Search NASA⌕ Search

SEARCH · Search NASA

Results for “variable threshold”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Variable threshold zonal filtering

Variable threshold zonal filtering is an active nonlinear image enhancement technique designed to avoid ringing artifacts which filtering can introduce near sharp brightness transitions in the original scene. The filtering procedure can be implemented in the Fourier domain or by subtractive box filtering. It is shown, in reference to a Landsat scene of Iceland, that while conventional box filtering produces severe ringing, zonal filtering results in a more uniform display of local detail.

Schwartz, A. A.↗
NASA NTRS1970

Research on variable threshold transistor storage systems

A fully integrated, electrically alterable, nonvolatile, nondestructive readout control memory was developed, using as storage elements metal-nitride-silicon variable threshold transistors. An optimum approach to such a memory was developed in which a three dimensional selection technique was used, both for read and write operations. Electrical isolation of writing and memory circuits was obtained by means of separate memory and write circuit chips. This method provided protection from voltage breakdowns, increased circuit flexibility, and greater ease of testing of interim and final circuit elements.

Wegener, H. A. R.↗
NASA NTRS1991

Cloud-screening for Africa using a geographically and seasonally variable infrared threshold

A spatially variable monthly, infrared cloud-threshold data base has been used to screen cloud-contaminated observations from radiances measured by the NOAA-9 AVHRR over Africa. Cloud-screening through a monthly average infrared threshold based on measured surface air temperature, which is geographically dependent, shows an improvement over using a seasonally and geographically independent thermal cloud threshold of 287 K. It is found that differences in cloud-screening for these two thresholds occur for cases of lower altitude clouds or subpixel clouds where the radiative temperature is higher than the 287 K infrared threshold, yet colder than the variable threshold developed by Stowe et al. (1988) for the Nimbus-7 global cloud climatology. The variable IR threshold is shown to be effective over persistently cloud-covered regions, such as the coastal region of the Gulf of Guinea, but may introduce some erroneous cloud identifications over mountains.

Eck, T. F.↗
NASA NTRS1993

Further studies to extend and test the area-time-integral technique applied to satellite data

The principal goal of this project is to establish relationships that would allow application of area-time integral (ATI) calculations based upon satellite data to estimate rainfall volumes. The research has been pursued using two different approaches, which for convenience can be designated as the 'fixed-threshold approach' and the 'variable-threshold approach'. In the former approach, an attempt is made to determine a single temperature threshold in the satellite infrared data that would yield ATI values for identifiable cloud clusters which are most closely related to the corresponding rainfall amounts. Results thus far have indicated that a strong correlation exists between the rain volumes and the satellite ATI values, but the optimum threshold for this relationship seems to differ from one geographic location to another. The difference is probably related to differences in the basic precipitation mechanisms that dominate in the different regions. The average rainfall rate associated with each cloudy pixel is also found to vary across the spectrum of ATI values. Work on the second, or 'variable-threshold', approach for determining the satellite ATI values was essentially suspended during this period due to exhaustion of project funds. Most of the ATI work thus far has dealt with cloud clusters from the Lagrangian or 'floating-target' point of view. For many purposes, however, the Eulerian or 'fixed-target' perspective is more appropriate. For a very large target area encompassing entire cluster life histories, the rain volume-ATI relationship would obviously be the same in either case. The important question for the Eulerian perspective is how small the fixed area can be made while maintaining consistency in that relationship.

Smith, Paul L.↗
NASA NTRS1998

Attitude Estimation Signal Processing: A First Report on Possible Algorithms and Their Utility

In this brief effort, time has been of the essence. The data had to be acquired from APL/Lincoln Labs, stored, and sorted out to obtain the pertinent streams. This has been a significant part of this effort and hardware and software problems have been addressed with the appropriate solutions to accomplish this part of the task. Passed this, some basic and important algorithms are utilized to improve the performance of the attitude estimation systems. These algorithms are an essential part of the signal processing for the attitude estimation problem as they are utilized to reduce the amount of the additive/multiplicative noise that in general may or may not change its structure and probability density function, pdf, in time. These algorithms are not currently utilized in the processing of the data, at least, we are not aware of their use in this attitude estimation problem. Some of these algorithms, like the variable thresholding, are new conjectures, but one would expect that someone somewhere must have utilized this kind of scheme before. The variable thresholding idea is a straightforward scheme to use in case of a slowly varying pdf, or statistical moments of the unwanted random process. The algorithms here are kept simple but yet effective for processing the data and removing the unwanted noise. For the most part, these algorithms can be arranged so that their consecutive and orderly execution would complement the preceding algorithm and improve the overall performance of the signal processing chain.

Riasati, Vahid R.↗
DOE OSTI2020

Leak detection in a subcritical boiler

Thermal power plants experience cycling duty leading to the fatigue of the boiler and heat exchanger tubes. As a result, tube failures occur frequently in coal fired fleets leading to forced outages. Furthermore, because the tube leaks have been the major source of unwanted shutdowns and the number of outages is increasing, present work focuses on the detection and isolation of the leak in a subcritical boiler based upon the process data from a commercial coalfired power plant. The mass balance equation around the steam drum was analyzed using timeseries data collected from a 300 MW power plant. The ratio of the feed water mass flow rate to the steam mass flow rate was defined as a key parameter for detecting leaks. The difference in slope between the feedwater and steam mass flow rate during the normal and faulty operations was established as the upper control limit for real time monitoring. To reduce false alarm rates that arise when raw signal is directly compared against the threshold due to common process fluctuations, an optimal filter was derived for smoothing. It was found that the optimal filter reacted much more quickly to process changes than an exponential moving average filter, around 8 h earlier on average. Occurrence of relatively high false alarm rates even in the filtered responses was related to the cycling of the boiler from the base load condition. Variable threshold was established to keep false alarm rates to the minimum while maintaining the leak detection rate. Finally, the leak was located at the economizer and this could readily be isolated by investigating the magnitude of the mass flow rates ratio and the temperature at the economizer outlet.

42 ENGINEERING↗
NASA NTRS1980

The response of the Seasat and Magsat infrared horizon scanners to cold clouds

Cold clouds over the Earth are shown to be the principal cause of pitch and roll measurement noise in flight data from the infrared horizon scanners onboard Seasat and Magsat. The observed effects of clouds on the fixed threshold horizon detection logic of the Magsat scanner and on the variable threshold detection logic of the Seasat scanner are discussed. National Oceanic and Atmospheric Administration (NOAA) Earth photographs marked with the scanner ground trace clearly confirm the relationship between measurement errors and Earth clouds. A one to one correspondence can be seen between excursion in the pitch and roll data and cloud crossings. The characteristics of the cloud-induced noise are discussed, and the response of the satellite control systems to the cloud errors is described. Changes to the horizon scanner designs that would reduce the effects of clouds are noted.

Bilanow, S.↗
DOE OSTI2022

Effective ZDC cross section derived from Vernier Scans during the RHICf run with polarized protons at 255 GeV in 2017

At RHIC the collision rate per IP is measured by the Zero Degree Calorimeters (ZDC). The collision rate, as measured by the ZDC, corresponds to the rate of mutual forward neutral particles above a variable threshold and within a certain coincidence window. During run 17 the detector was operated for the RHICf experiment in a slightly different configuration from the earlier standard polarized proton run. Due to the different configuration the ZDC detector was calibrated for the rhicf setup by performing a set of dedicated vernier scans. A total of 9 vernier scans were performed. This note presents the data and summarizes the results, i.e. effective ZDC cross section from those scans for the rhicf running period.

43 PARTICLE ACCELERATORS↗
DOE OSTI2022

Study of Radiative Heat Transfer and Flow Physics from Medium-scale Methanol Pool Fire Simulations [Slides]

Analysis of methanol pool fire conducted as part of validation study for SIERRA/Fuego. Radiation model was effectively calibrated by modifying radiation model parameters for methanol. Computing integrated buoyancy flux, entrainment rate, and turbulent kinetic energy allowed for evaluation of less typical quantities in this validation study. Quantities were compared with experimental data or correlations and generally showed agreement. TKE needed fine mesh to be computed accurately. Predicted flame height less sensitive to variations in mixture fraction than temperature. Mixture fraction is a preferable threshold variable for this application.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2020

Quantitative Analysis of the Effects of Natural and Human Factors on a Hydrological System in Zhangweinan Canal Basin

Drought is a water deficit state caused by large-scale climate change that cannot be avoided by a water resource management system. Water scarcity refers to the unsustainable utilization of water resources over a long time, which is the result of water management policies. However, water deficits caused by drought and water scarcity often occur simultaneously and are indistinguishable. This study proposes a model-based simulation framework that can quantitatively distinguish natural factors (drought) from human factors (water scarcity) in a hydrological system. The simulation was applied to the Zhangweinan Canal Basin, based on the runoff sequences from 1950 to 2004. The results show that the runoff curve number, soil depth, soil available water, soil evaporation compensation coefficient, base runoff α coefficient and the maximum canopy interception have the highest sensitivity to runoff, and that the calibrated and validated SWAT model can effectively simulate the runoff process in the Zhangweinan Canal Basin and similar areas. Abrupt changes in human activities in 1975 and water scarcity led to the disappearance of the summer peak runoff period in both wet and dry years. Human factors are the main reason for the change in the hydrological system in the study area; the runoff loss caused by human factors is four times that caused by natural factors according to the proposed variable threshold. This study proposes a model-based simulation framework that can help water resource managers to distinguish the effects of drought and water scarcity in water-stressed areas and adjust management accordingly.

54 ENVIRONMENTAL SCIENCES↗
NASA NTRS1977

Attitude determination system for Seasat-A mission

The attitude determination (AD) system hardware of Seasat-A consists of two sun aspect sensors, two infrared (IR) horizon scanners, related electronics, telemetry, and science sensors. The earth horizon pulse signal sensing is accomplished by a variable thresholding method intended to self-adjust for earth radiance variations. The use of sun sensors rather than star trackers for yaw determination calls for estimation rather than measurement of yaw attitude about 50% of mission time. Features of the yaw interpolation algorithm include adaptability and automatic incorporation of time-varying confidence levels of various data sources. The performance accuracy of the AD system was assessed, where it is found that the most important error source is the variation in earth atmospheric radiance. Analysis of science instrument sensitivity to AD uncertainties was performed, and the most sensitive instrument, the scatterometer system, shows only gradual degradation of performance in the vicinity of the AD accuracy requirement.

Ohtakay, H.↗
NASA NTRS1980

Spin-Down and Active Nutation Controller /SDANC/ for the Galileo project

The Spin-Down and Active Nutation Controller stabilizes the Galileo spacecraft during spin-down from approximately 70 to 1 rpm. Angular motion of the spacecraft is sensed through a pair of accelerometers and a sun sensor which is needed only at low spin rates. Spin and nutation information is derived by a set of 'loosely coupled' spin and transverse rate estimators. Spin rate is reduced by two spin-down thrusters. The transverse angular rate is compared with a variable threshold; exceeding the threshold activates axial thrusters which impart appropriate transverse torque to reduce the nutation. The scheme was verified by extensive computer simulations and has been demonstrated over a wide range of initial conditions.

Lin, H. S.↗
NASA NTRS1980

Polynomial striction algorithms in the detection and determination of the characteristics of non-stationary phenomena

The effectiveness of the algorithm of polynomial striction of the data is examined, and the selection of an algorithm is carried out, according to the results of measurements of the components of the permanent magnetic field in communication sequences from the Venera-9 space vehicle, where the shock waves were recorded. It is shown that the most effective algorithm, according to the coefficient of striction, is the algorithm of the zero order interpolator. Also examined is the increase in effectiveness with the introduction of a variable threshold of comparison. The root-mean-square deviation of the error of regeneration of the data with various thresholds is calculated, and qualitative analysis of the distortions is carried out, having shown a considerable change in the form of the small discontinuities, which may be interpreted as potential interplanetary shock waves.

Yevdokimov, V. P.↗
NASA NTRS1993

GaAs-based optoelectronic neurons

An integrated, optoelectronic, variable thresholding neuron implemented monolithically in GaAs integrated circuit and exhibiting high differential optical gain and low power consumption is presented. Two alternative embodiments each comprise an LED monolithically integrated with a detector and two transistors. One of the transistors is responsive to a bias voltage applied to its gate for varying the threshold of the neuron. One embodiment is implemented as an LED monolithically integrated with a double heterojunction bipolar phototransistor (detector) and two metal semiconductor field effect transistors (MESFET's) on a single GaAs substrate and another embodiment is implemented as an LED monolithically integrated with three MESFET's (one of which is an optical FET detector) on a single GaAs substrate. The first noted embodiment exhibits a differential optical gain of 6 and an optical switching energy of 10 pJ. The second embodiment has a differential optical gain of 80 and an optical switching energy of 38 pJ. Power consumption is 2.4 and 1.8 mW, respectively. Input 'light' power needed to turn on the LED is 2 micro-W and 54 nW, respectively. In both embodiments the detector is in series with a biasing MESFET and saturates the other MESFET upon detecting light above a threshold level. The saturated MESFET turns on the LED. Voltage applied to the biasing MESFET gate controls the threshold.

Lin, Steven H.↗