Engineering topics

Lang, Roger

Publications and source records attributed to Lang, Roger.

11 records

NASA NTRS2018

Analysis of Soil Freeze/Thaw Signatures During Slapex F/T Campaign

Permanently frozen and seasonally frozen soils occur over a large portion of the Earth's land surface. Changes in the freeze/thaw state of the land surface reflects major changes in thermal and hydraulic properties as well as acting as a "switch" for many ecological processes. In short, soil freeze/thaw state is a fundamental land surface variable in the water and energy cycles, and it connects to the carbon cycle. Surface freeze/thaw state is observable by passive and active microwave sensors. For example, NASA's Soil Moisture Active Passive (SMAP) mission includes a freeze/thaw data product. Such satellite sensing offers routine all-season and all-weather global observations of soil freeze/thaw state with the application of suitable algorithms. We describe early finding from the SLAPex Freeze/Thaw campaign, believed to be the first airborne campaign of its type, focusing on soil freeze/thaw.

SLAPex↗

NASA NTRS2018

Seawater Dielectric Measurements at L-Band with Latest Improvements

Recently, the dielectric constant of seawater at L-band was determined by employing a resonant cavity technique. A dielectric model function has been developed based on the measurement data and the model function has been used for retrieving the ocean salinity. The results indicate that additional accuracy is still needed to resolve the bias correlated with sea surface temperature. This paper reports the improvements that have been made recently for the development of a more accurate seawater dielectric model function. The additional measurements for the open ocean will be addressed in the paper.

L-band↗

NASA NTRS2018

Physics-Based Retrieval of Surface Roughness Parameters for Bare Soils from Combined Active-Passive Microwave Signatures

In the past the effect of soil roughness was often considered secondary within the determination of soil moisture from remote sensing data. Several studies showed that accurate determination of soil roughness leads to an improved estimation of soil moisture. Two default parameters to describe the surface roughness are the standard deviation of the surface height variation 𝑠 and the surface correlation length 𝑙 with its corresponding autocorrelation function. Both parameters (𝑠,𝑙) affect the emissivity measured by radiometers as well as the backscattering observed by radars. In this study, we develop a physics-based approach to retrieve 𝑠 and 𝑙 by combining both microwave signals based on active-passive microwave covariation. To test the approach, containing a forward model and a retrieval algorithm, we used active/passive microwave data measured with the ComRAD truck-based SMAP simulator at L-band. Results and validations with corresponding field measurements on ground show that 𝑠 and 𝑙 can be estimated simultaneously when using this approach. The physics-based retrieval algorithm works robustly for two investigated test fields having an RMS-Error of 0.68 cm and 0.69 cm between the microwave-based and field-measured 𝑠-values, and of 3.13 cm and 3.04 cm for 𝑙-values. The first validation of the results reveals that the influence of the autocorrelation function, needed within the retrieval, is distinct.

correlation length↗

NASA NTRS2016

Accurate Measurements of the Dielectric Constant of Seawater at L Band

This paper describes measurements of the dielectric constant of seawater at a frequency of 1.413 GHz, the center of the protected band (i.e., passive use only) used in the measurement of sea surface salinity from space. The objective of the measurements is to accurately determine the complex dielectric constant of seawater as a function of salinity and temperature. A resonant cylindrical microwave cavity in transmission mode has been employed to make the measurements. The measurements are made using standard seawater at salinities of 30, 33, 35, and 38 practical salinity units over a range of temperatures from 0 degree C to 35 degree C in 5 degree C intervals. Repeated measurements have been made at each temperature and salinity. Mean values and standard deviations are then computed. The total error budget indicates that the real and imaginary parts of the dielectric constant have a combined standard uncertainty of about 0.3 over the range of salinities and temperatures considered. The measurements are compared with the dielectric constants obtained from the model functions of Klein and Swift and those of Meissner and Wentz. The biggest differences occur at low and high temperatures.

Measurements↗

NASA NTRS2015

Evaluation of Radar Vegetation Indices for Vegetation Water Content Estimation Using Data from a Ground-Based SMAP Simulator

Vegetation water content (VWC) is an important component of microwave soil moisture retrieval algorithms. This paper aims to estimate VWC using L band active and passive radar/radiometer datasets obtained from a NASA ground-based Soil Moisture Active Passive (SMAP) simulator known as ComRAD (Combined Radar/Radiometer). Several approaches to derive vegetation information from radar and radiometer data such as HH, HV, VV, Microwave Polarization Difference Index (MPDI), HH/VV ratio, HV/(HH+VV), HV/(HH+HV+VV) and Radar Vegetation Index (RVI) are tested for VWC estimation through a generalized linear model (GLM). The overall analysis indicates that HV radar backscattering could be used for VWC content estimation with highest performance followed by HH, VV, MPDI, RVI, and other ratios.

soil moisture↗

NASA NTRS2010

L Band Brightness Temperature from Forest: Comparison of Approximate Techniques

In this paper, three approximate physical microwave radiometry models have been used to calculate brightness temperatures from a forest canopy at L-band. These models are (1) tau-omega model (zero order scattering approximation to radiative transfer equations), (2) successive order of scattering model up to first order (first order scattering approximation to the radiative transfer equations), and (3) Peak technique utilizing the active solution obtained from the Distorted Born Approximation (DBA). These models are physically-based and treat vegetation as a layer of discrete scatterers over a rough surface. Vegetation components within the canopy are represented by canonical shapes such as dielectric discs and cylinders. The tau-omega model is based on a zero-order solution to the radiative transfer (RT) equations. The model ignores scattering except for the effect of the scatterers in the attenuation of the emission through the vegetation. Application of the tau-omega model to data acquired during airborne and ground-based campaigns over the years has solidified scientific understanding of microwave interactions with different landscapes. In particular, shrubland, grasslands, agricultural crops, and light to moderate vegetation have been investigated. Its applicability to areas with a significant tree fraction is unknown. The first order scattering model is based on an iterative solution of the RT equation up to the first order. The first order solution is obtained by substituting the zeroth-order solution into the scattering source term and then solving the resulting radiative transfer equations. This formulation adds a new scattering term to the tau-omega model. It represents emission by particles in the layer and emission by the ground that is scattered once by particles in the layer. The resulting model represents an improvement over the standard zero-order solution (the tau-omega model) since it accounts for the scattered vegetation and ground radiation that can have a pronounced effect on the observed brightness temperature. The third model is based on the Peake formulation in conjunction with the DBA. The procedure for calculation of forest emission is accomplished by first calculating the bistatic scattering cross section for each type of scatterer, then by using the DBA to calculate specular albedo of the ground and the diffused albedo of the layer. Once the albedos are determined, Peake s principle relating active and passive problems can be used to determine the effective emissivity of the forest layer.

Kurum, Mehmet↗

NASA NTRS2007

Soil Moisture Retrieval During a Corn Growth Cycle using L-band (1.6 GHz) Radar Observations

New opportunities for large-scale soil moisture monitoring will emerge with the launch of two low frequency (L-band 1.4 GHz) radiometers: the Aquarius mission in 2009 and the Soil Moisture and Ocean Salinity (SMOS) mission in 2008. Soil moisture is an important land surface variable affecting water and heat exchanges between atmosphere, land surface and deeper ground water reservoirs. The data products from these sensors provide valuable information in a range of climate and hydrologic applications (e.g., nume~cal weather prediction, drought monitoring, flood forecasting, water resources management, etc.). This paper describes a unique data set that was collected during a field campaign at OPE^ (Optimizing Production Inputs for Economic and Environmental Enhancements) site in Beltsville, Maryland throughout the eompj2ete corn growing in 2002. This investigation describes a simple methodology to correct active microwave observations for vegetation effects, which could potentially be implemented in a global soil moisture monitoring algorithm. The methodology has been applied to radar observation collected during the entire corn growth season and validation against ground measurements showed that the top 5-cm soil moisture can be retrieved with an accuracy up to 0.033 [cu cm/cu cm] depending on the sensing configuration.

Joseph, Alicia T.↗

NASA NTRS2004

Forward and Backscattering Measurements of Rainfall using the NASA Microwave Link

This paper will present results from a study on the feasibility of making backscatter measurements from rainfall with the NASA/Microwave Link system at Wallops Island, VA. The study entails the implementation of an FMCW radar at the Link frequencies to enable simultaneous forward and backscatter measurements from rain. The Microwave Link system has been successfully employed in the development and testing of rainfall retrieval techniques. As presently configured, the Microwave Link measures attenuation and phase-shift due to rain over a 2.3 km path between the transmitting and receiving antennas. By their very nature, these measured quantities are averaged over the propagation path. As a result, the rainfall estimates obtained from the Link data are also averaged over the propagation path. However, rainfall is a highly variable process in space (as well as time). In order to gain a more detailed knowledge of its microphysics finer spatial resolutions are required. The backscatter measurements would enable range profiling over the Link path permitting a detailed study of the rainfall process. The backscatter measurements will be used in conjunction with the forward measurements and the measurements from a ground-based network of disdrometers and rain gauges located under the propagation path to develop new microwave retrieval techniques, and to test established single-frequency and dual-frequency radar retrieval algorithms relevant to the ongoing TRMM and up coming GPM missions.

Rincon, Rafael F.↗

NASA NTRS2002

Study of the Variability in the Rain Drop Size Distribution Over a 2.3. km Path

In an effort to study the drop size distribution (DSD) a state-of-the-art instrument arrangement was deployed on Wallops Island, VA. The instrumentation consisted of a 2.3-km multi-frequency microwave link, three impact disdrometers, and a network of optical and tipping bucket raingauges. A dual-frequency inversion technique was implemented with the fink measurements of attenuations at 25 GHz and 38 GHz to estimate the path-average DSD. Concurrently, an X-band, dual-polarization radar, located in the vicinity, collected polarization and reflectively measurements over the link path. The evaluation of the estimates and measurements generated some preliminary results.

Rincon, Rafael F.↗

NASA NTRS2002

Comparative Analysis of Radiometer Systems Using Non-Stationary Processes

Radiometers require periodic calibration to correct for instabilities in the receiver response. Various calibration techniques exist that minimize the effect of instabilities in the receivers. The optimal technique depends upon many parameters. Some parameters are constrained by the particular application and others can be chosen in the system design. For example, the measurement uncertainty may be reduced to the limits of the resolution of the measurement (sensitivity) if periodic absolute calibration can be performed with sufficient frequency. However if the period between calibrations is long, a reference-differencing technique, i.e. Dicke-type design, can yield better performance. The measurement uncertainty not only depends upon the detection scheme but also on the number of pixels between calibrations, the integration time per pixel, integration time per calibration reference measurement, calibration reference temperature, and the brightness temperature of what is being measured. The best scheme for reducing the measurement uncertainty also depends, in large part, on the stability of the receiver electronics. In this presentation a framework for evaluating calibration schemes for a wide range of system architectures is presented. Two methods for treating receiver non-stationarity are compared with radiometer measurements.

Racette, Paul↗

NASA NTRS2002

Experimental Investigations of Non-Stationary Properties In Radiometer Receivers Using Measurements of Multiple Calibration References

Radiometers must be periodically calibrated because the receiver response fluctuates. Many techniques exist to correct for the time varying response of a radiometer receiver. An analytical technique has been developed that uses generalized least squares regression (LSR) to predict the performance of a wide variety of calibration algorithms. The total measurement uncertainty including the uncertainty of the calibration can be computed using LSR. The uncertainties of the calibration samples used in the regression are based upon treating the receiver fluctuations as non-stationary processes. Signals originating from the different sources of emission are treated as simultaneously existing random processes. Thus, the radiometer output is a series of samples obtained from these random processes. The samples are treated as random variables but because the underlying processes are non-stationary the statistics of the samples are treated as non-stationary. The statistics of the calibration samples depend upon the time for which the samples are to be applied. The statistics of the random variables are equated to the mean statistics of the non-stationary processes over the interval defined by the time of calibration sample and when it is applied. This analysis opens the opportunity for experimental investigation into the underlying properties of receiver non stationarity through the use of multiple calibration references. In this presentation we will discuss the application of LSR to the analysis of various calibration algorithms, requirements for experimental verification of the theory, and preliminary results from analyzing experiment measurements.

Racette, Paul↗