Engineering topics

Armini, A. J.

Publications and source records attributed to Armini, A. J..

4 records

NASA NTRS1986

Solar-Cell-Junction Processing System

System under development reduces equipment costs. Processing system will produce solar-cell junctions on 4 in. (10.2 cm) round silicon wafers at rate of 10 to seventh power per year. System includes non-mass-analyzed ion implanter, microcomputer-controlled, pulsed-electron-beam annealer, and wafertransport system with vacuum interlock. These features eliminate large, expensive magnet and plates, circuitry, and power source otherwise needed for scanning.

Bunker, S. N.↗

NASA NTRS1982

Non-mass-analyzed ion implantation equipment for high volume solar cell production

Equipment designed for junction formation in silicon solar cells is described. The equipment, designed for a production level of approximately one megawatt per year, consists of an ion implanter and annealer. Low cost is achieved by foregoing the use of mass analysis during the implantation, and by the use of a belt furnace for annealing. Results of process development, machine design and cost analysis are presented.

Armini, A. J.↗

NASA NTRS1981

An automated process sequence using preformed cell contacts and interconnects with a total cost of $0.64 per peak watt in 1986

A process sequence is described which utilizes a preformed metal mesh electrostatically bonded to each cell to provide the front contact. Cells of 12 percent AM1 efficiency have been produced using this scheme. This method also permits access to both contacts on the cell from the back side. In addition, low cost cell interconnection is accomplished using a flexible 'printed circuit' sheet which is ultrasonically bonded to the cell contacts. The complete process sequence as well as automated equipment which also uses ion implantation and pulse annealing is described. The total cost for module fabrication is estimated at $0.64 per peak watt for a 30 MW/year plant.

Armini, A. J.↗

NASA NTRS1981

Apparatus and technique for pulsed electron beam annealing for solar cell production

Many of the demands of high-throughput processing of solar cells can be satisfied by transient methods using pulsed electron beams. A prototype pulsed electron beam processor for solar cell production has been built, and is intended for automated annealing of solar cell junction ion implantation at a rate of 1200-1800 silicon wafers per hour. Other applications include solar cell junctions by pulse diffusion, annealing of ion-implanted back surface fields, and pulse sintering of cell metallization.

Landis, G. A.↗