Engineering topics
Publications and source records attributed to Johs, B..
Small-modulation ellipsometer contains no moving parts and insensitive to small misalignments. Provides real-time, simultaneous measurements of both ellipsometric parameters, without need for separate calibration measurement or tedious adjustments. Can be made compact and rugged for operation in harsh environments.
Pulsed laser deposition is a technique commonly used to deposit high quality thin films of high temperature superconductors. This paper discusses the results obtained when this technique is applied to the deposition of Tl-Ca-Ba-Cu-O thin films using a frequency doubled Nd:YAG laser operating at 532 nm and an excimer laser operating at 248 nm. Films with onset temperatures of 125 K and zero resistance temperatures of 110 K deposited on (100) oriented MgO from a composite Tl2Ca2Ba2Cu3Ox target were obtained at both wavelengths upon appropriate post deposition annealing. Films deposited at 532 nm exhibit a rough surface, while those deposited at 248 nm are smooth and homogeneous. Upon annealing, films deposited at both wavelengths are single phase Tl2Ca2Ba2Cu3Ox.
Tl-Ba-Ca-Cu-O superconducting thin films with zero-resistance temperatures up to 115 K have been prepared using a Tl2O3 vapor process on Ba-Ca-Cu-O precursor thin films. The Ba-Ca-Cu-O thin films were made by laser deposition on Y-stabilized ZrO2 substrates. This technique minimizes problems caused by the toxicity of Tl2O3, and its subsequent decomposition to the volatile and toxic Tl2O upon heating. Therefore, it may have practical application in the fabrication of high T(c) Tl-Ba-Ca-Cu-O superconducting thin-film devices.
Superconducting thin films on MgO (100) substrates with nearly pure Tl2Ba2Ca2Cu3O10 (2:2:2:3) phase using pulsed laser evaporation and postannealing have been fabricated. The films had c axes perpendicular to the substrates. Superconducting films with onset temperatures of 125 K and zero resistance at 110 K were obtained. X-ray microprobe fluorescence measurements indicate that a typical composition of films is Tl(0.66)Ba(1.77)Ca(1.46)Cu3O(x) which is low in Tl compared to that expected for the 2:2:2:3 phase. A typical grain size is greater than 10 microns revealed by scanning electron microscopy.