Engineering topics

Hauser, J. R.

Publications and source records attributed to Hauser, J. R..

At least 19 records

NASA NTRS1984

Inflight evaluation of four measures of pilot workload

Four measures of pilot workload were tested in the NASA C-141 Kuiper Airborne Observatory. The measured included a communications analysis, subjective ratings of workload, subjective ratings of additional factors related to workload, and heart rate. Data were collected for 11 flights, each of which lasted approximately seven hours. Heart rate was found to be significantly higher for the pilot who was flying than for the pilot who was not flying and it varied significantly across flight segments, peaking during landing and take off, particularly for the pilot in the left seat who was resonsible for aircraft control. For both left and right seats, the subjective assessment of stress rather than the subjective assessment of workload was significantly correlated with variation in heart rate. Frequencies of different types of communications varied significantly across segments of flight, however, they were not correlated with subjective ratings of workload. There was a significant difference between the left and right seats in the types of activities that contributed to their workload, however, workload was considered to be equivalent for the two.

Hart, S. G.↗

NASA NTRS1979

A theoretical study of heterojunction and graded band gap type solar cells

The work performed concentrated on including multisun effects, high temperature effects, and electron irradiation effects into the computer analysis program for heterojunction and graded bandgap solar cells. These objectives were accomplished and the program is now available for such calculations.

Chiang, J. P. C.↗

NASA NTRS1979

A theoretical analysis of the current-voltage characteristics of solar cells

The following topics are discussed: (1) dark current-voltage characteristics of solar cells; (2) high efficiency silicon solar cells; (3) short circuit current density as a function of temperature and the radiation intensity; (4) Keldysh-Franz effects and silicon solar cells; (5) thin silicon solar cells; (6) optimum solar cell designs for concentrated sunlight; (7) nonuniform illumination effects of a solar cell; and (8) high-low junction emitter solar cells.

Fang, R. C. Y.↗

NASA NTRS1979

Optimum bandgap of several III-V heterojunction solar cells

Results of computer analysis of AlAs/Ga(1-x)As n-on-p heterojunction solar cells are presented with particular consideration given to interface recombination effects. It is found that, for an AlAs window layer, GaAs appears to be the optimum semiconductor for the active layer. Furthermore, even if the interface recombination is neglected, GaAs comes so close to being the optimum III-V active layer material that the additional effort required to incorporate a few percent of InAs into the active layer appears to be much greater than any expected efficiency increase.

Sutherland, J. E.↗

NASA NTRS1978

A two dimensional analysis of sheet resistance and contact resistance effects in solar cells

A computer model is developed to study the two-dimensional nature of the sheet resistance and contact resistance effects in solar cells. A major result is the demonstration that the distributed nature of the semiconductor sheet resistance causes the terminal dark I-V characteristics to exhibit an exp(qV/2kT) type dependence even when the one-dimensional characteristics of the cell exhibit an exp(qV/kT) type voltage dependence. The analytical model which is developed provides an easy method for estimating the sheet resistance of a solar cell from the terminal I-V data.

Fang, C. R.↗

NASA NTRS1978

Comparison of theoretical and experimental solar cell performance

This paper presents the results of a detailed comparison between the theoretically predicted performance of silicon solar cells and the experimentally observed performance. The comparison has included the dark I-V characteristics, the spectral response characteristics and the I-V characteristics under AM0 illumination. In general it has been found that the agreement between theory and experimental behavior is very good. This good agreement has been obtained for a variety of cells fabricated with junction depths ranging from 0.1 micron to more than 1 micron and for base layer resistivities from 10 to 0.1 ohm-cm.

Fang, C. R.↗

NASA NTRS1977

A theoretical analysis of the current-voltage characteristics of solar cells

The correlation of theoretical and experimental data is discussed along with the development of a complete solar cell analysis. The dark current-voltage characteristics, and the parameters for solar cells are analyzed. The series resistance, and impurity gradient effects on solar cells were studied, the effects of nonuniformities on solar cell performance were analyzed.

Fang, R. C. Y.↗

NASA NTRS1977

Theoretical effects of surface diffused region lifetime models on silicon solar cells

A computer simulation of silicon solar cells has indicated that the combination of band gap reduction due to heavy doping and certain spatial forms of lifetime dependence can combine to form severe limitations on the open-circuit voltage of such cells. The interaction of these effects tends to shift the active region of the diffused surface layer away from the injecting junction, resulting in an increase in the current density injected into the surface region. Reductions in open circuit voltage as great as 10% over models which do not include these effects can be seen.

Dunbar, P. M.↗

NASA NTRS1977

A theoretical study of heterojunction and graded band gap type solar cells

A computer program was designed for the analysis of variable composition solar cells and applied to several proposed solar cell structures using appropriate semiconductor materials. The program simulates solar cells made of a ternary alloy of two binary semiconductors with an arbitrary composition profile, and an abrupt or Gaussian doping profile of polarity n-on-p or p-on-n with arbitrary doping levels. Once the device structure is specified, the program numerically solves a complete set of differential equations and calculates electrostatic potential, quasi-Fermi levels, carrier concentrations and current densities, total current density and efficiency as functions of terminal voltage and position within the cell. These results are then recorded by computer in tabulated or plotted form for interpretation by the user.

Sutherland, J. E.↗

NASA NTRS1977

Performance limitations of silicon solar cells

This paper discusses the performance limitations of silicon solar cells which have been identified and investigated using a detailed numerical analysis of solar cell operation. Efficiency limitations are discussed as related to doping densities, minority carrier lifetimes, widths of solar cell regions, surface recombination, antireflecting layers, and ohmic contact stripes. Areas in which improvements can be expected in performance are identified and discussed.

Hauser, J. R.↗

NASA NTRS1977

A computer analysis of heterojunction and graded composition solar cells

The development and application of a variable composition solar cell computer analysis program is discussed. The basic device equations are derived and results of the computer analysis of several Al(x)Ga(1-x)As and GaAs(1-x)P(x) solar cell structures are presented along with a discussion of the effects of interface states and various composition and doping profiles on maximum solar cell efficiency. Interface states are found to be responsible for a severe reduction in the efficiency of GaAs(1-x)P(x) cells, but do not significantly affect the behavior of Al(x)Ga(1-x)As cells. The depth of the p-n junction below the wide bandgap window layer is a critical factor in determining the loss of minority carriers to interface recombination at the heterojunction.

Sutherland, J. E.↗

NASA NTRS1977

Impurity gradients and high efficiency solar cells

One potential means of improving the efficiency of solar cells especially after space irradiation is to incorporate built-in fields into the device through the use of impurity doping gradients. A detailed numerical calculation of solar cell performance has been used to study various types of doping gradients. In general, the predicted improvements in performance have been less than previously reported due to various device effects such as, high injection and the dependence of lifetime on doping density.

Fang, C. R.↗

NASA NTRS1976

A theoretical analysis of the current-voltage characteristics of solar cells

Various mechanisms which limit the conversion efficiency of silicon solar cells were studied. The effects of changes in solar cell geometry such as layer thickness on performance were examined. The effects of various antireflecting layers were also examined. It was found that any single film antireflecting layer results in a significant surface loss of photons. The use of surface texturing techniques or low loss antireflecting layers can enhance by several percentage points the conversion efficiency of silicon cells. The basic differences between n(+)-p-p(+) and p(+)-n-n(+) cells are treated. A significant part of the study was devoted to the importance of surface region lifetime and heavy doping effects on efficiency. Heavy doping bandgap reduction effects are enhanced by low surface layer lifetimes, and conversely, the reduction in solar cell efficiency due to low surface layer lifetime is further enhanced by heavy doping effects. A series of computer studies is reported which seeks to determine the best cell structure and doping levels for maximum efficiency.

Dunbar, P. M.↗

NASA NTRS1976

A theoretical study of heterojunction and graded band gap type solar cells

The theory of heterojunction and graded bandgap solar cells was studied to help determine the material compositions and device dimensions needed for high efficiency solar cells. Because of the involved analysis of the fundamental equations describing solar cell operation, a general numerical device analysis program was used. A major part of the initial work was involved in modifying an existing silicon solar cell analysis program to account for the unique features of graded bandgap and heterojunction solar cells. The most successful III-V solar cells have so far been constructed in the GaAs and Gal-xAlxAs material systems; this project was concerned with such solar cells. The most efficient solar cell so far evaluated is an abrupt heterojunction cell with a pure AlAs layer at the surface with a GaAs substrate. The predicted efficiency for this cell is slightly larger than that of a graded bandgap Gal-xAlxAs solar cell.

Hauser, J. R.↗

NASA NTRS1976

A study of efficiency in low resistivity silicon solar cells

A general device-analysis program has been utilized to study the efficiency of silicon solar cells. The analysis is applied to specific geometries of both n(+)-p and n(+)-p-p(+) solar cells, and involves a numerical solution of the basic transport and continuity equations. This approach allows solutions that are free of typical limiting assumptions involved in solving the device equations as well as solutions relating to lifetime, mobility variations, and diffused-region profiles. The analysis includes available empirical information on diffusion length, mobility, and lifetime as a function of doping, as well as a Gaussian profile for the diffused region. Results are presented which illustrate the limitations of efficiency as a function of doping. It is found that the maximum efficiencies for both types of cell converge at lower resistivities to around 16% with air-mass-zero radiation and a single-layer absorbing-SiO antireflecting film. It is also found that the minority-carrier lifetime, both in the n(+) surface and p-type bulk regions, presents serious limitations to conversion efficiency, particularly in the low-resistivity cells.

Dunbar, P. M.↗

NASA NTRS1976

A study of improvements in silicon solar cell efficiency due to various geometrical and doping modifications

This paper presents the results of continued studies of silicon solar cell operation and limitations. The objective of this paper is to report on geometrical and doping changes in silicon solar cells which result in predictions of high efficiencies. Efficiencies as high as 20 per cent (uncorrected for metal coverage and ohmic sheet resistance) have been calculated for optimized cells. The conditions required to achieve these efficiency values are discussed.

Dunbar, P. M.↗

NASA NTRS1976

Computer analysis of heterojunction and graded bandgap solar cells

The development and application of a graded bandgap solar cell computer analysis program is discussed. The basic device equations as used in the computer analysis are discussed and the techniques used to model material parameter variations are described. Finally, the results of the computer analysis of several Al(x)Ga(1-x)As and GaAs(1-x)P(x) solar cell structures are presented along with a discussion of the effects of interface states and various composition profiles on maximum solar cell efficiency.

Sutherland, J. E.↗

NASA NTRS1975

Ion implanted photodiode detectors in epitaxial /Ga/x/In/1-x//As

Ion implanted p-n junction photodiodes in epitaxially grown (Ga(x)In(1-x))As material are reported on here. Photoresponse in these diodes was investigated for approximately the entire composition range of x between zero and one. High values for quantum efficiency were obtained for the devices with a high value of x.

Ajmera, P. K.↗