Engineering topics

Bailey, Trevor P.

Publications and source records attributed to Bailey, Trevor P..

24 records · Page 2

DOE OSTI2020

Ultralow thermal conductivity in diamondoid lattices: high thermoelectric performance in chalcopyrite Cu 0.8+y Ag 0.2 In 1–y Te 2

Because of its unique transport properties, CuInTe 2 has been considered as a promising p-type material for thermoelectric applications. However, its diamondoid structure gives it a high intrinsic lattice thermal conductivity that greatly limits its thermoelectric performance. In this study, we demonstrate that Ag alloying gives rise to an extremely low lattice thermal conductivity of 0.47 W m –1 K –1 for Cu 0.8 Ag 0.2 InTe 2 at 850 K. Moreover, we found Cu doping significantly improves the carrier mobility while simultaneously increasing the carrier concentraton. As a result, the power factor of Cu 0.8 Ag 0.2 InTe 2 increases and a maximum ZT of ~1.6 is achieved at 850 K. Both DFT calculations and low temperature heat capacity measurements suggest a strong interaction between low frequency optical phonons and heat carrying acoustic phonons, which is derived from the weak Ag–Te bonding. Here, this strong phonon coupling decreases the Debye temperature and induces a low sound velocity.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Ultrafine Interwoven Dendritic Cu 2 Se/CuFeSe 2 Composites with Enhanced Thermoelectric Performance

As an effort to develop high-performance and stable copper chalcogenide thermoelectrics, several (1-x)Cu 2 Se/(x)CuFeSe 2 composites were successfully synthesized via a one-step solid-state transformation of CuSe 2 template. Uniform ultrafine dendritic structures consisting of interweaving Cu 2 Se and CuFeSe 2 nanofibers were observed in samples with low Fe content (0.05 ≤ x ≤ 0.1). Increasing the Fe content to x = 0.5 led to phase segregation into Cu 2 Se-rich region with embedded CuFeSe 2 fine structures interwoven with CuFeSe 2 -rich region containing Cu 2 Se nanofibers. The formation of such an entwined dendritic structure is believed to arise from the temperature-dependent solubility of CuFeSe 2 in the Cu 2 Se matrix. The dynamic dissolution of CuFeSe 2 into the Cu 2 Se at high temperatures leads to temperature-dependent doping of the Cu 2 Se matrix, enabling drastic enhancements of thermoelectric power factor at high temperatures. As a result, such a strategy is expected to be a powerful tool for properties modulation in thermoelectric materials.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Contrasting SnTe–NaSbTe 2 and SnTe–NaBiTe 2 Thermoelectric Alloys: High Performance Facilitated by Increased Cation Vacancies and Lattice Softening

Defect chemistry is critical to designing high performance thermoelectric materials. In SnTe, the naturally large density of cation vacancies results in excessive hole doping and frustrates the ability to control the thermoelectric properties. Yet, recent work also associates the vacancies with suppressed sound velocities and low lattice thermal conductivity, underscoring the need to understand the interplay between alloying, vacancies, and the transport properties of SnTe. Here, we report solid solutions of SnTe with NaSbTe 2 and NaBiTe 2 (NaSn m SbTe m +2 and NaSn m BiTe m +2 , respectively) and focus on the impact of the ternary alloys on the cation vacancies and thermoelectric properties. We find introduction of NaSbTe 2 , but not NaBiTe 2 , into SnTe nearly doubles the natural concentration of Sn vacancies. Furthermore, DFT calculations suggest that both NaSbTe 2 and NaBiTe 2 facilitate valence band convergence and simultaneously narrow the band gap. These effects improve the power factors but also make the alloys more prone to detrimental bipolar diffusion. Indeed, the performance of NaSn m BiTe m +2 is limited by strong bipolar transport and only exhibits modest maximum ZTs ≈ 0.85 at 900 K. In NaSn m SbTe m +2 however, the doubled vacancy concentration raises the charge carrier density and suppresses bipolar diffusion, resulting in superior power factors than those of the Bi-containing analogues. Lastly, NaSbTe 2 incorporation lowers the sound velocity of SnTe to give glasslike lattice thermal conductivities. Facilitated by the favorable impacts of band convergence, vacancy-augmented hole concentration, and lattice softening, NaSn m SbTe m +2 reaches high ZT ≈ 1.2 at 800–900 K and a competitive average ZT avg of 0.7 over 300–873 K. The difference in ZT between two chemically similar compounds underscores the importance of intrinsic defects in engineering high-performance thermoelectrics.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2020

Nanoscale Engineering of Polymorphism in Cu 2 Se-Based Composites

Crystal polymorphism selection during synthesis is extremely challenging. However, promoting the formation of a specific metastable polymorph enables modulation of the functional properties of phase-change materials through alteration of the relative abundance of various polymorphs. Here, we demonstrate the stabilization of the superionic β-Cu 2 Se phase under ambient conditions and the direct control over the relative ratio between the α-Cu 2 Se and β-Cu 2 Se polymorphs in (x)CuGaSe 2 /(1-x)Cu 2 Se composites using CuGaSe 2 nanoseeds. Here, we found that the small lattice mismatch between β-Cu 2 Se (cubic) and the ab plane of tetragonal CuGaSe 2 nanoseeds promotes the formation of low-energy coherent CuGaSe 2 /β-Cu 2 Se interfaces leading to preferential stabilization of β-Cu 2 Se. Astonishingly, the hierarchical microstructure of the resulting composites enables a remarkable decoupling of charge and heat transport, which is manifested by a breakdown of the Wiedemann-Franz law

36 MATERIALS SCIENCE↗

DOE OSTI2020

Understanding the thermally activated charge transport in NaPb m SbQ m+2 (Q = S, Se, Te) thermoelectrics: weak dielectric screening leads to grain boundary dominated charge carrier scattering

Many thermoelectric materials feature irregular electrical conductivity with thermally activated transport below ~600 K and metallic behavior at high temperatures, despite possessing degenerate carrier concentrations. The suppression of the electrical conductivity ultimately degrades the thermoelectric performance on the cold side and limits the device energy conversion efficiency. As such, establishing the origin of the low temperature scattering and developing strategies to mitigate its effect are paramount issues. To date, the correct microscopic description of the low temperature carrier scattering remains an open issue, and there is little work addressing why some thermoelectric materials are more susceptible to the deleterious behavior. Here, we use the promising thermoelectric alloys of PbQ and NaSbQ 2 (Q = S, Se, Te) as model systems to address these concerns. We directly show the thermally activated transport stems from the scattering of charge carriers by the grain boundaries (GBs), and that the expected metallic electrical conductivity is recovered by preparing large grained samples with reduced densities of GBs. We furthermore study the electrical properties NaPb m SbSe m+2 as a function of NaSbSe 2 fraction, as well as those of the chalcogenide analogues, PbTe–NaSbTe 2 and PbS–NaSbS 2 , and demonstrate that the strength of GB scattering can be understood by utilizing simple chemical principles. By considering the polarizability of the host atoms, we directly relate the magnitude of GB scattering to the relative degree of charge carrier screening in each material, and demonstrate that GB scattering is strongest in the ionic NaSbQ 2 -rich compounds and weakest in more polarizable PbQ-rich phases. We finally show how these chemical arguments elegantly explain the strong GB scattering in numerous other thermoelectric materials. By uniting the deleterious charge transport properties exhibited by many different compounds into a common picture, we discuss how our work gives design principles for proper microstructure engineering in emerging thermoelectric materials.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Anomalously Large Seebeck Coefficient of CuFeS 2 Derives from Large Asymmetry in the Energy Dependence of Carrier Relaxation Time

The Seebeck effect in a material originates from the distribution of asymmetry in the electron transport under a temperature gradient, which has contributions from the energy-dependent electronic density-of-states and carrier mobility. However, because the energy dependence of common electron scattering mechanisms is weak, the mobility-driven Seebeck coefficient has long been ignored in most thermoelectric materials, and the energy asymmetry of the density-of-states has been considered the dominant contribution. In this work, we describe a hopping transport behavior observed in CuFeS 2 , and a large carrier Hall mobility gradient of dμH/dT that creates an unusually large energy-dependent mobility contribution to the Seebeck coefficient. This work offers several ideas regarding the mobility-driven Seebeck effect and its potential utilization in the design of thermoelectric materials.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗