Engineering topics

Innis, R. C.

Publications and source records attributed to Innis, R. C..

At least 19 records

NASA NTRS1986

Flight evaluation of augmented controls for approach and landing of powered-lift aircraft

Flight experiments were conducted with Ames Research Center's Quiet Short-Haul Research Aircraft to evaluate the influence of highly augmented control modes on the ability of pilots to execute precision instrument flight operations in the terminal area, particularly approaches to and landings on a short runway. The aircraft is a powered-lift, short-takeoff and landing configuration that is equipped with a modern digital fly-by-wire flight control system, a head-up display, and a solar head-down display that make it possible to investigate control concepts and display format and content for full envelope, powered-lift operations. Considerable attention has been devoted in this flight program to assessing flightpath and airspeed command and stabilization modes developed using nonlinear, inverse model-following methods. The primary benefit of this control concept was realized when the pilot was required to execute a complex transition and approach under instrument conditions and in the presence of a wide range of wind and turbulence conditions.

Franklin, J. A.↗

NASA NTRS1986

Flight evaluation of a precision landing task for a powered-lift STOL aircraft

A flight research experiment was conducted with the NASA-Ames Research Center's Quiet Short-Haul Research Aircraft to determine the factors which influence the touchdown distribution for a powered-lift STOL aircraft. The pilots were given two tasks for each of a series of precision approaches flown using a microwave landing system (MLS) in simulated instrument meteorological conditions. They flew the aircraft, with forward vision obscured by a screen, to a 100-ft decision height using a flightpath-oriented, color electronic display and one of four levels of control augmentation. Approaches were flown along a nominal 6 deg glidepath, as well as to calibrated offsets at the decision height to establish a variety of initial conditions for the landing task. The screen was removed at the decision height and the pilot was briefed to land in a 200 foot touchdown zone of the STOLport with a sink rate less than 5 ft/sec. Statistical performance envelopes and pilot ratings are used to describe the results of this experiment. The data generated are expected to be useful for establishing STOL aircraft operating requirements and STOL MLS approach criteria.

Watson, D. M.↗

NASA NTRS1982

Flight experiments using the front-side control technique during piloted approach and landing in a powered lift STOL aircraft

The essential features of using pitch attitude for glidepath control in conjunction with longitudinal thrust modulation for speed control are described, using a simple linearized model for a powered-lift STOL aircraft operating on the backside of the drag curve and at a fixed setting of propulsive lift. It is shown that an automatic speed-hold system incorporating heave-damping augmentation can allow use of the front-side control technique with satisfactory handling qualities, and the results of previous flight investigations are reviewed. Manual control considerations, as they might be involved following failure of the automatic system, are emphasized. The influence of alternative cockpit controller configurations and flight-director display features were assessed for their effect on the control task, which consisted of a straight-in steep approach flown at constant speed in simulated instrument conditions.

Hindson, W. S.↗

NASA NTRS1982

Design criteria for flightpath and airspeed control for the approach and landing of STOL aircraft

A flight research program was conducted to assess requirements for flightpath and airspeed control for glide-slope tracking during a precision approach and for flare control, particularly as applied to powered-lift, short takeoff and landing (STOL) aircraft. Ames Research Center's Augmentor Wing Research Aircraft was used to fly approaches on a 7.5 deg glide slope to landings on a 30 X 518 m (100 X 1700 ft) STOL runway. The dominant aircraft response characteristics determined were flightpath overshoot, flightpath-airspeed coupling, and initial flightpath response time. The significant contribution to control of the landing flare using pitch attitude was the short-term flightpath response. The limiting condition for initial flightpath response time for flare control with thrust was also identified. It is possible to define flying-qualities design criteria for glide-slope and flare control based on the aforementioned response characteristics.

Franklin, J. A.↗

NASA NTRS1981

Powered-lift takeoff performance characteristics determined from flight test of the Quiet Short-haul Research Aircraft /QSRA/

A powered-lift, reduced thrust takeoff performance program utilizing quiet short-haul research aircraft has been conducted. It has been shown that the powered-lift upper surface blowing concept greatly enhances aircraft takeoff performance. The improvements include: (1) takeoff field lengths may be shortened by approximately 30%; (2) Air Force critical field lengths may be shortened by approximately 60%; (3) powered lift upper surface blowing aircraft have better handling and performance characteristics than comparable conventional aircraft; and (4) the low speeds associated with powered-lift takeoff enhance safety margins.

Riddle, D. W.↗

NASA NTRS1981

Powered-lift STOL aircraft shipboard operations - A comparison of simulation, land-based and sea trial results for the QSRA

A moving base carrier landing flight simulation using NASA's Quiet Short-Haul Research Aircraft (QSRA) was conducted during the design and fabrication of the QSRA. After completing its initial flight testing, the QSRA flew simulated carrier landings on land, followed by actual carrier landings at sea. This paper compares the simulated flight characteristics used in the flight simulation (using an aircraft math model based on wind tunnel data) with the aircraft flight characteristics obtained from flight test data. This paper also compares the results of the QSRA flight simulation carrier landings, the land based simulated carrier landings, and the actual carrier landings.

Stevens, V. C.↗

NASA NTRS1981

Flight evaluation of the STOL flare and landing during night operations

Simulated instrument approaches were made to Category 1 minimums followed by a visual landing on a 100 x 1700 ft STOL runway. Data were obtained for variations in the aircraft's flare response characteristics and control techniques and for different combinations of aircraft and runway lighting and a visual approach slope indication. With the complete aircraft and runway lighting and visual guidance no degradation in flying qualities or landing performance was observed compared to daylight operations. elimination of the touchdown zone floodlights or the aircraft landing lights led to somewhat greater pilot workload; however, the landing could still be accomplished successfully. Loss of both touchdown zone and aircraft landing lights led to a high workload situation and only a marginally adequate to inadequate landing capability.

Franklin, J. A.↗

NASA NTRS1981

Flight-test evaluation of STOL control and flight director concepts in a powered-lift aircraft flying curved decelerating approaches

Flight tests were carried out to assess the feasibility of piloted steep curved, and decelerating approach profiles in powered lift STOL aircraft. Several STOL control concepts representative of a variety of aircraft were evaluated in conjunction with suitably designed flight directions. The tests were carried out in a real navigation environment, employed special electronic cockpit displays, and included the development of the performance achieved and the control utilization involved in flying 180 deg turning, descending, and decelerating approach profiles to landing. The results suggest that such moderately complex piloted instrument approaches may indeed be feasible from a pilot acceptance point of view, given an acceptable navigation environment. Systems with the capability of those used in this experiment can provide the potential of achieving instrument operations on curved, descending, and decelerating landing approaches to weather minima corresponding to CTOL Category 2 criteria, while also providing a means of realizing more efficient operations during visual flight conditions.

Hindson, W. S.↗

NASA NTRS1981

Long-wave stratospheric transmission of Mount St. Helens ejecta

The NASA/Ames Research C-141 aircraft underflew the Mount St. Helens ejecta plume in Utah three days after the eruption. Upward-looking 20-40-microns on-board radiometry provided data resulting in a calculated long-wave transmission of 0.93. From this value, an optical depth of 0.073 is inferred. This value is compared with an accepted background, stratospheric infrared optical depth of 0.06. Assumptions on particle size, shortwave albedo, and thermal warming imply little surface temperature change caused by the ejecta on the third day immediately following the eruption.

Kuhn, P. M.↗

NASA NTRS1980

Flight evaluation of stabilization and command augmentation system concepts and cockpit displays during approach and landing of powered-lift STOL aircraft

A flight research program was conducted to assess the effectiveness of manual control concepts and various cockpit displays in improving altitude (pitch, roll, and yaw) and longitudinal path control during short takeoff aircraft approaches and landings. Satisfactory flying qualities were demonstrared to minimum decision heights of 30 m (100 ft) for selected stabilization and command augmentation systems and flight director combinations. Precise landings at low touchdown sink rates were achieved with a gentle flare maneuver.

Franklin, J. A.↗

NASA NTRS1980

Flight evaluation of configuration management system concepts during transition to the landing approach for a powered-lift STOL aircraft

Flight experiments were conducted to evaluate two control concepts for configuration management during the transition to landing approach for a powered-lift STOL aircraft. NASA Ames' augmentor wing research aircraft was used in the program. Transitions from nominal level-flight configurations at terminal area pattern speeds were conducted along straight and curved descending flightpaths. Stabilization and command augmentation for attitude and airspeed control were used in conjunction with a three-cue flight director that presented commands for pitch, roll, and throttle controls. A prototype microwave system provided landing guidance. Results of these flight experiments indicate that these configuration management concepts permit the successful performance of transitions and approaches along curved paths by powered-lift STOL aircraft. Flight director guidance was essential to accomplish the task.

Franklin, J. A.↗

NASA NTRS1978

A flight investigation of the stability, control, and handling qualities of an augmented jet flap STOL airplane

The stability, control, and handling qualities of an augmented jet flap STOL airplane are presented. The airplane is an extensively modified de Havilland Buffalo military transport. The modified airplane has two fan-jet engines which provide vectorable thrust and compressed air for the augmentor jet flap and Boundary-Layer Control (BLC). The augmentor and BLC air is cross ducted to minimize asymmetric moments produced when one engine is inoperative. The modifications incorporated in the airplane include a Stability Augmentation System (SAS), a powered elevator, and a powered lateral control system. The test gross weight of the airplane was between 165,000 and 209,000 N (37,000 and 47,000 lb). Stability, control, and handling qualities are presented for the airspeed range of 40 to 180 knots. The lateral-directional handling qualities are considered satisfactory for the normal operating range of 65 to 160 knots airspeed when the SAS is functioning. With the SAS inoperative, poor turn coordination and spiral instability are primary deficiencies contributing to marginal handling qualities in the landing approach. The powered elevator control system enhanced the controllability in pitch, particularly in the landing flare and stall recovery.

Vomaske, R. F.↗

NASA NTRS1977

Flight evaluation of flight-path control required for the approach and landing of STOL aircraft

Flight experiments have been conducted as part of a program to assess requirements for flight-path control for glide-slope tracking and for control of the flare and landing for STOL aircraft. The Augmentor Wing Research Aircraft was used to perform landing approaches on a 7.5 deg glide slope to landings on a 30 x 518 m STOL runway. The flight results identified flight-path overshoot and vertical velocity damping to be the dominant aircraft response characteristics that affect glide-slope tracking. The one prominent contribution to control of flare using pitch attitude was the short-term path response.

Franklin, J. A.↗

NASA NTRS1976

Operational experience with a powered-lift STOL aircraft

The experience gained in over four years of STOL operations with the augmentor wing research aircraft and the background of operation of other STOL powered-lift aircraft indicate that the use and percent of lift achieved by powered lift have significant effects on the operational characteristics of STOL aircraft and, therefore, on the performance that can be achieved. A brief description of the augmentor wing including the means by which it achieves its powered lift is presented. Specific problem areas relating to the control of longitudinal flight path are discussed as well as the consequences these might have on the design and operation of this class of aircraft. Particular emphasis is given to the approach and landing phase of flight where the consequences of the powered lift are most pronounced, and the resultant characteristics most different from those of conventional aircraft.

Innis, R. C.↗

NASA NTRS1976

Flight evaluation of advanced flight control systems and cockpit displays for powered-lift STOL Aircraft

A flight research program was conducted to assess the improvements, in longitudinal path control during a STOL approach and landing, that can be achieved with manual and automatic control system concepts and cockpit displays with various degrees of complexity. NASA-Ames powered-lift Augmentor Wing Research Aircraft was used in the research program. Satisfactory flying qualities were demonstrated for selected stabilization and command augmentation systems and flight director combinations. The ability of the pilot to perform precise landings at low touchdown sink rates with a gentle flare maneuver was also achieved. The path-control improvement is considered to be applicable to other powered-lift aircraft configurations.

Franklin, J. A.↗

NASA NTRS1974

Flight-path and airspeed control during landing approach for powered-lift aircraft

Manual control of flight path and airspeed during landing approach has been investigated for powered-lift transport aircraft. An analysis was conducted to identify the behavior of the aircraft which would be potentially significant to the pilot controlling flight path and airspeed during the approach. The response characteristics found to describe the aircraft behavior were (1) the initial flight-path response and flight-path overshoot for a step change in thrust, (2) the steady-state coupling of flight path and airspeed for a step change in thrust, and (3) the sensitivity of airspeed to changes in pitch attitude. The significance of these response characteristics was evaluated by pilots on a large-motion, ground-based simulator at Ames Research Center. Coupling between flight path and airspeed was considered by the pilot to be the dominant influence on handling qualities for the approach task. Results are compared with data obtained from flight tests of three existing powered-lift V/STOL aircraft.

Franklin, J. A.↗

NASA NTRS1974

A Flight Investigation of the STOL Characteristics of an Augmented Jet Flap STOL Research Aircraft

The flight test program objectives are: (1) To determine the in-flight aerodynamic, performance, and handling qualities of a jet STOL aircraft incorporating the augmented jet flap concept; (2) to compare the results obtained in flight with characteristics predicted from wind tunnel and simulator test results; (3) to contribute to the development of criteria for design and operation of jet STOL transport aircraft; and (4) to provide a jet STOL transport aircraft for STOL systems research and development. Results obtained during the first 8 months of proof-of-concept flight testing of the aircraft in STOL configurations are reported. Included are a brief description of the aircraft, fan-jet engines, and systems; a discussion of the aerodynamic, stability and control, and STOL performance; and pilot opinion of the handling qualities and operational characteristics.

Quigley, H. C.↗

NASA NTRS1973

Takeoff and landing performance and noise measurements of a deflected slipstream STOL airplane with interconnected propellers and rotating cylinder flaps

A YOV-10A aircraft was modified to incorporate rotating cylinder flaps and interconnected propellers with Lycoming T-53-L11 engines. Flight tests were made to evaluate the low speed handling qualities and performance characteristics. The flight test results indicated that landings could be made with approach speeds of 55 to 65 knots (CL = 4.5) and descent angles of 6 deg to 8 deg for total flap angles of 60 deg to 75 deg. At higher flap angles, deterioration of stability and control characteristics precluded attempts at landing. The noise level on the ground under an 8 deg landing approach path was below 86 PNdB at distances beyond 1 nautical mile from touchdown. Takeoffs were made with 30 deg to 45 deg flaps at lift off speeds of 75 to 80 knots and climb angles of 4 deg to 8 deg. Noise levels were below 83 PNdB at 3.5 nautical miles from the start of ground roll.

Weiberg, J. A.↗