Search NASA⌕ Search

Engineering topics

Boswell, Ray

Publications and source records attributed to Boswell, Ray.

At least 55 records · Page 3

UT-GOM2-1 Hydrate Pressure Coring Expedition Volume

From 2-May-2017 to 22-May-2017, the UT-GOM2-1 Hydrate Pressure Coring Expedition drilled two wells in Green Canyon Block 955 (GC 955) in the deepwater Gulf of Mexico: Hole GC 955 H002 (H002) and Hole GC 955 H005 (H005). 21 10 ft (3.05 m) pressure cores were attempted in and near the methane hydrate reservoir. In the first hole, H002, 1 of the 8 cores were recovered under pressure and there was 34% recovery of sediment (both pressurized and depressurized). In the second hole, H005, 12 of the 13 cores were recovered under pressure and there was 72% recovery of sediment. The pressure cores were imaged and logged under pressure. Samples were quantitatively degassed either on-board or on-shore to determine the hydrate concentration and the gas composition. Pore water analyses were performed on depressurized samples, and sediment samples were collected to enable characterization of the microbial community. 21 3.3 ft (1 m) vessels containing pressure core sections were returned to the University of Texas for storage, distribution, and further analysis. These cores will provide a foundation for scientific exploration by the greater hydrate research community.

03 NATURAL GAS↗

Evaluation of Geothermal and Natural Gas Resources Beneath Camp Dawson and Opportunities for Deep Direct Use of Geothermal Energy or Natural Gas for Heat and Electricity Production; NETL-TRS-8-2017; NETL Technical Report Series; U.S. Department of Energy, National Energy Technology Laboratory: Morgantown, WV, 2017; p 148.

NETL has reviewed available information and evaluated the deep geothermal and natural gas resources located beneath the Camp Dawson National Guard Training Center in West Virginia. This facility is located in the northeastern portion of the state in Preston County, near the town of Kingwood. This study reviews options for the onsite drilling of wells for the production of geothermal heat or natural gas, as well as the utilization of these resources for on-site power and heating needs. Resources of potential interest are at subsurface depths between 7,000 feet and 15,000 feet.

03 NATURAL GAS↗

What Has Been Learned From Pressure Cores

The advancement of pressure core acquisition and analysis technology in recent decades has enabled detailed imaging and direct measurement of naturally occurring hydrate-bearing sediments and has shed light onto hydrate habits, formation processes, fundamental physical properties, and hydrate deposit responses during gas production. This paper reviews the development and capabilities of the pressure core technology, discusses insights learned from hydrate-bearing pressure cores and inherent limitations of this technology, and concludes with suggestions for potential applications of pressure core technology for investigating hydrate deposits.

Dai, Sheng↗

The Increasingly Complex Challenge of Gas Hydrate Reservoir Simulation

Gas hydrate reservoir simulation is a complex endeavor. Reliable simulation capability will allow the proper design of field tests and the interpretation of field test data that are necessary to advance the understanding of the response of gas hydrate reservoirs to production activities. Increasing appreciation of the complexity of gas hydrate reservoirs, as well as continued uncertainty in key petrophysical parameters, requires great care in the design of simulation studies. This report outlines select emerging issues that greatly impact the relevance of numerical simulation resulting, including reservoir heterogeneity, geomechanics, log and core data interpretation, grid size, and others.

Boswell, Ray↗

Numerical Studies of Depressurization-Induced Gas Production from an Interbedded Marine Turbidite Gas Hydrate Reservoir Model

The numerical simulation of thin hydrate-bearing sand layers interbedded with mud layers is investigated. In this model, the lowest hydrate layer occurs at the base of gas hydrate stability and overlies a thinly-interbedded saline aquifer. The predicted gas rates reach 6.25 MMscf/day (~1.77 x 10 5 m 3 /day) after 90 days of continuous depressurization with manageable water production. Development of horizontal dissociating interfaces between hydrate-bearing sand and mud layers is a primary determinant of reservoir performance. A set of simulations has been executed to assess uncertainty in in situ permeability and to determine the impact of the saline aquifer on productivity.

Myshakin, Evgeniy↗

Geomechanical Analysis of Initial Stage of Gas Production from Interbredded Hydrate-bearing Sediment

Geomechanical stability of marine hydrate reservoirs during gas production by depressurization is the focus of this study. The reservoir considered here consists of thin hydrate rich sandy layers interbedded with mud layers. Because of the input parameter uncertainties involved, it is prudent from a geomechanical perspective to estimate the likely bounds of potential responses. A decoupled approach is presented herein for which the pressure and hydrate saturation in the sediments during gas production are obtained from multiphase flow computation, but could also be synthesized from various scenarios. This procedure is illustrated with sample problems.

Lin, Jeen-Shang↗

Hydrate Formation in an Unsaturated System - Impacts of Fine Particles and Water Content

Parametric study of hydrate saturation dependent properties of hydrate-bearing sediments requires a large amount of uniform and representative specimens. Expedited synthetization of hydrate-bearing sediments in the laboratory usually uses an unsaturated system due to low methane solubility in water. This study experimentally investigates how various factors affect the distribution of formed hydrate in the sediments via X-ray computed tomography. Results show that the pressure-temperature history is the most critical factor influencing water migration during hydrate formation. Hydrate formed by cooling-pressurization method tends to lead to preferred hydrate formation at core boundaries where exothermic heat can be easily dissipated. The presence of fine-grained particles fails to mitigate this phenomenon, but can effectively suppress water migration even when hydrate is formed using the pressurization-cooling method or the freezing-pressurization-thawing method. Fine-grained particles reduce water activity which further reduce the amount of hydrate formed in the system. The mixing sequence of sand-clay-water mixture affects the final morphology and distribution of each phase and eventually affects hydrate distribution in the sediments. A small amount of clay in sands can suppress water preferentially residing at grain contacts and combine with water acting as a pore filling component. This potentially helps synthesize non-cementing hydrate-bearing sediments in the laboratory more efficiently.

Lei, Liang↗

High-resolution Seismic Imaging of Depositional Characteristics at Gas Hydrate Research Sites in the Gulf of Mexico

High-resolution seismic data acquired by the U.S. Geological Survey (USGS), with support from the U.S. Bureau of Ocean Energy Management (BOEM) and the U.S. Department of Energy (DOE), in 2013 at two geologically distinct study sites in the offshore Gulf of Mexico basin provide an opportunity for detailed characterization and for comparison of the depositional settings of sediments that host high concentrations of gas hydrate at each site. Gas hydrate exists at Green Canyon Block 955 (GC955) within sand layers deposited in a proximal marine channel-levee setting, whereas at Walker Ridge Block 313 (WR313) gas hydrate deposits occur within thin distal levees and sheet sands deposited in a mini-basin environment. A refined understanding of the depositional environment at these sites in turn provides valuable insights regarding reservoir characteristics and controls on gas hydrate occurrence.

Haines, Seth↗

GOM2: Prospecting, Drilling and Sampling Coarse-Grained Hydrate Reservoirs in the Deepwater Gulf of Mexico

The UT-GOM2-1 Hydrate Pressure Coring Expedition will drill two holes in Green Canyon Block 955 in the deepwater Gulf of Mexico to pressure core and wireline log a coarse-grained methane hydrate reservoir. We will take ten, 10 ft, pressure cores in each well. The cores will be imaged and logged under pressure. Samples will be degassed to interpret hydrate concentration. Microbiological and porewater analyses will be performed. 20 3 ft pressure cores will be returned to shore for analysis. The log and core data will provide a foundation for scientific exploration by the greater hydrate research community.

Flemings, Peter↗

UT-GOM2-1 Hydrate Pressure Coring Expedition Prospectus

The UT-GOM2-1 Hydrate Pressure Coring Expedition will drill two holes in Green Canyon Block 955 in the deepwater Gulf of Mexico to pressure core and wireline log a coarse-grained methane hydrate reservoir. We will take ten, 10 ft, pressure cores in each well. The cores will be imaged and logged under pressure. Samples will be degassed to interpret hydrate concentration. Microbiological and pore water analyses will be performed. 20 3 ft pressure cores will be returned to shore for analysis. The log and core data will provide a foundation for scientific exploration by the greater hydrate research community

03 NATURAL GAS↗

Numerical simulations of depressurization-induced gas production from gas hydrates using 3-D heterogeneous models of L-Pad, Prudhoe Bay Unit, North Slope Alaska

Gas production potential is estimated using a three-dimensional reservoir model based on gas hydrate deposits located in the Prudhoe Bay region of the Alaska's North Slope. The model incorporates two hydrate-bearing sand units using detailed reservoir geological and structural information obtained from past and recent drilling programs. Geostatistical porosity models, conditioned to log data from 78 wells drilled in the vicinity of the Prudhoe Bay “L-Pad,” were developed, providing 3D heterogeneity in porosity, porosity-dependent hydrate saturation, and intrinsic permeability. The simulations utilize both vertical and inclined wellbores to induce depressurization of the reservoir at a constant bottom-hole pressure. The results show the superior performance of the inclined well design. Average gas production rates during the first five years were ~6.0 × 10 4 ST m 3 /day (~2.1 MMSCF/day) and ~2.7 × 10 4 ST m 3 /day (~1.0 MMSCF/day) for incline and vertical wells, respectively. After 30 years 5.3 × 10 8 - 5.7 × 10 8 ST m 3 (18.6–20.2 BSCF) and 6.2 × 10 8 - 6.4 × 10 8 ST m 3 (22.0–22.7 BSCF) gas were produced using the vertical and inclined well configurations, respectively. The analysis reveals that 2D reservoir models with homogeneous representations for porosity and hydrate saturation significantly underestimate production potential. The heterogeneity implemented in this work provides complex porous network and preferential pathways for mobile phase flow to a producing well. Consequently, no secondary hydrate formation around a wellbore is predicted in contrast to models that utilize uniform porosity and hydrate saturation distributions.

03 NATURAL GAS↗

Basin and Petroleum System Modeling of Gas Hydrate Deposits in the Walker Ridge Area, Northern Gulf of Mexico - Poster

Poster presented by NETL at ICGH, 06/17 - Abstract:<p><br></p><p>We are currently constructing an Earth model of the Terrebonne Basin for comprehensive 3D modeling. Well data and a high-quality 3D seismic survey underpin the geologic conditions for the model. Additional model constraints include basal heat flow, seafloor temperature, and paleowater depth through time. Our initial investigation comprises the development of a “pseudo” 2D model centered on the deep WR313 #001 well. We are using this test case to establish the workflow for integrating BPSM with gas hydrate analyses; this will eventually be applied to the entire mini-basin. </p><p><br></p><p>A key aspect of investigating the gas hydrate system with BPSM is integrating it with the other active petroleum system(s) in the region, because the methane in hydrate deposits can derive from both biogenic and thermogenic sources. Some of the questions we may consider are: What is the history of these deposits with respect to the gas hydrate stability zone, recognizing that this area is not one characterized by simple continuous sedimentation and subsidence, but instead by periodic uplift, tilting, plate rotation, sea-level change, salt tectonics, and evolution of temperature gradients. </p><p><br></p><p>In conclusion, BPSM has been called the ‘great integrator’ in petroleum exploration. Development of a BPSM model of gas hydrates in the Terrebonne Basin of the northern GoM will provide a vehicle within which to integrate other early exploration and assessment research being conducted on gas hydrates, such as in frontier areas like Japan, as a potential resource likely to provide many decades of energy if proven to be commercially producible</p>

Dafov, Laura↗