GPM Level 1 Science Requirements: Science and Performance Viewed from the Ground
No abstract available
Hydrology↗
Engineering topics
Jackson, G. S.
Publications and source records attributed to Jackson, G. S..
Dataset Analysis to Support Verification of GPM Science Requirements
No abstract available
Precipitation↗
Gpm Level 1 Science Requirements: Science and Performance Viewed from the Ground
GPM meets Level 1 science requirements for rain estimation based on the strong performance of its radar algorithms. Changes in the V5 GPROF algorithm should correct errors in V4 and will likely resolve GPROF performance issues relative to L1 requirements. L1 FOV Snow detection largely verified but at unknown SWE rate threshold (likely < 0.5 –1 mm/hr/liquid equivalent). Ongoing work to improve SWE rate estimation for both satellite and GV remote sensing.
Precipitation↗
The effect of initial diameter in sperically symmetric droplet combustion of sooting fuels
The effect of initial droplet diameter on the burning rate of sooting fuels - n-heptane and 1-chloro-octane - was examined experimentally at low gravity. A 1.2s drop tower provided a low gravity environment to minimize buoyancy and achieve spherically symmetric flames for stationary droplets. Free-floating and fiber-supported droplets were burned, and both techniques gave matching results for droplets of similar initial diameter. Burning rate constants for both fuels were measured for a large number of droplets ranging from 0.4 to 1.1mm in initial diameter.
Jackson, G. S.↗
Experiments on the effect of initial diameter in spherically symmetric droplet combustion of sooting fuels
The effect of initial droplet diameter on the burning rate of sooting fuels (n-heptane and 1-chloro-octane) is studied experimentally at low gravity. A 1.2 s drop tower provided a low gravity environment to minimize buoyancy and achieve spherically symmetric flames for stationary droplets. Free-floating and fiber supported droplets were burned, and both methods gave matching results for droplets of similar initial diameter.
Jackson, G. S.↗
Observations of soot during droplet combustion at low gravity - Heptane and heptane/monochloroalkane mixtures
Experimental observations of the combustion of sooting fuel droplets, performed in a drop tower to create a low gravity environment, are reported. Free n-heptane droplets and suspended droplets of heptane, monochloroalkanes, and mixtures of monochloro-octane and heptane were studied. Initial droplet diameters ranged from 0.4 to 1.1. mm. The results suggest that soot may influence droplet vaporization rates. Spherical symmetry of the flame allowed for extended observation of soot agglomerates inside the droplet flame. Effects of slight convective flows were also observed, both through variations of natural convection around the suspended droplets and through variations in the drift velocities of the unsupported droplets. Slight convective flows around the suspended droplets reduced flame luminosity as well as soot accumulation inside the flame and increased droplet vaporization rates. Mixing monochloro-octane with n-heptane demonstrated the effectiveness of n-heptane in reducing soot emissions from the flames of the chlorinated fuels. Finally, trends of initial droplet diameter with burning rate were observed and may be linked to the effect of droplet size upon soot formation inside the flame.
Jackson, G. S.↗
Soot formation during combustion of unsupported methanol/toluene mixture droplets in microgravity
Results are reported of an experimental study tracing the influence of liquid composition on soot formation and the burning rate of a droplet composed of a binary miscible mixture of liquids. The mixture components represented a highly sooting fuel, toluene, and a nonsooting fuel, methanol. The toluene concentration in methanol was shown to dramatically influence flame luminosity and soot production. Neither burning rates nor a propensity for flame extinction appeared to be significantly affected by toluene mixture fractions. Five-percent toluene mixture droplets behaved like pure methanol droplets in terms of burning rate, lack of flame luminosity, and extinction. Increasing the toluene concentration in the droplets to 25 percent increased flame luminosity, yet no visible soot agglomerates were observed. The 50-percent-mixture droplets burned with highly luminous flames and large amounts of soot agglomerates collecting inside the flame. All the mixture droplets showed burning rates similar to those of pure methanol and likewise exhibited flame extinction before complete droplet vaporization.
Jackson, G. S.↗
Combustion of unsupported methanol/dodecanol mixture droplets at low gravity
Experiments are reported on the combustion of free or unsupported methanol/dodecanol mixture droplets in a reduced gravity environment. The experiments were conducted in a drop tower. The Grashof number (based on drop diameter) in the moving frame of reference was on the order of 10 exp -5 for the period of droplet burning. Combustion of the mixture droplets was characterized by a multi-stage process indicative of diffusion controlled burning. The flame was not visible during the first stage because of the lighting used, but was visible (and spherical) in the final stage. The results suggested that the mixture droplets did not extinguish. By contrast, methanol droplets consistently extinguished. Microexplosions were not observed for mixtures with initial concentrations of equal volumes of methanol and dodecanol. However, most of the droplets containing initially 75 percent (by volume) of methanol exploded. The initiation of microexplosion, as defined by the occurrence of homogeneous nucleation within the droplet, is explained by comparing the calculated nonlinear variation of superheat limit with composition for a methanol/dodecanol mixture with the boiling point of dodecanol.
Yang, J. C.↗