Search NASA⌕ Search

Engineering topics

Jenei, P.

Publications and source records attributed to Jenei, P..

Microstructure evolution and mechanical performance of copper processed by equal channel angular rolling

Highlights: • Copper was processed by equal channel angular rolling (ECAR) up to 33 passes. • A very fine grained microstructure with high dislocation density was developed. • A decrease of dislocation density was observed for high numbers of passes. • The proof stress saturated at a value of about 400 MPa. • ECAR is a possible way of commercialization of ultrafine-grained materials. - Abstract: Ultrafine-grained (UFG) oxygen free high conductivity (OFHC) Cu samples were processed by severe plastic deformation (SPD) using the method of equal channel angular rolling (ECAR) up to 33 passes at room temperature. It was found that the grain size gradually decreased from ~ 40 μm to ~ 250 nm with increasing the number of passes. A maximum dislocation density of ~ 21 × 10{sup 14} m{sup − 2} was achieved after 13 passes of ECAR. For large numbers of passes (between 23 and 33), the dislocation density decreased to ~ 14 × 10{sup 14} m{sup − 2}. The proof stress was saturated at the value of about 400 MPa. The stored energy was measured by calorimetry and compared with the values calculated from the parameters of the microstructure. The reduction of the released heat after 13 and 33 passes suggested structural relaxation of the UFG microstructure. For these numbers of passes, the reduction of area in tensile testing was improved without decreasing the proof stress. The correlation between the microstructure and the mechanical behavior was discussed in detail. It was found that ECAR is capable for the mass-production of UFG metallic materials with high strength, therefore this method is a possible way of commercialization of SPD-processed materials.

36 MATERIALS SCIENCE↗

Investigation of deformation micro-mechanisms in nickel consolidated from a bimodal powder by spark plasma sintering

Bulk polycrystalline nickel compact was processed by spark plasma sintering from heterogeneous powder consisting of a mixture of nanometer and micrometer sized particles. The consolidated samples inherited the bimodal structure of the starting powder and was composed of ~ 55 vol.% coarse-grained (with the grain size larger than 1 μm) and ~ 45 vol.% ultrafine-grained (with an average grain size of ~ 550 nm) components. The deformation mechanisms were established by EBSD, X-ray line profile analysis and in-situ TEM observations. In the ultrafine-grained volume, the deformation occurred mainly through the activation of dislocation sources emitting full or partial dislocation either from grain interior or grain boundaries. Besides dislocation activity, rolling and sliding of nanograins were also observed during deformation by in-situ transmission electron microscopy, which have a considerable contribution to the observed high strain rate sensitivity of the bimodal microstructure. The cracks formed during deformation easily propagated in the nanograin regions due to the weaker particle bonding caused by the relatively high fraction of native oxide layer on the surface of the initial nanoparticles. - Highlights: • Bulk bimodal polycrystalline Ni was processed by SPS from a heterogeneous powder. • High SRS of the flow stress was observed which enhanced ductility and strength. • In-situ TEM revealed dislocation sources inside and at the boundaries of UFGs. • Twinning, partial dislocation and NG rolling were observed at crack tip vicinity. • The high SRS pertained to both dislocation activity in CG and NG rolling.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗