Engineering topics

Becker, F. J.

Publications and source records attributed to Becker, F. J..

4 records

NASA NTRS1980

Bubble memory module

Design, fabrication and test of partially populated prototype recorder using 100 kilobit serial chips is described. Electrical interface, operating modes, and mechanical design of several module configurations are discussed. Fabrication and test of the module demonstrated the practicality of multiplexing resulting in lower power, weight, and volume. This effort resulted in the completion of a module consisting of a fully engineered printed circuit storage board populated with 5 of 8 possible cells and a wire wrapped electronics board. Interface of the module is 16 bits parallel at a maximum of 1.33 megabits per second data rate on either of two interface buses.

Bohning, O. D.↗

NASA NTRS1980

An 8 x 10 to the 5th bit bubble memory cell for spacecraft applications

A multiple chip magnetic bubble memory cell design developed for NASA embodies the low power, low weight, environmental tolerance and reliability necessary for successful operation in spacecraft launch and mission environments. Packaging of multiple chips in a common magnetic bias, drive coil assembly reduces weight and volume overhead per chip and also reduces the number of coil drive components required. This 8 x 10 to the 5th bit cell is conduction cooled and provides a metal and ceramic sealed hermetic chip environment.

Becker, F. J.↗

NASA NTRS1979

The 10 to the 8th power bit solid state spacecraft data recorder

The results are summarized of a program to demonstrate the feasibility of Bubble Domain Memory Technology as a mass memory medium for spacecraft applications. The design, fabrication and test of a partially populated 10 to the 8th power Bit Data Recorder using 100 Kbit serial bubble memory chips is described. Design tradeoffs, design approach and performance are discussed. This effort resulted in a 10 to the 8th power bit recorder with a volume of 858.6 cu in and a weight of 47.2 pounds. The recorder is plug reconfigurable, having the capability of operating as one, two or four independent serial channel recorders or as a single sixteen bit byte parallel input recorder. Data rates up to 1.2 Mb/s in a serial mode and 2.4 Mb/s in a parallel mode may be supported. Fabrication and test of the recorder demonstrated the basic feasibility of Bubble Domain Memory technology for such applications. Test results indicate the need for improvement in memory element operating temperature range and detector performance.

Murray, G. W.↗

NASA NTRS1977

Packaging of a large capacity magnetic bubble domain spacecraft recorder

A Solid State Spacecraft Data Recorder (SSDR), based on bubble domain technology, having a storage capacity of 10 to the 8th power bits, was designed and is being tested. The recorder consists of two memory modules each having 32 cells, each cell containing sixteen 100 kilobit serial bubble memory chips. The memory modules are interconnected to a Drive and Control Unit (DCU) module containing four microprocessors, 500 integrated circuits, a RAM core memory and two PROM's. The two memory modules and DCU are housed in individual machined aluminum frames, are stacked in brick fashion and through bolted to a base plate assembly which also houses the power supply.

Becker, F. J.↗