Engineering topics

Gupta, Inder J.

Publications and source records attributed to Gupta, Inder J..

16 records

NASA NTRS1993

Scattering from thin dielectric straps surrounding a perfectly conducting structure

Dielectric straps can support very heavy targets and have low backscattering levels, especially at low frequencies (below 8 GHz); thus, they can be used effectively to support targets during backscattered field measurements. In this paper, the scattered fields of nonmagnetic dielectric straps surrounding a perfectly conducting structure are presented, and the computed results are compared with experimental data. Empirical formulas for the strap scattered fields are also given. These formulas are good for general convex structures whose radii of curvature are large compared with the wavelength and are expected to give a reasonable estimate of the true backscattered fields from the dielectric straps when used as a target support structure.

Al-Hekail, Zeyad O.↗

NASA NTRS1992

Critical range evaluation using a diagonal flat plate

A novel technique is presented to image stray signals in RCS measurement ranges. In this technique, the scattered fields of a flat plate in the diagonal plane are measured in a range for various frequencies and look angles. The scattered field data is then processed to generate an inverse synthetic aperture radar (ISAR) image of the diagonal flat plate. It is shown that scattering mechanisms associated with various stray signals can be identified by using the ISAR image. This leads to better understanding of the range and possible chamber improvements. Scattering mechanisms as small as 90 dB below the plate broadside scattered field level have been observed in the image domain due to the high directivity and low sidelobe characteristics associated with the diagonal flat plate backscattered fields. The results obtained from evaluating the two compact range facilities at The Ohio State University ElectroScience Laboratory are presented to illustrate the virtues of this new range evaluation technique.

Lee, Teh-Hong↗

NASA NTRS1991

An experimental SMI adaptive antenna array simulator for weak interfering signals

An experimental sample matrix inversion (SMI) adaptive antenna array for suppressing weak interfering signals is described. The experimental adaptive array uses a modified SMI algorithm to increase the interference suppression. In the modified SMI algorithm, the sample covariance matrix is redefined to reduce the effect of thermal noise on the weights of an adaptive array. This is accomplished by subtracting a fraction of the smallest eigenvalue of the original covariance matrix from its diagonal entries. The test results obtained using the experimental system are compared with theoretical results. The two show a good agreement.

Dilsavor, Ronald S.↗

NASA NTRS1990

Analysis of blended rolled edge reflectors using numerical UTD

The uniform geometrical theory of diffraction (UTD) concept is used to predict the scattered fields in the target zones of compact-range blended rolled-edge reflectors. Since the necessary diffraction coefficients are not known in a closed form, a numerical method to calculate the diffraction coefficients is described. In the numerical method, the problem is reduced to two dimensions, and physical optics line integration is used to compute the diffraction coefficients. Thus, the method is computationally efficient. The method is used to analyze two compact-range reflectors. The results obtained using the numerical UTD show good agreement with the scattered fields obtained using a corrected physical optics surface integration.

Ellingson, Steven W.↗

NASA NTRS1990

Performance of a modified feedback loop adaptive array with TVRO satellite signals

Performance of an experimental adaptive antenna array system is evaluated using television receive-only (TVRO) satellite signals. The experimental system is a sidelobe canceller with two auxiliary channels. Modified feedback loops are used to enhance the suppression of weak interfering signals. The modified feedback loops used two spatialy separated antennas, each with an individual amplifier for each auxiliary channel. Thus, the experimental system uses five antenna elements. Instead of using five separate antennas, a reflector antenna with multiple feeds is used to receive signals from various TVRO satellites. The details of the earth station are given. It is shown that the experimental system can null up to two signals originating from interfering TVRO satellites while receiving the signals from a desired TVRO satellite.

Steadman, Karl N.↗

NASA NTRS1990

A method to design blended rolled edges for compact range reflectors

A method to design blended rolled edges for arbitrary rim shape compact range reflectors is presented. The reflectors may be center-fed or offset-fed. The method leads to rolled edges with minimal surface discontinuities. It is shown that the reflectors designed using the prescribed method can be defined analytically using simple expressions. A procedure to obtain optimum rolled edges parameters is also presented. The procedure leads to blended rolled edges that minimize the diffracted fields emanating from the junction between the paraboloid and the rolled edge surface while satisfying certain constraints regarding the reflector size and the minimum operating frequency of the system.

Gupta, Inder J.↗

NASA NTRS1989

Adaptive antenna arrays for satellite communication

The feasibility of using adaptive antenna arrays to provide interference protection in satellite communications was studied. The feedback loops as well as the sample matric inversion (SMI) algorithm for weight control were studied. Appropriate modifications in the two were made to achieve the required interference suppression. An experimental system was built to test the modified feedback loops and the modified SMI algorithm. The performance of the experimental system was evaluated using bench generated signals and signals received from TVRO geosynchronous satellites. A summary of results is given. Some suggestions for future work are also presented.

Gupta, Inder J.↗

NASA NTRS1989

Effects of desired signal on the performance of a sidelobe canceller

The performance of a sidelobe canceller is studied in a communication system where the desired signal is continually present and its amplitude in the auxiliary antennas may be large (above thermal noise). In such a system, to avoid the cancellation of the desired signal, one can use a reference signal and adjust the auxiliary antenna weights to minimize the error between the reference signal and the sidelobe canceller output or one can use a steering vector. It is shown that in spite of the reference signal or a steering vector, the presence of the desired signal in the auxiliary antennas degrades the interference suppression provided by a sidelobe canceller. The amount of degradation depends on the number of degrees of freedom, the strength of the various signals, and the angular resolution of the auxiliary antenna array. Signal scenarios involving a single interfering signal as well as those involving multiple interfering signals are considered.

Gupta, Inder J.↗

NASA NTRS1989

A method to design blended rolled edges for compact range reflectors

A method to design blended rolled edges for arbitrary rim shape compact range reflectors is presented. The reflectors may be center-fed or offset-fed. The method leads to rolled edges with minimal surface discontinuities. It is shown that the reflectors designed using the prescribed method can be defined analytically using simple expressions. A procedure to obtain optimum rolled edges parameter is also presented. The procedure leads to blended rolled edges that minimize the diffracted fields emanating from the junction between the paraboloid and the rolled edge surface while satisfying certain constraints regarding the reflector size and the minimum operating frequency of the system.

Gupta, Inder J.↗

NASA NTRS1989

Scattering from thin dielectric straps surrounding a perfectly conducting structure

A method to calculate the electromagnetic scattered fields from a dielectric strap wrapped around convex, conducting structure is presented. A moment method technique is used to find the current excited within the strap by the incident plane wave. Then, Uniform Geometrical Theory of Diffraction (UTD) is used to compute the fields scattered by the strap. Reasonable agreement was obtained between the computed and the measured results. The results found in this study are useful in evaluating straps as a target support structure for scattering measurements.

Al-Hekail, Zeyad↗

NASA NTRS1988

An experimental adaptive array to suppress weak interfering signals

An experimental adaptive antenna system to suppress weak interfering signals is described. It is a sidelobe canceller with two auxiliary elements. Modified feedback loops are used to control the array weights. The received signals are simulated in hardware for parameter control. Digital processing is used for algorithm implementation and performance evaluation. The experimental results are presented. They show that interfering signals as much as 10 dB below the thermal noise level in the main channel are suppressed by 20-30 dB. Such a system has potential application in suppressing the interference encountered in direct broadcast satellite communication systems.

Walton, Eric K.↗

NASA NTRS1987

An efficient method to compute spurious end point contributions in PO solutions

A method is given to compute the spurious endpoint contributions in the physical optics solution for electromagnetic scattering from conducting bodies. The method is applicable to general three-dimensional structures. The only information required to use the method is the radius of curvature of the body at the shadow boundary. Thus, the method is very efficient for numerical computations. As an illustration, the method is applied to several bodies of revolution to compute the endpoint contributions for backscattering in the case of axial incidence. It is shown that in high-frequency situations, the endpoint contributions obtained using the method are equal to the true endpoint contributions.

Gupta, Inder J.↗

NASA NTRS1987

A physical optics correction for backscattering from curved surfaces

The conventional physical optics (PO) approximation used to calculate the scattered fields from a conducting body leads to incorrect scattered fields even in the specular reflection region. This is true even when all other subdominant terms are assumed to be absent. The inaccuracy stems from the fact that the surface currents used in the PO approximation suddenly truncate at the shadow boundary of curved surfaces resulting in an erroneous contribution. Expressions for these shadow boundary (end point) contributions are presented in this paper. It is shown that if these end point contributions are substracted from the conventional PO results, one obtains a better representation of the true scattered field. For illustration, backscattered fields from various conducting bodies are computed using the corrected PO solution and are compared with the exact scattered fields.

Gupta, Inder J.↗

NASA NTRS1987

User manual for semi-circular compact range reflector code: Version 2

A computer code has been developed at the Ohio State University ElectroScience Laboratory to analyze a semi-circular paraboloidal reflector with or without a rolled edge at the top and a skirt at the bottom. The code can be used to compute the total near field of the reflector or its individual components at a given distance from the center of the paraboloid. The code computes the fields along a radial, horizontal, vertical or axial cut at that distance. Thus, it is very effective in computing the size of the sweet spot for a semi-circular compact range reflector. This report describes the operation of the code. Various input and output statements are explained. Some results obtained using the computer code are presented to illustrate the code's capability as well as being samples of input/output sets.

Gupta, Inder J.↗

NASA NTRS1986

SMI adaptive antenna arrays for weak interfering signals

The performance of adaptive antenna arrays in the presence of weak interfering signals (below thermal noise) is studied. It is shown that a conventional adaptive antenna array sample matrix inversion (SMI) algorithm is unable to suppress such interfering signals. To overcome this problem, the SMI algorithm is modified. In the modified algorithm, the covariance matrix is redefined such that the effect of thermal noise on the weights of adaptive arrays is reduced. Thus, the weights are dictated by relatively weak signals. It is shown that the modified algorithm provides the desired interference protection.

Gupta, Inder J.↗

NASA NTRS1986

User's manual for semi-circular compact range reflector code

A computer code was developed to analyze a semi-circular paraboloidal reflector antenna with a rolled edge at the top and a skirt at the bottom. The code can be used to compute the total near field of the antenna or its individual components at a given distance from the center of the paraboloid. Thus, it is very effective in computing the size of the sweet spot for RCS or antenna measurement. The operation of the code is described. Various input and output statements are explained. Some results obtained using the computer code are presented to illustrate the code's capability as well as being samples of input/output sets.

Gupta, Inder J.↗