Frequency dependence of wake-up and fatigue characteristics in ferroelectric Al0.93B0.07N thin films
Not provided.
Materials Science↗
Engineering topics
Choi, Sukwon
Publications and source records attributed to Choi, Sukwon.
Deep-Ultraviolet Thermoreflectance Imaging of Ultra-Wide Bandgap Semiconductor Devices (invited).
Abstract not provided.
Choi, Sukwon↗
A perspective on the electro-thermal co-design of ultra-wide bandgap lateral devices
Fundamental research and development of ultra-wide bandgap (UWBG) semiconductor devices are under way to realize next-generation power conversion and wireless communication systems. Devices based on aluminum gallium nitride (AlxGa1-xN, x is the Al composition), ..beta..-phase gallium oxide (..beta..-Ga2O3), and diamond give promise to the development of power switching devices and radio frequency power amplifiers with higher performance and efficiency than commercial wide bandgap semiconductor devices based on gallium nitride (GaN) and silicon carbide (SiC). However, one of the most critical challenges for the successful deployment of UWBG device technologies is to overcome adverse thermal effects that impact the device performance and reliability. Overheating of UWBG devices originates from the projected high power density operation and poor intrinsic thermal properties of AlxGa1-xN and ..beta..-Ga2O3. This Perspective delineates the need and process for the "electro-thermal co-design" of laterally configured UWBG electronic devices and provides a comprehensive review of current state-of-the-art thermal characterization methods, device thermal modeling practices, and both device- and package-level thermal management solutions.
71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗
Thermal Conductivity of β-Phase Ga 2 O 3 and (Al x Ga 1– x ) 2 O 3 Heteroepitaxial Thin Films
Heteroepitaxy of β-phase gallium oxide (β-Ga 2 O 3 ) thin films on foreign substrates shows promise for the development of next-generation deep ultraviolet solar blind photodetectors and power electronic devices. In this work, the influences of the film thickness and crystallinity on the thermal conductivity of ($\bar{2}01$)-oriented β-Ga 2 O 3 heteroepitaxial thin films were investigated. Unintentionally doped β-Ga 2 O 3 thin films were grown on c-plane sapphire substrates with off-axis angles of 0° and 6° toward $\langle$$11\bar{2}0$$\rangle$ via metal–organic vapor phase epitaxy (MOVPE) and low-pressure chemical vapor deposition. The surface morphology and crystal quality of the β-Ga 2 O 3 thin films were characterized using scanning electron microscopy, X-ray diffraction, and Raman spectroscopy. The thermal conductivities of the β-Ga 2 O 3 films were measured via time-domain thermoreflectance. The interface quality was studied using scanning transmission electron microscopy. The measured thermal conductivities of the submicron-thick β-Ga 2 O 3 thin films were relatively low as compared to the intrinsic bulk value. The measured thin film thermal conductivities were compared with the Debye–Callaway model incorporating phononic parameters derived from first-principles calculations. The comparison suggests that the reduction in the thin film thermal conductivity can be partially attributed to the enhanced phonon-boundary scattering when the film thickness decreases. They were found to be a strong function of not only the layer thickness but also the film quality, resulting from growth on substrates with different offcut angles. Growth of β-Ga 2 O 3 films on 6° offcut sapphire substrates was found to result in higher crystallinity and thermal conductivity than films grown on on-axis c-plane sapphire. However, the β-Ga 2 O 3 films grown on 6° offcut sapphire exhibit a lower thermal boundary conductance at the β-Ga 2 O 3 /sapphire heterointerface. In addition, the thermal conductivity of MOVPE-grown ($\bar{2}01$)-oriented β-(Al x Ga 1–x ) 2 O 3 thin films with Al compositions ranging from 2% to 43% was characterized. Because of phonon-alloy disorder scattering, the β-(Al x Ga 1–x ) 2 O 3 films exhibit lower thermal conductivities (2.8–4.7 W/m∙K) than the β-Ga 2 O 3 thin films. The dominance of the alloy disorder scattering in β-(Al x Ga 1–x ) 2 O 3 is further evidenced by the weak temperature dependence of the thermal conductivity. This work provides fundamental insight into the physical interactions that govern phonon transport within heteroepitaxially grown β-phase Ga 2 O 3 and (Al x Ga 1–x ) 2 O 3 thin films and lays the groundwork for the thermal modeling and design of β-Ga 2 O 3 electronic and optoelectronic devices.
36 MATERIALS SCIENCE↗
Residual stress analysis of aluminum nitride piezoelectric micromachined ultrasonic transducers using Raman spectroscopy
In this study, the Raman biaxial stress coefficients K II and strain-free phonon frequencies ω 0 have been determined for the E 2 (low), E 2 (high), and A 1 (LO) phonon modes of aluminum nitride, AlN, using both experimental and theoretical approaches. The E 2 (high) mode of AlN is recommended for the residual stress analysis of AlN due to its high sensitivity and the largest signal-to-noise ratio among the studied modes. The E 2 (high) Raman biaxial stress coefficient of ₋3.8 cm₋1/GPa and strain-free phonon frequency of 656.68 cm ₋1 were then applied to perform both macroscopic and microscopic stress mappings. For macroscopic stress evaluation, the spatial variation of residual stress was measured across an AlN-on-Si wafer prepared by sputter deposition. A cross-wafer variation in residual stress of ~150 MPa was observed regardless of the average stress state of the film. Microscopic stress evaluation was performed on AlN piezoelectric micromachined ultrasonic transducers (pMUTs) with submicrometer spatial resolution. These measurements were used to assess the effect of device fabrication on residual stress distribution in an individual pMUT and the effect of residual stress on the resonance frequency. At ~20 μm directly outside the outer edge of the pMUT electrode, a large lateral spatial variation in residual stress of ~100 MPa was measured, highlighting the impact of metallization structures on residual stress in the AlN film.
36 MATERIALS SCIENCE↗
Guest Editorial: Special Issue on InterPACK 2019 - Part 1
This is a collection of papers drawn from the 2019 ASME InterPACK Conference. The content spans the areas of heterogeneous integration, servers, flexible and wearable electronics, photonics, power electronics, energy storage, and autonomous and electric vehicles.
47 OTHER INSTRUMENTATION↗
Device-Level Multidimensional Thermal Dynamics With Implications for Current and Future Wide Bandgap Electronics
Researchers have been extensively studying wide-bandgap (WBG) semiconductor materials such as gallium nitride (GaN) with an aim to accomplish an improvement in size, weight, and power of power electronics beyond current devices based on silicon (Si). However, the increased operating power densities and reduced areal footprints of WBG device technologies result in significant levels of self-heating that can ultimately restrict device operation through performance degradation, reliability issues, and failure. Typically, self-heating in WBG devices is studied using a single measurement technique while operating the device under steady-state direct current measurement conditions. However, for switching applications, this steady-state thermal characterization may lose significance since the high power dissipation occurs during fast transient switching events. Therefore, it can be useful to probe the WBG devices under transient measurement conditions in order to better understand the thermal dynamics of these systems in practical applications. In this work, the transient thermal dynamics of an AlGaN/GaN high electron mobility transistor (HEMT) were studied using thermoreflectance thermal imaging and Raman thermometry. Also, the proper use of iterative pulsed measurement schemes such as thermoreflectance thermal imaging to determine the steady-state operating temperature of devices is discussed. These studies are followed with subsequent transient thermal characterization to accurately probe the self-heating from steady-state down to submicrosecond pulse conditions using both thermoreflectance thermal imaging and Raman thermometry with temporal resolutions down to 15 ns.
42 ENGINEERING↗