Search NASA⌕ Search

Engineering topics

Kvackaj, T.

Publications and source records attributed to Kvackaj, T..

Microstructure evolution and mechanical performance of copper processed by equal channel angular rolling

Highlights: • Copper was processed by equal channel angular rolling (ECAR) up to 33 passes. • A very fine grained microstructure with high dislocation density was developed. • A decrease of dislocation density was observed for high numbers of passes. • The proof stress saturated at a value of about 400 MPa. • ECAR is a possible way of commercialization of ultrafine-grained materials. - Abstract: Ultrafine-grained (UFG) oxygen free high conductivity (OFHC) Cu samples were processed by severe plastic deformation (SPD) using the method of equal channel angular rolling (ECAR) up to 33 passes at room temperature. It was found that the grain size gradually decreased from ~ 40 μm to ~ 250 nm with increasing the number of passes. A maximum dislocation density of ~ 21 × 10{sup 14} m{sup − 2} was achieved after 13 passes of ECAR. For large numbers of passes (between 23 and 33), the dislocation density decreased to ~ 14 × 10{sup 14} m{sup − 2}. The proof stress was saturated at the value of about 400 MPa. The stored energy was measured by calorimetry and compared with the values calculated from the parameters of the microstructure. The reduction of the released heat after 13 and 33 passes suggested structural relaxation of the UFG microstructure. For these numbers of passes, the reduction of area in tensile testing was improved without decreasing the proof stress. The correlation between the microstructure and the mechanical behavior was discussed in detail. It was found that ECAR is capable for the mass-production of UFG metallic materials with high strength, therefore this method is a possible way of commercialization of SPD-processed materials.

36 MATERIALS SCIENCE↗