Search NASASearch

Engineering topics

Honnell, M. A.

Publications and source records attributed to Honnell, M. A..

At least 19 records

Measured spectral amplitude of lightning sferics in the HF, VHF, and UHF bands

An experimental study was carried out to measure the spectral amplitude of lightning sferics at 22.5 MHz, 225 MHz, and 2.25 GHz. This effort included the detection, storage, and analysis of RF emission data to accurately determine the relative electric field strength produced by the lightning associated with a typical local thunderstorm. These measured spectral amplitudes are normalized and plotted relative to similar data from other investigators. These data support a 1/F to the 2nd to 1/F to the 3rd slope for sferics at frequencies above the HF range.

Shumpert, T. H.

Measurement of RF lightning emissions

A lightning radio emission observation laboratory is described. The signals observed and recorded include HF, VHF and UHF radio emissions, optical signature, electric field measurements, and thunder. The objectives of the station, the equipment used, and the recording methods are discussed.

Lott, G. K., Jr.

Analysis of a parallel-arrayed power regulating system

A power regulation system incorporating n-parallel power supplies employing PWM switching regulators is studied. Analysis of individual unit operation and coupled-system parameter sensitivity is considered from an operations viewpoint. A detailed example is included to illustrate parallel system operation for 18 such units powered by solar-cell banks.

Colburn, B. K.

The state of technology in electromagnetic (RF) sensors (for lightning detection)

A brief overview of the radio-frequency sensors which were applied to the detection, isolation, and/or identification of the transient electromagnetic energy (sferics) radiated from one or more lightning discharges in the atmosphere is presented. Radio frequency (RF) characteristics of lightning discharges, general RF sensor (antenna) characteristics, sensors and systems previously used for sferic detection, electromagnetic pulse sensors are discussed. References containing extensive bibliographies concerning lightning are presented.

Shumpert, T. H.

FM oscillator has improved deviation linearity

Device can be obtained by driving basic circuit through nonlinear FET input stage. Frequency of VCO is linearized with FET and total variance is varactor controlled. Experimental device exhibited linearity of better than plus or minus one percent for total frequency of plus or minus 10 millihertz.

Honnell, M. A.

Improving FM transmitter power and efficiency

Amplifier tracks oscillator frequency allowing narrow band high Q circuit to be used, increasing wide deviation FM transmission efficiency and power output, and suppressing spurious output frequencies system. Tracking oscillator and amplifier act like wideband circuitry with narrow-band advantages.

Honnell, M. A.

Frequency modulated oscillator

A frequency modulated push-pull oscillator in which the non-linear characteristic of varactors producing frequency modulation is compensated for by an opposite non-linear characteristic of a field effect transistor providing modulating bias to the varactors is described.

Honnell, M. A.

Modulation linearization of a frequency-modulated voltage controlled oscillator, part 3

An analysis is presented for the voltage versus frequency characteristics of a varactor modulated VHF voltage controlled oscillator in which the frequency deviation is linearized by using the nonlinear characteristics of a field effect transistor as a signal amplifier. The equations developed are used to calculate the oscillator output frequency in terms of pertinent circuit parameters. It is shown that the nonlinearity exponent of the FET has a pronounced influence on frequency deviation linearity, whereas the junction exponent of the varactor controls total frequency deviation for a given input signal. A design example for a 250 MHz frequency modulated oscillator is presented.

Honnell, M. A.

A stable, linear frequency-modulated oscillator, part 1

The development of a push-pull frequency-modulated oscillator employing field-effect transistors is described. The advantages of field-effect transistors for use in a frequency-stable oscillator are presented. Linearization of the frequency deviation was accomplished by utilizing the square-law characteristic of an FET used as a modulating amplifier. The push-pull oscillator model produced a linear frequency deviation of more than 10 MHz at a center frequency of approximately 100 MHz. Output power is within 0.6 db of a nominal +8.5 dBm over the desired frequency range, and the modulation bandwidth is dc to 10 MHz. Frequency variation with temperature after compensation with a negative-temperature-coefficient capacitor is within + or - 0.05% from 0 to 60 C.

Honnell, M. A.

A digital mixer, part 2

A study was made to determine the characteristic response of D flip-flop digital logic units used as mixing devices for telemetry applications. The D flip-flop is shown to perform the mixing operation under a variety of input frequency conditions. The output signal is a rectangular wave whose long term average frequency is the desired difference frequency. The output signal contains frequency jitter which is a function of the relationship between the two input frequencies. The seriousness of the jitter depends on the application.

Honnell, M. A.

Automatic frequency control for FM transmitter

An automatic frequency control circuit for an FM television transmitter is described. The frequency of the transmitter is sampled during what is termed the back porch portion of the horizontal synchronizing pulse which occurs during the retrace interval, the frequency sample compared with the frequency of a reference oscillator, and a correction applied to the frequency of the transmitter during this portion of the retrace interval.

Honnell, M. A.

A study of power conditioning and power distribution and components

A comprehensive simulation and analysis performed on the operation of the regulator part of the Charger/Battery/Regulator Module (CBRM) are detailed. The CBRM is utilized as an integral component of the Skylab/Apollo Telescope Mount (ATM) electrical power system and contains a switching mode electronic regulator. Implementing circuit analysis techniques, pertinent voltages and currents are calculated; these, in turn, are incorporated into the regulator system study. Investigation of the turn-on and turn-off times associated with the switching circuitry is performed and an examination is made on these calculations. A simulation model computer program is utilized to generate graphs that relate various CBRM parameters to one another.

Horton, H. M.

Studies relating to FM television and telemetry transmitters

The Auburn University Model S-2 FM television transmitter was examined to determine if the performance and reliability could be improved by application of new techniques and devices developed since completion of the original design work. In particular this study examined the possibility of increased use of integrated circuits. It was determined that improvements in both performance and reliability were possible. In addition a study was conducted to determine the feasibility of converting the transmitter to handle telemetry signals. The study revealed that this conversion was feasible and the modifications were made to the prototype model for verification.

Albritton, W. P.