Search NASA⌕ Search

Engineering topics

Joel B. Lonzaga

Publications and source records attributed to Joel B. Lonzaga.

12 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2023

Split-Step Simulations to Assess the Effects of Atmospheric Boundary Layer Turbulence on the Dose Variability of N-Waves and Shaped Booms

The effects of atmospheric boundary layer turbulence on the loudness variability of a sonic boom N-wave and shaped boom are examined with split-step simulations. The shaped boom is representative of a design iteration of the NASA X-59 aircraft. Inhomogeneous atmospheric boundary layer turbulence is generated in the computational domain by a Fourier synthesis method. The N-wave and shaped boom are propagated through turbulent fields representing eight different convection levels measured at the NASA Kennedy Space Center and the NASA Armstrong Flight Research Center. Probability density functions of the formation of caustic regions along the propagation direction are computed from the N-wave results, and a parameter to collapse the caustic PDFs that accounts for both fluctuation intensities and length scales is proposed. Statistical results concerning loudness metric variability are presented, and the standard deviations of several metrics are shown to collapse across different convection levels of turbulence for small nondimensional propagation distances. The loudness metric distributions are observed to be well approximated by a normal distribution for a given range of propagation distances, and become increasingly skewed as distance increases. A model function for the dose variability is proposed, and the function parameters are found to be related to the convection level of the turbulence. The model for the dose variability distribution is compared to simulation data that were not used to find the regression parameters of the model. At several nondimensional propagation distances, agreement is observed between the model and the simulation data. These results indicate that the model may be suitable for providing quick estimates of noise dose variability in the primary carpet region across a wide range of atmospheric boundary layer conditions.

Sonic boom↗
NASA NTRS2023

PCBoom Version 7.3 User's Guide

PCBoom is a suite of sonic boom propagation programs that applies full three-dimensional ray tracing based on geometrical acoustics. It predicts sonic boom ground waveforms (signatures) and footprints from supersonic flight vehicles performing arbitrary maneuvers using a variety of built-in or user supplied near-field vehicle source definitions. It also computes loudness metrics, ground signature locations, and sonic boom propagation times. The nomenclature "PC" in PCBoom denotes that the programs were historically targeted to run on a Personal Computer.

PCBoom↗
NASA NTRS2022

PCBoom Version 7 Technical Reference

PCBoom is a suite of sonic boom propagation programs that applies full three-dimensional ray tracing based on geometrical acoustics. It predicts sonic boom ground waveforms and footprints from supersonic flight vehicles performing arbitrary maneuvers using a variety of built-in or user-supplied nearfield vehicle source definitions. It also computes loudness metrics, ground signature locations, and sonic boom propagation times. The nomenclature "PC" in PCBoom denotes that the programs were historically targeted to run on a personal computer. PCBoom provides a valuable contribution toward sonic boom research as illustrated by the following examples: • PCBoom allows for quick “what if” type predictions for a multitude of sonic boom scenarios, including low boom design iteration work. • The detailed flight planning capabilities allow for flight conditions and waypoints to be provided to pilots to generate booms needed for research. • PCBoom allows for post-flight analysis of as-flown trajectories with measured weather data. • PCBoom has been used in sonic boom damage claim cases to determine claim veracity.

PCBoom↗
NASA NTRSDate not supplied

Split-Step Simulations of Sonic Boom Propagation Beyond the Lateral Cutoff in a Turbulent Atmosphere

Recent flight tests during the Quiet Supersonic Flights 2018 (QSF18) study reported sonic booms heard outside of the primary carpet region. In the absence of turbulence, the lateral cutoff region separates the primary sonic boom carpet from the shadow zone, where the sonic boom signal experiences significant attenuation. However, when turbulence is present in the atmospheric boundary layer (ABL), additional scattering of the sonic boom to the shadow zone region occurs. A method is presented for simulating sonic boom propagation in a turbulent atmospheric boundary layer beyond the lateral cutoff region into the shadow zone. A split-step method is used to integrate a partially one-way equation for the acoustic pressure. Inhomogeneous turbulence, representative of the ABL, is generated in the computational domain with a Fourier synthesis approach. Distributions of several loudness metrics in the shadow zone region for a sonic boom N-wave and a shaped boom are examined. Increasing both turbulence root-mean-square velocity and integral length scale are found to increase the average loudness of booms in the shadow zone. (This research is supported by the Commercial Supersonic Technology Project of the National Aeronautics and Space Administration under Grant No. 80NSSC19K1685.)

sonic boom↗
NASA NTRSDate not supplied

Nonnormality of Sonic Boom Loudness Metrics in the Turbulent Atmospheric Boundary Layer at Large Lateral Distances from the Flight Path

Atmospheric boundary layer (ABL) turbulence causes variability of the sonic boom waveform at the ground. Recent numerical investigations of sonic boom propagation through kinematic velocity fluctuations indicate that loudness metric distributions are positively skewed relative to a normal distribution. This skewness depends on the propagation distance and turbulence intensity. Propagation simulations of N-waves and shaped booms through inhomogeneous ABL turbulence are presented. Meteorological conditions are varied to examine different daytime ABL conditions and their effect on sonic boom loudness distributions. Two outcomes are observed: 1) the loudness metric distributions become increasingly positively skewed as the propagation distance through the ABL increases, and 2) the distributions become increasingly positively skewed at the same lateral distance from the flight path as the convection level of the daytime ABL is increased. Thus, results indicate that ground level measurements of sonic boom loudness from flight tests performed at large lateral distances from the flight path may not be normally distributed, due to turbulence present in the ABL. (This research is supported by the Commercial Supersonic Technology Project of the National Aeronautics and Space Administration under Grant No. 80NSSC19K1685.)

sonic boom↗
NASA NTRSDate not supplied

Nonlinear Acoustic Propagation in Low-Density Media

Nonlinear acoustic propagation in the atmosphere is usually modeled using an augmented Burgers equation accounting for atmospheric absorption and weak nonlinearity. However, the weak-nonlinearity assumption may not apply to acoustic signals propagating from the lower atmosphere that are subsequently refracted downward from the upper atmosphere (e.g., stratosphere and thermosphere) due to the decreasing air density with increasing altitude [Lonzaga, et al., Geophysical Journal International, 200(3), pp.1347-1361]. Consequently, this paper discusses the effects of a strong nonlinearity that lead to an amplitude-dependent increase in signal propagation speed. This propagation speed is obtained using a perturbation expansion where the leading-order term is simply the small-amplitude sound speed while the first-order term is the existing expression that gives rise to waveform steepening and stretching. Furthermore, the second-order term is proportional to the spectral density of the acoustic signal and is inversely proportional to the local density of the medium. Consequently, for an impulsive signal such as a sonic boom or an infrasound, the second-order effect causes a dispersion of the signal similar to the observed dispersion of acoustic signals from supersonic Concorde as well as from large explosions. This paper also discusses the extension of these results in general low-density propagation media.

sonic booms↗
NASA NTRSDate not supplied

Higher-Order Statistical Moments of Predicted Sonic Boom Waveforms Through Turbulence

Sonic booms generated by supersonic aircraft are affected by turbulence in the atmospheric boundary layer through which they propagate. Turbulence effects lead to random variability of the sonic boom waveforms measured on the ground, complicating the prediction of such waveforms. As an initial effort to predict the waveform variability, the solution of the coherent or mean sonic boom waveform has previously been formulated by the author. The current paper extends the formulation to derive an expression of the second-order statistical moment necessary to calculate the variance of the spectral amplitudes. Since the derivation uses a full wave equation, results using the derived expression will be compared with those obtained using a parabolic approximation. In order to fully quantify the uncertainty of our predictions, the higher order statistical moments are also formulated and are shown to be approximately zero. Consequently, the probability density function (pdf) of the spectral amplitudes is predicted to be Gaussian. The formulation is further extended to determine the pdf of the loudness of sonic booms and quantify the uncertainties associated with the loudness prediction. Results from the formulation are compared with available flight test data.

sonic booms↗
NASA NTRSDate not supplied

Evaluation of Finite Impulse Response Filters for Turbulence Effects on Sonic Booms

Turbulence effects on sonic booms lead to random variability of sonic boom waveforms measured on the ground, complicating the prediction of such waveforms using sonic boom propagation codes that do not account for turbulence effects. The NASA PCBoom software is one such code shown to accurately predict sonic booms above the atmospheric boundary layer but not those on the ground. Analyses of measured sonic booms show that, on average, the turbulence effects result in sonic boom loudness reduction, on average, that increases with propagation distance and turbulence strength. To efficiently account for such effects, a signal processing-based approach has been developed at NASA using finite impulse response filters derived from predicted waveforms by solving a nonlinear parabolic equation. Analyses indicate that the mean loudness reduction obtained using the filters does not increase with propagation distance or with increasing turbulence strength, in disagreement with flight test data. An alternative approach to the filters is currently under development employing the multiple scattering theory (MST) of wave propagation. Available results from the physics-based MST approach are used to evaluate the predictive capability of the filters, suggesting that the filters can severely underestimate the prediction of the MST approach.

sonic booms↗
NASA NTRSDate not supplied

Evaluation of Finite Impulse Response Filters for Turbulence Effects on Sonic Booms

Turbulence effects on sonic booms lead to random variability of sonic boom waveforms measured on the ground, complicating the prediction of such waveforms using sonic boom propagation codes that do not account for turbulence effects. The NASA PCBoom software is one such code shown to accurately predict sonic booms above the atmospheric boundary layer but not those on the ground. Analyses of measured sonic booms show that, on average, the turbulence effects result in sonic boom loudness reduction, on average, that increases with propagation distance and turbulence strength. To efficiently account for such effects, a signal processing-based approach has been developed at NASA using finite impulse response filters derived from predicted waveforms by solving a nonlinear parabolic equation. Analyses indicate that the mean loudness reduction obtained using the filters does not increase with propagation distance or with increasing turbulence strength, in disagreement with flight test data. An alternative approach to the filters is currently under development employing the multiple scattering theory (MST) of wave propagation. Available results from the physics-based MST approach are used to evaluate the predictive capability of the filters, suggesting that the filters can severely underestimate the prediction of the MST approach.

sonic booms↗