Search NASA⌕ Search

Engineering topics

Hall, R. M.

Publications and source records attributed to Hall, R. M..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2003

Recommended Experimental Procedures for Evaluation of Abrupt Wing Stall Characteristics

This paper presents a review of the experimental program under the Abrupt Wing Stall (AWS) Program. Candidate figures of merit from conventional static tunnel tests are summarized and correlated with data obtained in unique free-to-roll tests. Where possible, free-to-roll results are also correlated with flight data. Based on extensive studies of static experimental figures of merit in the Abrupt Wing Stall Program for four different aircraft configurations, no one specific figure of merit consistently flagged a warning of potential lateral activity when actual activity was seen to occur in the free-to-roll experiments. However, these studies pointed out the importance of measuring and recording the root mean square signals of the force balance.

Capone, F. J.↗
NASA NTRS2003

Development of a Free-to-Roll Transonic Test Capability (Invited)

As part of the NASA/Navy Abrupt Wing Stall Program, a relatively low-cost, rapid-access wind-tunnel free-to-roll rig was developed. This rig combines the use of conventional models and test apparatuses to evaluate both transonic performance and wing-drop/rock tendencies in a single tunnel entry. A description of the test hardware as well as a description of the experimental procedures is given. The free-to-roll test rig has been used successfully to assess the static and dynamic characteristics of three different configurations--two configurations that exhibit uncommanded lateral motions, (pre-production F/A-18E and AV-8B), and one that did not (F/A-18C).

Capone, F. J.↗
NASA NTRS2003

AWS Figure of Merit (FOM) Developed Parameters from Static, Transonic Model Tests

This paper provides an approach to answer the question of whether one can rely solely on static data taken during a transonic model test to provide the certainty needed that a new aircraft will or will not have Abrupt Wing Stall (AWS) events during its flight operations. By comparing traditional- and alternate-static-Figures of Merit (FOMs) with the Free-To-Roll (FTR) response data, a rational basis for assessing the merits of using standard testing techniques for the prediction of AWS events has been established. Using the FTR response data as a standard, since these results compare well with flight, the conclusion from this study is that neither traditional nor alternate FOMs can be trusted to provide an indication as to whether a configuration will or will not have AWS tendencies. Even though these FOMs may flag features which have a high degree of correlation with the FTR response data, there are as many or more of these FOM flagged features which do not correlate. Thus, one needs to use the FTR rig to assess AWS tendencies on new configurations.

Lamar, J. E.↗
NASA NTRS2002

Investigation of Reynolds Number Effects on a Generic Fighter Configuration in the National Transonic Facility

A wind tunnel test of a generic fighter configuration was tested in the National Transonic Facility through a cooperative agreement between NASA Langley Research Center and McDonnell Douglas. The primary purpose of the test was to assess Reynolds number scale effects on a thin-wing, fighter-type configuration up to full-scale flight conditions (that is, Reynolds numbers of the order of 60 million). The test included longitudinal and lateral/directional studies at subsonic and transonic conditions across a range of Reynolds numbers from that available in conventional wind tunnels to flight conditions. Results are presented for three Mach numbers (0.6, 0.8, and 0.9) and three configurations: (1) Fuselage/Wing; (2) Fuselage/Wing/Centerline Vertical Tail/Horizontal Tail; and (3) Fuselage/Wing/Trailing-Edge Extension/Twin Vertical Tails. Reynolds number effects on the longitudinal aerodynamic characteristics are presented herein.

Tomek, W. G.↗
NASA NTRS1990

Impact of nose-probe chines on the vortex flows about the F-16C

A 1/15-scale model of the F-16C aircraft was tested at subsonic and transonic speeds to determine the effects of small nose-probe chines on the high angle-of-attack aerodynamic and stability characteristics. Off-body flow visualization using a laser vapor screen technique and six-component forces and moments were obtained at freestream Mach numbers of 0.30, 0.60, and 0.80. The nose-probe chines generated strong vortices interacting with the vortices generated over the smooth forebody or over the strakes. These vortices in turn led to global flow unsteadiness and model dynamics at the high angles of attack. The test results underscore the sensitivity of the high angle-of-attack flow field to small geometry changes in the nose region.

Hall, R. M.↗
NASA NTRS1989

Navier-Stokes solutions for vortical flows over a tangent-ogive cylinder

Reynolds number (Re) effects on low-speed vortical flows over a 3.5 caliber tangent-ogive cylinders at two angles of attack (alpha = 20 and alpha = 30 degrees) are computationally assessed for Re(D) = 0.2 -3.0 million (D: maximum diameter). The flow field results are steady-state solutions to the three-dimensional, incompressible Navier-Stokes equations in their thin-layer approximation. Using a properly modified algebraic turbulence model, the numerical results are in good to excellent agreement with experiments.

Hartwich, PETER-M.↗
NASA NTRS1989

Comparisons of boundary-layer transition measurement techniques in the Langley Unitary Plan wind tunnel

Four different boundary-layer transition detection techniques, namely liquid crystals, very thin hot films, IR photography, and an optical interferometer, were compared using the same flat plate model for the same tunnel conditions. The comparisons, conducted at NASA-Langley, involved not only their sensitivity to transition but also their ease of use. The thin films, as expected, gave excellent quantitative information and were used as the standard for evaluating the other techniques. Both the liquid crystals and IR photography were able to detect transition before the boundary-layer intermittency factor had reached 50 percent. The optical interferometer was unsuccessful. Conditions sampled included a range of Mach numbers from 1.5 to 2.5 and unit Reynolds numbers from 1.0 to 4.0 million/foot.

Hall, R. M.↗
NASA NTRS1988

Low-speed vortical flow over a 5-degree cone with tip geometry variations

Experimental results on the surface pressures and sectional side forces on a 5-deg cone were obtained for the cases of three different nose tips. The sectional side force data for both the sharp cone and the blunt nose cone configurations showed a dependence on roll orientation. The blunt nose configurations were found to be effective in reducing the sectional side force for angles of attack up to 25 deg.

Chu, J.↗
NASA NTRS1987

Optical boundary-layer transition detection in a transonic wind tunnel

A high-sensitivity interferometer has been developed and used to detect boundary-layer transitions over a symmetric airfoil. The tests, which included both natural and roughness-induced transitions, were performed in a transonic wind tunnel. The measurements showed a peak amplitude rms and higher energy in the spectrum of the signal associated with transition. The tests revealed that the interferometer system can be used to locate the transition region over three-dimensional aerodynamic models.

Azzazy, M.↗
NASA NTRS1986

Studies of condensation effects on airfoil testing in the Langley 0.3-meter transonic cryogenic tunnel

In the context of an overall development of transonic, cryogenic wnd tunnel technology, NASA has been investigating the onset of condensation effects in nitrogen gas. The temperature at which condensation occurs determines the minimum operating temperature (MOT) of cryogenic tunnels. The apparatus and airfoils are discussed, taking into account a description of the 0.3-m Transonic Cryogenic Tunnel (TCT), the drag rake, the airfoils, and the technique used for determining the onset of condensation effects. Attention is also given to the types of nucleation processes, the relative sensitivity of drag rake and surface pressure measurements, correlations between data and theory, the prediction of minimum operating temperatures for the 0.3-m TCT, and MOT's for different tunnels.

Hall, R. M.↗
NASA NTRS1986

Influence of forebody cross-sectional shape on wing vortex burst location

A water tunnel study examining the influence of forebody cross section on the position of the wing vortex burst was carried out in the NASA Ames-Dryden water tunnel for a 55-deg cropped delta-wing model. Two of three cross sections investigated were chine-shaped, where the included angle of the chine was either 7.5-deg, representing a rather small side-edge angle, or 90 deg, representing a more moderate design. The third cross section was circular and served as a baseline for comparison. It is found that the 7.5 deg chine cross section generated the strongest forebody vortices of the three configurations and that these strong forebody vortices interacted with the main wing vortices in such a manner as to dramatically delay wing vortex burst position at zero sideslip. If the configuration is sideslipped, large asymmetries in wing vortex burst location may result.

Hall, R. M.↗
NASA NTRS1985

Studies of condensation effects on airfoil testing in a transonic cryogenic tunnel

In the context of an overall development of transonic, cryogenic wind tunnel technology, NASA has been investigating the onset of condensation effects in nitrogen gas. The temperature at which condensation occurs determines the minimum operating temperature (MOT) of cryogenic tunnels. The apparatus and airfoils are discussed, taking into account a description of the 0.3-m Transonic Cryogenic Tunnel (TCT), the drag rake, the airfoils, and the technique used for determining the onset of condensation effects. Attention is also given to the types of nucleation processes, the relative sensitivity of drag rake and surface pressure measurements, correlations between data and theory, the prediction of minimum operating temperatures for the 0.3-m TCT, and MOT's for different tunnels.

Hall, R. M.↗
NASA NTRS1984

Pre-existing seed particles and the onset of condensation in cryogenic wind tunnels

The condensation research at NASA Langley Research Center has used a variety of experimental approaches to gather information on seed particles that can act as sites for condensation growth. Total pressure measurements have suggested that condensation growth is caused by impurities in the flow and not by unevaporated liquid nitrogen (LN2) droplets resulting from the LN2 injected to cool the 0.3-Meter Transonic Cryogenic Tunnel. A separate test with an optical droplet sizing probe, which was designed to detect droplets in the 2- to 300-micron range, confirmed the conclusions from the total pressure measurements and also discovered what appears to be solidified oil droplets having diameters of about 3 microns. These oil droplets appear to be the dominant source of seed particles above 2 microns. However, computer simulations of static pressure test data suggest that the measured condensation effects are the result of more numerous, smaller seeds with number densities on the order of 10 to the 12th per kilogram of the gas and diameters on the order of 0.5 microns.

Hall, R. M.↗
NASA NTRS1982

Homogeneous and heterogeneous condensation of nitrogen in transonic flow

Onset of both homogeneous and heterogeneous nucleation for nitrogen gas has been measured in the Langley 0.3m Transonic Cryogenic Tunnel. Homogeneous nucleation data have been taken using a DFVLR CAST-10 airfoil and are used to evaluate classical liquid droplet theory and several proposed corrections to it. A correction for differences in translational energy states between the droplet and the bulk liquid due to either Reiss (1977) or Kikuchi (1977) achieves good agreement between the predicted onset of nucleation and the data. Good agreement is also found using a Tolman constant of 0.25 x 10 to the -10th m. Onset of heterogeneous nucleation on pre-existing seed particles in the flow has also been studied, and preliminary estimates of seed size and number are 0.25 x 10 to the -6th m and 3.0 x 10 to the 12th per kilogram of the gas. It is shown that this preexisting seed population is insufficient to influence the observed onset of homogeneous nucleation.

Hall, R. M.↗