Search NASA⌕ Search

Engineering topics

Fuller, C. R.

Publications and source records attributed to Fuller, C. R..

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1987

Application of the complex cepstrum to the location of acoustic sources near reflective surfaces

The complex cepstrum is used to correct bearing estimations of acoustic sources in the presence of a reflective surface. An automated liftering procedure is used which zeros out a block portion of the cepstrum including the echo information. The problem of the resulting distortion is alleviated by applying a coherence criterion to the recovered direct signals at each microphone. Thus to a large degree the interactive nature of cepstral processing is overcome for this application. For the test signals and geometries considered the cepstrum is shown to accurately correct for bearing errors in acoustic signals contaminated with reflections from nearby surfaces.

Fuller, C. R.↗
NASA NTRS1987

Active control of sound fields in elastic cylinders by vibrational inputs

An experiment is performed to study the mechanisms of active control of sound fields in elastic cylinders via vibrational outputs. In the present method of control, a vibrational force input was used as the secondary control input to reduce the radiated acoustic field. For the frequencies considered, the active vibration technique provided good global reduction of interior sound even though only one actuator was used.

Jones, J. D.↗
NASA NTRS1986

An experimental investigation of the interior noise control effects of propeller synchrophasing

A simplified cylindrical model of an aircraft fuselage is used to investigate the mechanisms of interior noise suppression using synchrophasing techniques. This investigation allows isolation of important parameters to define the characteristics of synchrophasing. The optimum synchrophase angle for maximum noise reduction is found for several interior microphone positions with pure tone source excitation. Noise reductions of up to 30 dB are shown for some microphone positions, however, overall reductions are less. A computer algorithm is developed to decompose the cylinder vibration into modal components over a wide range of synchrophase angles. The circumferential modal response of the shell vibration is shown to govern the transmission of sound into the cylinder rather than localized transmission. As well as investigating synchrophasing, the interior sound field due to sources typical of propellers has been measured and discussed.

Jones, J. D.↗
NASA NTRS1986

Radiation of sound from an infinite cylindrical elastic shell excited by an internal monopole source

The radiation of sound from an infinite elastic cylindrical shell excited by an internal monopole source is investigated analytically. Coupled equations of motion are used. The modal mobility of the shell wall at the source plane is examined for differing source locations and the behavior is explained in terms of free wave propagation. The radiated pressure and line power from the shell surface is then evaluated for a similar range of source positions and frequencies. A real surface power flow, that circulates backwards and forward between the shell and fluid while propagating axially, but does not contribute to the radiated far field, is uncovered. Finally, the transmission loss of the shell wall is evaluated and found to be between 10 and 35 dB lower than predicted by existing simplified theories. The lower transmission losses predicted by the coupled analysis presented here are shown to be due to excitation of higher order 'shell' type waves at the source plane.

Fuller, C. R.↗
NASA NTRS1986

Analytical model for investigation of interior noise characteristics in aircraft with multiple propellers including synchrophasing

A simplified analytical model of transmission of noise into the interior of propeller-driven aircraft has been developed. The analysis includes directivity and relative phase effects of the propeller noise sources, and leads to a closed form solution for the coupled motion between the interior and exterior fields via the shell (fuselage) vibrational response. Various situations commonly encountered in considering sound transmission into aircraft fuselages are investigated analytically and the results obtained are compared to measurements in real aircraft. In general the model has proved successful in identifying basic mechanisms behind noise transmission phenomena.

Fuller, C. R.↗
NASA NTRS1986

Effects of an internal floor on low frequency sound transmission into aircraft cabins - An experimental investigation

A simplified cylindrical model of an aircraft fuselage is used to experimentally study the effects of an internal floor on low frequency sound transmission into aircraft cabins. A scaled-down lattice floor support and floor skin are designed based upon selected characteristics of a business aircraft. Thus, the model provides a simplified procedure for studying the effects of various structural modifications as well as other important effects. Modal decomposition of the shell response and the corresponding pressure response at various interior locations are presented. Results indicate that the main effect of the floor on interior pressure levels is due to modification of the interior acoustic mode shape and not due to the structural modification of the fuselage caused by the lattice floor support.

Jones, J. D.↗
NASA NTRS1986

Structural influence of cabin floor on sound transmission into propeller aircraft - Analytical investigations

The structural influence of the cabin floor on the transmission of low frequency propeller noise into aircraft interiors has been examined using a simplified analytical model. The response amplitudes and distributions of shell displacement and internal acoustic pressure are examined for various frequencies and floor configurations. In general, at lower frequencies the floor exerts little structural influence on the transmission of acoustic energy to the interior. However, as the frequency nears half the cylinder ring frequency the floor can be seen to significantly alter the internal pressure distributions and response.

Fuller, C. R.↗
NASA NTRS1986

Active control of propeller induced noise fields inside a flexible cylinder

An active noise control model has been evaluated for reducing aircraft interior noise. The structural noise transmission properties of an aircraft fuselage were modelled as a flexible cylinder excited by external acoustic dipoles simulating the noise produced by twin propellers. The amplitudes of an internal distribution of monopole control sources were determined such that the area-weighted mean square acoustic pressure was minimized in the propeller plane. The noise control model was evaluated at low frequencies corresponding to the blade passage frequency and first few harmonics of a typical turbo-prop aircraft. Interior noise reductions of 20 25 dB were achieved, over a substantial region of the cylindrical cross-section, with just a few monopole control sources. The most favorable interior noise reductions were achieved when the active noise control model was used in combination with propeller source phasing.

Lester, H. C.↗
NASA NTRS1986

Comparison of two propeller source models for aircraft interior noise studies

The sensitivity of the predicted synchrophasing (SP) effectiveness trends to the propeller source model issued is investigated with reference to the development of advanced turboprop engines for transport aircraft. SP effectiveness is shown to be sensitive to the type of source model used. For the virtually rotating dipole source model, the SP effectiveness is sensitive to the direction of rotation at some frequencies but not at others. The SP effectiveness obtained from the virtually rotating dipole model is not very sensitive to the radial location of the source distribution within reasonable limits. Finally, the predicted SP effectiveness is shown to be more sensitive to the details of the source model used for the case of corotation than for the case of counterrotation.

Mahan, J. R.↗
NASA NTRS1985

Mechanisms of transmission and control of low-frequency sound in aircraft interiors

A simplified analytical model is used to study the principal mechanisms at work in propeller noise source radiation, fuselage response, and the behavior of the coupled inner acoustic field, in order to control low frequency sound in aircraft interiors. Both active and passive methods of noise control are comparatively evaluated in light of the transmission mechanisms. Fuselage vibrational response is noted to be dominated by only a few lower order circumferential modes.

Fuller, C. R.↗
NASA NTRS1985

An improved source model for aircraft interior noise studies

There is concern that advanced turboprop engines currently being developed may produce excessive aircraft cabin noise levels. This concern has stimulated renewed interest in developing aircraft interior noise reduction methods that do not significantly increase take off weight. An existing analytical model for noise transmission into aircraft cabins was utilized to investigate the behavior of an improved propeller source model for use in aircraft interior noise studies. The new source model, a virtually rotating dipole, is shown to adequately match measured fuselage sound pressure distributions, including the correct phase relationships, for published data. The virtually rotating dipole is used to study the sensitivity of synchrophasing effectiveness to the fuselage sound pressure trace velocity distribution. Results of calculations are presented which reveal the importance of correctly modeling the surface pressure phase relations in synchrophasing and other aircraft interior noise studies.

Mahan, J. R.↗
NASA NTRS1985

An improved source model for aircraft interior noise studies

There is concern that advanced turboprop engines currently being developed may produce excessive aircraft cabin noise level. This concern has stimulated renewed interest in developing aircraft interior noise reduction methods that do not significnatly increase take off weight. An existing analytical model for noise transmission into aircraft cabins was utilized to investigate the behavior of an improved propeller source model for use in aircraft interior noise studies. The new source model, a virtually rotating dipole, is shown to adequately match measured fuselage sound pressure distributions, including the correct phase relationships, for published data. The virtually rotating dipole is used to study the sensitivity of synchrophasing effectiveness to the fuselage sound pressure trace velocity distribution. Results of calculations are presented which reveal the importance of correctly modeling the surface pressure phase relations in synchrophasing and other aircraft interior noise studies.

Mahan, J. R.↗
NASA NTRS1985

The effect of source location on the structural-acoustic interaction of an infinite elastic shell

This paper deals with the response of an infinite elastic shell to simple acoustic sources (monopole and dipole). This simplified model is considered in order to gain insight into the characteristics of aircraft interior noise. The shell represents the aircraft fuselage and the sources are due to the propellor. Specifically, in this study the location of the source with respect to the cylinder is the major concern. How this affects acoustic line power, intensity flow into the shell and internal sound pressure is analyzed.

Kelly, J. J.↗
NASA NTRS1984

Noise control characteristics of synchrophasing - An analytical investigation

In this paper the noise control characteristics of synchrophasing are investigated using a simplified model of an aircraft fuselage. The analysis presented here includes directivity effects of the noise sources and solves in closed form the coupled motion between the interior and exterior acoustic fields and the shell vibrational response. The variation in sound pressure level at various locations inside the shell is studied for various synchrophase angles as well as the shell vibrational response and input power flow in order to uncover the principal mechanisms behind the transmission phenomena.

Fuller, C. R.↗