Search NASA⌕ Search

Engineering topics

Gupta, S. K.

Publications and source records attributed to Gupta, S. K..

34 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1983

Estimation of clear-sky insolation using satellite and ground meteorological data

Ground based pyranometer measurements were combined with meteorological data from the Tiros N satellite in order to estimate clear-sky insolations at five U.S. sites for five weeks during the spring of 1979. The estimates were used to develop a semi-empirical model of clear-sky insolation for the interpretation of input data from the Tiros Operational Vertical Sounder (TOVS). Using only satellite data, the estimated standard errors in the model were about 2 percent. The introduction of ground based data reduced errors to around 1 percent. It is shown that although the errors in the model were reduced by only 1 percent, TOVS data products are still adequate for estimating clear-sky insolation.

Staylor, W. F.↗
NASA NTRS1982

Design and development of a ceramic radial turbine for the AGT101

An acceptable and feasible ceramic turbine wheel design has been achieved, and the relevant temperature, stress, and success probability analyses are discussed. The design is described, the materials selection presented, and the engine cycle conditions analysis parameters shown. Measured MOR four-point strengths are indicated for room and elevated temperatures, and engine conditions are analyzed for various cycle states, materials, power states, turbine inlet temperatures, and speeds. An advanced gas turbine ceramic turbine rotor thermal and stress model is developed, and cumulative probability of survival is shown for first and third-year properties of SiC and Si3N4 rotors under different operating conditions, computed for both blade and hub regions. Temperature and stress distributions for steady-state and worst-case shutdown transients are depicted.

Finger, D. G.↗
NASA NTRS1978

Parameterization of surface temperature retrieval for remote sensing experiments

The paper describes a parameterization procedure for determining the actual surface temperature from the effective brightness temperature measured radiometrically in the 11-micron window region. The algorithm permits computation of the atmospheric correction without performing detailed radiative transfer calculations, and corrections for atmospheric water vapor and for variations of surface emittance are explained. The parameterization is based on model calculations performed with a line-by-line radiative transfer program, and the sensitivity of the retrieved surface temperature to uncertainties concerning the water vapor and the surface emittance is examined.

Tiwari, S. N.↗
NASA NTRS1978

Estimation of surface temperature in remote pollution measurement experiments

A simple algorithm has been developed for estimating the actual surface temperature by applying corrections to the effective brightness temperature measured by radiometers mounted on remote sensing platforms. Corrections to effective brightness temperature are computed using an accurate radiative transfer model for the 'basic atmosphere' and several modifications of this caused by deviations of the various atmospheric and surface parameters from their base model values. Model calculations are employed to establish simple analytical relations between the deviations of these parameters and the additional temperature corrections required to compensate for them. Effects of simultaneous variation of two parameters are also examined. Use of these analytical relations instead of detailed radiative transfer calculations for routine data analysis results in a severalfold reduction in computation costs.

Gupta, S. K.↗
NASA NTRS1978

Longwave radiative transfer in the atmosphere

The reported investigation has the objective to develop an accurate radiative transfer model for the thermal infrared region using a quasi-random band model. It is intended to use this model to examine the sensitivity of the outgoing radiance and flux density to the perturbations of such meteorological parameters on the surface emittance and temperature, atmospheric water vapor distribution, cloud altitude and fractional cover, and the concentrations of other infrared active constituents. It is found that the combined effect of N2O and CH4 on the flux is significant and exceeds 1 percent. These two constituents should, therefore, not be neglected in accurate modeling work. The effect of ozone on the flux is too large to be neglected and was partly responsible for the discrepancy between earlier model results and measurements. The effect of cloud depth should be taken into account to obtain better agreement with the measured limb darkening functions.

Gupta, S. K.↗
NASA NTRS1978

Ground temperature measurement by PRT-5 for maps experiment

A simple algorithm and computer program were developed for determining the actual surface temperature from the effective brightness temperature as measured remotely by a radiation thermometer called PRT-5. This procedure allows the computation of atmospheric correction to the effective brightness temperature without performing detailed radiative transfer calculations. Model radiative transfer calculations were performed to compute atmospheric corrections for several values of the surface and atmospheric parameters individually and in combination. Polynomial regressions were performed between the magnitudes or deviations of these parameters and the corresponding computed corrections to establish simple analytical relations between them. Analytical relations were also developed to represent combined correction for simultaneous variation of parameters in terms of their individual corrections.

Gupta, S. K.↗
NASA NTRS1978

Longwave radiative transfer in the atmosphere

The reported investigation had the objective to develop an accurate radiative transfer model for the thermal infrared region using a quasi-random band model. It is intended to use this model to examine the sensitivity of the outgoing radiance and flux density to the perturbations of such meteorological parameters as the surface emittance and temperature, atmospheric water vapor distribution, cloud altitude and fractional cover, and the concentrations of other infrared active constituents. The outgoing infrared flux and limb darkening functions obtained from this model agree well with the satellite measured data. Important sensitivity parameters obtained agree with the results of the various empirical and theoretical models. It is concluded that the effect of cloud depth should be taken into account to obtain better agreement with the measured limb darkening functions.

Gupta, S. K.↗
NASA NTRS1977

Accurate spectral modeling for infrared radiation

Direct line-by-line integration and quasi-random band model techniques are employed to calculate the spectral transmittance and total band absorptance of 4.7 micron CO, 4.3 micron CO2, 15 micron CO2, and 5.35 micron NO bands. Results are obtained for different pressures, temperatures, and path lengths. These are compared with available theoretical and experimental investigations. For each gas, extensive tabulations of results are presented for comparative purposes. In almost all cases, line-by-line results are found to be in excellent agreement with the experimental values. The range of validity of other models and correlations are discussed.

Tiwari, S. N.↗
NASA NTRS1977

Remote estimation of surface temperature in pollution measurement experiments

The procedure described was developed for inferring the effective brightness temperature (EBT) of the underlying surface (at a given altitude) from the computed value of the radiance corresponding to a known surface temperature. A standard temperature correction to EBT (termed 'base correction') is first determined by using a 'base model atmosphere' for computing the upwelling radiance. Additional temperature corrections are then determined by considering several variations of the different surface and atmospheric parameters from their 'base model' values. Empirical relations are derived between the deviations of various surface and atmospheric parameters (from their base model values) and the additional corrections required for the EBT as a result of these variations. Use of such relations for large-scale data reduction, instead of radiative transfer calculations, is expected to result in drastic cost decrease.

Gupta, S. K.↗
NASA NTRS1976

Evaluation of upwelling infrared radiance from the earth's troposphere

Basic equations for calculating the upwelling atmospheric radiance are presented. Theoretical formulation of the transmittance models (line-by-line and quasi-random band) and computational procedures for the evaluation of transmittance and radiance are discussed. This information is useful in the interpretation of the data obtained from measuring gaseous pollutants in the troposphere.

Tiwari, S. N.↗
NASA NTRS1976

Retrieval of surface temperature by remote sensing

A simple procedure and computer program were developed for retrieving the surface temperature from the measurement of upwelling infrared radiance in a single spectral region in the atmosphere. The program evaluates the total upwelling radiance at any altitude in the region of the CO fundamental band (2070-2220 1/cm) for several values of surface temperature. Actual surface temperature is inferred by interpolation of the measured upwelling radiance between the computed values of radiance for the same altitude. Sensitivity calculations were made to determine the effect of uncertainty in various surface, atmospheric and experimental parameters on the inferred value of surface temperature. It is found that the uncertainties in water vapor concentration and surface emittance are the most important factors affecting the accuracy of the inferred value of surface temperature.

Gupta, S. K.↗
NASA NTRS1976

Evaluation of transmittance of selected infrared bands

Computer programs were developed for evaluating homogeneous path transmittance with line-by-line and quasi-random band model formulations. Spectral transmittances for some selected bands of different gases (CO, N2O, CO2, H2O) were obtained using these programs. Results of theoretical computations are compared with available experimental measurements. Significant errors are observed in the results obtained from a quasi-random band model formulation, indicating that it is inadequate to meet the accuracy requirements for atmospheric work.

Gupta, S. K.↗
NASA NTRS1975

Evaluation of upwelling infrared radiance from earth's atmosphere

Basic equations for calculating the upwelling atmospheric radiation are presented which account for various sources of radiation coming out at the top of the atmosphere. The theoretical formulation of the transmittance models (line-by-line and quasi-random band model) and the computational procedures used for the evaluation of the transmittance and radiance are discussed in detail. By employing the Lorentz line-by-line and quasi-random computer programs, model calculations were made to determine the upwelling radiance and signal change in the wave number interval of CO fundamental band. These results are useful in determining the effects of different interfering molecules, water vapor profiles, ground temperatures, and ground emittances on the upwelling radiance and signal change. This information is of vital importance in establishing the feasibility of measuring the concentrations of pollutants in the atmosphere from a gas filter correlation instrument flown on an aircraft or mounted on a satellite.

Gupta, S. K.↗
NASA NTRS1975

Preferential concentration of certain elements in smaller aerosols emitted from aircraft engines

Aerosols from aircraft engines were collected with an eight-stage cascade sampler for a period of 24 h. The aerosol samples from each stage were analyzed for their elemental composition using the proton-induced X-ray emission (PIXE) technique. Seventeen elements (Si, P, S, Cl, K, Ca, Ti, V, Fe, Ni, Cu, Zn, Br, Sr, Nb, Sn, and Pb) were positively identified and quantitated at each stage. Six elements (S, Ca, Fe, Zn, Sn, and Pb) showed a fractional concentration increase with decreasing aerosol size. Similar, but less well-defined, trends were also observed for V and Ni. Silicon and chlorine, on the other hand, showed an opposite trend. Neutron-activation analysis of bulk aerosol samples collected every 2 h over the same period showed a correlation between concentration of Si, Ca, V, Ti, Zn, Br, and Sn and the density of air traffic at the airport. Analysis of the aviation-fuel samples by PIXE indicates that major fractions of Pb, Sn, Br, Zn, Ni, Fe, V, Ca, and S observed in these aerosol studies come from the aircraft engine exhaust.

Jolly, R. K.↗
NASA NTRS1973

On the measurement of Rayleigh scattering by gases at 6328A

The problem of laboratory measurements of Rayleigh scattering and depolarization ratio for atoms and molecules in the gaseous state is described. It is shown that, if the scattered radiation measurements are made at two angles, the normal depolarization ratio cannot be determined meaningfully. However, from scattering measurements, the Rayleigh scattering cross sections can be determined accurately. The measurements of Raleigh scattering from He, H2, Ar, O2, and N2 for unpolarized radiation at 6328A are reported and compared with similar measurements at 6943 and 1215.7A.

SHARDANAND↗