Search NASA⌕ Search

Engineering topics

Fischman, M. A.

Publications and source records attributed to Fischman, M. A..

7 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2008

The Detection and Mitigation of RFI with the Aquarius L-Band Scatterometer

The Aquarius sea-surface salinity mission includes an L-band scatterometer to sense sea-surface roughness. This radar is subject to radio-frequency interference (RFI) in its passband from 1258 to 1262 MHz, a region also allocated for terrestrial radio location. Due to its received power sensitivity requirements, the expected RFI environment poses significant challenges. We present the results of a study evaluating the severity of terrestrial RFI sources on the operation of the Aquarius scatterometer, and propose a scheme to both detect and remove problematic RFI signals in the ocean backscatter measurements. The detection scheme utilizes the digital sampling of the ambient input power to detect outliers from the receiver noise floor which are statistically significant, and flags nearby radar echoes as potentially contaminated by RFI. This detection strategy, developed to meet tight budget and data downlink requirements, has been implemented and tested in hardware, and shows great promise for the detection and global mapping of L-band RFI sources.

Electromagnetic radiative interference↗
NASA NTRS2007

An FPGA-based Doppler Processor for a Spaceborne Precipitation Radar

Measurement of precipitation Doppler velocity by spaceborne radar is complicated by the large velocity of the satellite platform. Even if successive pulses are well correlated, the velocity measurement may be biased if the precipitation target does not uniformly fill the radar footprint. It has been previously shown that the bias in such situations can be reduced if full spectral processing is used. The authors present a processor based on field-programmable gate array (FPGA) technology that can be used for spectral processing of data acquired by future spaceborne precipitation radars. The requirements for and design of the Doppler processor are addressed. Simulation and laboratory test results show that the processor can meet real-time constraints while easily fitting in a single FPGA.

measurements↗
NASA NTRS2004

An on-board processor for a spaceborne Doppler precipitation radar : requirements and preliminary design

Use of Doppler velocity measurement in spaceborne precipitation radar is highly desirable, since it can allow more accurate retrieval of atmospheric latent heating, which depends on both cloud and rain microphysical processes and on dynamical processes, namely, vertical updrafts and downdrafts. However, if the rain within the antenna beam is very non-uniform, biases can result with conventional pulse-pair processing, and more sophisticated processing is required. The solution is a time-frequency approach, which uses the full Doppler spectrum at each point in time. Since precipitation radars normally operate continuously and collect large amounts of data, real-time, on-board processing of data is needed to reduce the data rate. The objective of this work is to develop an on-board data processor for spaceborne Doppler precipitation radar, using field-programmable gate array (FPGA) technology. This paper describes the simulations and analysis that have been completed during the first year of the project. This includes both analytical calculations and bit-true simulations that allow the effects of finite word length to be explored. Tradeoffs have also been considered between speed and space within the chosen FPGA part. The results of these analyses have been used to develop a complete set of requirements for the processor. Initial design work has begun, based on these requirements. The design is being implemented in Verilog, and a description of this early design effort is also be given.

on-board processing↗