Search NASA⌕ Search

Engineering topics

Kombaiah, Boopathy

Publications and source records attributed to Kombaiah, Boopathy.

38 records · Page 3

Heterogeneous creep deformation in Dissimilar Metal Welds (DMWs)

Dissimilar Metal Welds (DMWs) made between ferritic low alloy steels and austenitic alloys are widely used in high temperature components of nuclear and fossil energy power plants. Literature shows that these bimetallic welds fail prematurely by creep mechanism close to the interface of the ferritic (BCC) and austenitic regions (FCC), with lifetimes much less than the creep lives of both materials. These creep failures are associated with cavity formation close to BCC/FCC interfaces. However, the spatial and temporal variations of creep strain rates in these DMWs have not been measured. In this research, DMW coupons were fabricated between 2.25Cr-1Mo steel and Alloy 800 H base material using a Ni base Inconel weld consumable. These samples were aged at 600 °C for 2000 h and 4000 h to induce two different sizes and distributions of Type I interfacial carbides and further subjected to a short term (~1 month) creep testing. Here, surface strains were measured with Digital Image Correlation (DIC) technique to extract local creep strain rates. In both samples, creep strain concentration occurred in the BCC matrix. The location of creep strain concentration from the BCC/FCC interface, changed from 5 µm (2000 h aged condition) to 400 µm (4000 h aged condition) depending on the initial carbide distributions in these regions.

36 MATERIALS SCIENCE↗

Mechanisms of radiation-induced segregation around He bubbles in a Fe-Cr-Ni crystal

We report that Fe-15Cr-15Ni (wt.%) austenitic stainless steel was irradiated with 200 keV 4 He + ions to a fluence of 5 × 10 16 /cm 2 at 500 °C. Radiation-induced segregation (RIS) at He bubbles in the irradiated steel was measured using Energy Dispersive X-ray Spectroscopy (EDS) coupled with Scanning Transmission Electron Microscopy (STEM). The RIS measurements exhibited an enrichment of Ni and a depletion of Cr and Fe at the bubbles. To determine the underlying mechanisms of the RIS, the prediction of the Marwick model was compared with the RIS measurements. The model with parametric input in accordance with the Inverse Kirkendall effect (IKE), i.e. a preferential flux of elements associated with vacancy flux, was inadequate in explaining the observed amount of segregation of Fe, Cr and Ni. More specifically, a considerably lower ratio of the concentration gradient between Cr and Fe, $\left(\frac{∇Cr}{∇Fe}\right)$, of 0.53 was obtained from the RIS measurements versus the model-predicted value of 2.3, indicating an overestimation of Cr depletion at the bubbles by the Marwick model. To explain this difference between the model prediction and the RIS measurements, in addition to the Cr depletion at the bubbles by IKE due to the fastest diffusion via vacancy flux, a preferential interstitial flux of Cr from the matrix to the bubbles is discussed as a possible concurrently operating mechanism.

36 MATERIALS SCIENCE↗