Case study probing the potential drivers of Houston new particle formation and growth in a unique outdoor chamber
Explore the source record for details and available documents.
O’Donnell, Samuel E.↗
Engineering topics
Collins, D. R.
Publications and source records attributed to Collins, D. R..
In Situ Aerosol Size Distributions and Clear Column Radiative Closure During ACE-2
As part of the second Aerosol Characterization Experiment (ACE-2) during June and July of 1997, aerosol size distributions were measured on board the CIRPAS Pelican aircraft through the use of a DMA and two OPCS. During the campaign, the boundary layer aerosol typically possessed characteristics representative of a background marine aerosol or a continentally influenced aerosol, while the free tropospheric aerosol was characterized by the presence or absence of a Saharan dust layer. A range of radiative closure comparisons were made using the data obtained during vertical profiles flown on four missions. Of particular interest here are the comparisons made between the optical properties as determined through the use of measured aerosol size distributions and those measured directly by an airborne 14-wavelength sunphotometer and three nephelometers. Variations in the relative humidity associated with each of the direct measurements required consideration of the hygroscopic properties of the aerosol for size distribution based calculations. Simultaneous comparison with such a wide range of directly measured optical parameters not only offers evidence of the validity of the physicochemical description of the aerosol when closure is achieved, but also provides insight into potential sources of error when some or all of the comparisons result in disagreement. Agreement between the derived and directly measured optical properties varied for different measurements and for different cases. Averaged over the four case studies, the derived extinction coefficient at 525 nm exceeded that measured by the sunphotomoter by 2.5% in the clean boundary later, but underestimated measurements by 13% during pollution events. For measurements within the free troposphere, the mean derived extinction coefficient was 3.3% and 17% less than that measured by the sunphotometer during dusty and nondusty conditions, respectively. Likewise, averaged discrepancies between the derived and measured scattering coefficient were -9.6%, +4.7%, +17%, and -41% for measurements within the clean boundary layer, polluted boundary layer, free troposphere with a dust layer, and free troposphere without a dust layer, respectively. Each of these quantities, as well as the majority of the > 100 individual comparisons from which they were averaged, were within estimated uncertainties.
Collins, D. R.↗
Charge coupled devices for intensified imager applications
Three types of CCD sensors have been successfully incorporated into ICCD (intensified CCD) tubes. Intensifier tubes of varying design and application have been manufactured by three different manufacturers. Typical characteristics of the thinned CCDs incorporated into these ICCD's will be presented. Problems concerning the compatibility of tube processing and CCD performance will be discussed, as well as the procedures used to minimize CCD degradation during tube processing. ICCD tube characteristics will also be presented.
Stubbs, D. P.↗
A backside illuminated 400 x 400 charge-coupled device imager
Large-area backside illuminated charge-coupled device imagers have been fabricated using double level aluminum transfer electrode technology. Devices with 100 x 160 and 400 x 400 resolution elements have been fabricated using buried channel technology for high charge transfer efficiency. Detailed optical characterization has been performed on these imagers over the temperature range -40 to +24 C and at several operating frequencies between 10 kHz and 1 MHz.
Antcliffe, G. A.↗
Large-area CCD imagers for spacecraft applications
Backside illuminated CCD imagers with 100 x 160 resolution elements have been fabricated using double level metal technology. Detailed study of the optical performance of such arrays has been performed between 24 C and -40 C using data rates from 10 kHz to 1 MHz. A 400 x 400 array is presently being fabricated.
Antcliffe, G. A.↗
Development of a CCD for ultraviolet imaging using a CCD photocathode combination
CCD in the electron-in mode, coupled with a bi-alkali photocathode to produce UV photon conversion, provides the following desirable features: (1) high UV response of the bi-alkali photocathode; (2) excellent imaging quality of a CCD area array; and (3) high signal-to-noise ratio due to the EBS (electron bombarded silicon) gain of the CCD operating in a tube configuration. This paper describes the rationale and progress made in developing a CCD for use as an UV imager.
Collins, D. R.↗
Effects of ionizing radiation on CCD's
The effects of 1.2 MeV gamma radiation and 20 MeV electrons on the operational characteristics of CCDs are studied. The effects of ionizing radiation on the charge transfer efficiency, dark current, and input/output circuitry are described. The improved radiation hardness of buried channel CCDs is compared to surface channel results. Both ion implanted and epitaxial layer buried channel device results are included. The advantages of using a single thickness SiO2 gate dielectric are described. The threshold voltage shifts and surface state density changes of dry, steam, and HCl doped oxides are discussed. Recent results on the recovery times and total dose effects of high dose rate pulses of 20 MeV electrons are reported.
Hartsell, G. A.↗
Spacecraft development
Flight sequence, capsule design, pyrotechnic applications, escape modes, and safety features for Gemini spacecraft
SAFETY DEVICE↗