Ab Initio Investigation of Per- and Poly-fluoroalkyl Substance (PFAS) Adsorption on Zerovalent Iron (Fe 0 )
Not Available
Mohamed, Mohamed S.↗
Engineering topics
Chaplin, Brian P.
Publications and source records attributed to Chaplin, Brian P..
Electrochemical reduction of per- and polyfluorinated alkyl substances (PFAS): is it possible? Applying experimental and quantum mechanical insights from the reductive defluorination literature
Remediation of per- and polyfluorinated alkyl substances (PFAS) in global water systems is a critical human and environmental health challenge facing society. PFAS consumption is associated with a litany of adverse health effects, and our knowledge of these dangers is still evolving. Current techniques to remove PFAS from water include adsorption to media (e.g. granular activated carbon, ion-exchange resin), nanofiltration, and reverse osmosis. However, these processes create a concentrated PFAS residual that requires further management. Destructive techniques are therefore needed to detoxify these residuals. Oxidative techniques have garnered the most attention (e.g. supercritical water oxidation, electrochemical oxidation) but are energy intensive and potentially form toxic by-products. As an alternative, several groups have researched advanced reduction processes that form aqueous electrons, but these processes are still chemical and energy intensive (e.g. ultraviolet/SO 3 2− , electron beam). This concise review therefore focuses on whether electrochemical reduction — a chemical-free, modular process — could be technically feasible for PFAS destruction.
King, Jacob F.↗
A New Cathode Material for a Li–O 2 Battery Based on Lithium Superoxide
Li–O 2 batteries suffer from large charge overpotentials due to the high charge transfer resistance of Li 2 O 2 discharge products. A potential solution to this problem is the development of LiO 2 -based batteries that possess low charge overpotentials due to the lower charge transfer resistance of LiO 2 . In this report, IrLi nanoparticles were synthesized and implemented for the first time as a LiO 2 battery cathode material. The IrLi nanoparticle synthesis was achieved by a temperature- and time-optimized thermal reaction between a precise ratio of iridium nanoparticles and lithium metal. Li–O 2 batteries employing the IrLi-rGO cathodes were cycled up to 100 cycles at moderate current densities with sustained low cell charge potentials (<3.5 V). Further, various characterization techniques, including SEM, DEMS, TEM, Raman, and titration, were used to demonstrate the LiO 2 discharge product and the absence of Li 2 O 2 . On the basis of first-principles calculations, it was concluded that the formation of crystalline LiO 2 can be stabilized by epitaxial growth on the (111) facets of IrLi nanoparticles present on the cathode surface. These findings demonstrate that, in addition to the previously studied Ir 3 Li intermetallic, the IrLi intermetallic also provides a means by which LiO 2 discharge products can be stabilized and confirms the importance of templating for the formation process.
25 ENERGY STORAGE↗
Electronic properties of Ir 3 Li and ultra-nanocrystalline lithium superoxide formation
Current lithium-oxygen (Li-O 2 ) batteries suffer from large charge overpotentials related to electronic resistivity of the insulating lithium peroxide (Li 2 O 2 ) discharge product. One potential solution to this challenge is the stabilization of the lithium superoxide (LiO 2 ) discharge intermediate, which has much higher electronic conductivity compared to Li 2 O 2 . Cathodes based on small iridium (Ir) nanoparticles have been recently used in a LiO 2 battery to successfully stabilize the LiO 2 product, however, the LiO 2 had a short lifetime. In the previous study, researchers found that the LiO 2 was stabilized on Ir 3 Li surfaces which were formed from Ir nanoparticles during battery operation. Little is known about the electronic properties of Ir 3 Li and its role in stabilizing LiO 2 product formation. This work provides the first study of the electronic properties of Ir 3 Li, which was thermally synthesized in bulk prior to implementation on the reduced graphene oxide (rGO) cathode of a Li-O 2 cell. Here, the bulk Ir 3 Li was found to have comparable electrical conductivity to Ir metal, possess metal-like magnetic properties, and has an affinity towards O 2 adsorption. The LiO 2 discharge product formed from the Li-O 2 battery discharge was characterized using Raman spectroscopy, titration, along with a comprehensive transmission electron microscopy (TEM) study. This analysis revealed the formation of ultra-nanocrystalline LiO 2 particles greater than 200 nm. This result was attributed to the use of large micron sized Ir 3 Li particles, which could stabilize larger LiO 2 particles compared to previous cathodes that utilized Ir nanoparticles that partially converted to Ir 3 Li during cycling. These results demonstrate that cathode properties can be modified to stabilize the bulk LiO 2 discharge product, which can be useful for the further development of LiO 2 -based Li-O 2 batteries.
25 ENERGY STORAGE↗
Charge Transport Properties of Lithium Superoxide in Li–O 2 Batteries
The theoretical energy density of lithium–oxygen (Li–O 2 ) batteries is extremely high, although there are many challenges that must be overcome to achieve high energy density in a manufactured cell. For example, little is known about the properties of one of the key intermediates, lithium superoxide (LiO 2 ), which until recently had not been stabilized in bulk form. In this work, lithium superoxide was deposited onto iridium–reduced graphene oxide (Ir–rGO) cathodes in a Li–O 2 system under a flow of O 2 . Lithium peroxide (Li 2 O 2 ) was subsequently produced on the cathode surface in an inert Ar atmosphere. Based on a detailed analysis of electrochemical impedance spectroscopy data, it was demonstrated experimentally for the first time that the charge transport resistance through LiO 2 was much lower than for Li 2 O 2 and correlated with lower LiO 2 charge overpotentials. We report this result indicates that LiO 2 has good electronic conductivity and confirms previous theoretical predictions that bulk LiO 2 has better charge transport properties than Li 2 O 2 . In addition, impedance and other characterization of Li 2 O 2 formation from LiO 2 in an Ar atmosphere revealed that when surface-mediated Li 2 O 2 formation occurs, it has a significantly lower discharge potential than when it forms through a solution-phase-mediated process. These significant findings will contribute to the development of Li–O 2 batteries through better understanding of LiO 2 properties and formation mechanisms.
25 ENERGY STORAGE↗