production.

Aschwanden, M. J.

Stochastic acceleration of electrons. I - Effects of collisions in solar flares

Stochastic acceleration of thermal electrons to nonrelativistic energies is studied under solar flare conditions. We show that, in turbulent regions, electron-whistler wave interactions can result in the acceleration of electrons in times comparable to or shorter than the Coulomb collision time. The kinetic equation describing the evolution of the electron energy distribution including stochastic acceleration by whistlers and energy loss via Coulomb interactions is solved for an initial thermal electron energy spectrum. In general, the shape of the resulting electron distributions are characterized by the energy E(c) where systematic energy gain by turbulence equals energy loss due to Coulomb collisions. For energies less than E(c), the spectra are steep (quasi-thermal) whereas above E(c), the spectra are power laws. We find that hard X-ray spectra computed using the electron distributions obtained from our numerical simulations are able to explain the complex spectral shapes and variations observed in impulsive hard X-ray bursts. In particular, we show that the gradual steepening observed by Lin et al. (1981) could be due to a systematic increase in the density of the plasma (due to evaporation) and the increasing importance of collisions instead of the appearance of a superhot thermal component.

Hamilton, Russell J.

Impulsive behavior in solar soft X-radiation

The Yohkoh soft X-ray telescope has observed impulsive, thermal, soft X-ray emission at the footpoints of magnetic loops during solar flares. The soft X-ray (thermal) time profiles at the footpoints closely match the hard X-ray (nonthermal) time profiles, directly demonstrating the heating of the lower solar atmosphere on short timescales during the interval of nonthermal energy release. This phenomenon is the rule, rather than the exception, occurring in the majority of flares that we have examined with the Yohkoh data. We illustrate the impulsive behavior with data from the major flare of 1992 January 26. For this flare, the soft X-ray peak times matched the hard X-ray peak times within the time resolution of the soft X-ray measurements (about 10 s), and the soft and hard X-ray locations match within the resolution of the hard X-ray imager. The impulsive soft X-ray emission clearly has a thermal spectral signature, but not at the high temperature of a 'superhot' source. We conclude that the impulsive soft X-ray emission comes from material heated by precipitating electrons at loop footpoints and evaporating from the deeper atmosphere into the flaring flux tube.

Hudson, H. S.

Miocrowave spectral imaging, H-alpha and hard X-ray observations of a solar limb flare

We compare the microwave, H-alpha, and hard X-ray observations for a west limb C7.3 flare that occurred at 17:10 UT, 1992 June 26. H-alpha movies were obtained at Big Bear Solar Observatory. Before the onset of the flare, overexposed H-alpha images show the complicated flux loop structure above the limb. Material was observed to descend along the loops toward the site where the flare occurred hours later. Using the five-antenna solar array at Owens Valley Radio Observatory, we obtain two-dimensional maps of flare emission from 1.4 to 14 GHz. In all three temporal peaks of the microwave bursts, the maps show the same characteristics. The peak low-frequency emission comes from the top of one bundle of the H-alpha loops and gradually shifts to the foot-point of the loops (the location of H-alpha flare) as the frequency increases. The location of the emission peak shifts 88 sec between 1 and 14 GHz. Seventy percent of the shift occurs between 1 and 5 GHz. The locus of the shift of the emission peak follows the shape of an H-alpha surge that occurred after the flare. For each point along the locus, we create the microwave brightness temperature spectrum and compare the radio-derived electron distribution with that derived from the high-resolution hard X-ray spectra measured with Burst and Transient Source Experiment (BATSE) on board the Compton Gamma Ray Observatory (CGRO). We find that the peak frequency changes from approximately 3 GHz at the loop top to approximately 7 GHz at the footprint, presumably due to the increase of the magnetic field from approximately 160 GHz at the loop top to approximately 300 G at the footpoint. The high-frequency slope of the microwave power-law spectrum decreases from approximately 10 at the loop top to approximately 5 at the footprint due to a change in the energy distribution of the dominant electrons. The microwave brightness temperature spectral index predicted by the BATSE power-law hard X-ray spectra agrees with the measured value only at the footpoint. At the loop top, the emission may be thermal gyrosynchrotron with a temperature of 3.5 x 10(exp 7) K, which is likely to correspond to the superhot component seen in the hard X-ray emission.

Wang, H.