Search NASASearch

Engineering topics

Larson, R. W.

Publications and source records attributed to Larson, R. W..

At least 19 records

Microwave properties of sea ice in the marginal ice zone

Active microwave properties of summer sea ice were measured. Backscatter data were acquired at frequencies from 1 to 17 GHz, at angles from 0 to 70 deg from vertical, and with like and cross antenna polarizations. Results show that melt-water, snow thickness, snowpack morphology, snow surface roughness, ice surface roughness, and deformation characteristics are the fundamental scene parameters which govern the summer sea ice backscatter response. A thick, wet snow cover dominates the backscatter response and masks any ice sheet features below. However, snow and melt-water are not distributed uniformly and the stage of melt may also be quite variable. These nonuniformities related to ice type are not necessarily well understood and produce unique microwave signature characteristics.

Onstott, R. G.

Calibration of dual-frequency SAR ocean imagery

A calibration procedure for digital aircraft SAR imagery is presented. Techniques to utilize internal and external calibration references are discussed. Examples of calibrated intensity scans from an oceanographic test site are presented. The relationship of the aircraft SAR calibration procedure to future spaceborne SAR systems is discussed.

Kasischke, E. S.

Inversion problems in SAR imaging

Attention is given to two classes of SAR imaging inversion problems: fine resolution imagery of stationary scenes, and the imaging of a moving surface. Absolute scattering coefficient values are obtained from the output image by means of reference reflectors. The inversion of SAR data obtained from a moving surface requires consideration of motion effects in addition to those for the fixed scatterer; systematic displacements on a scale greater than the resolution result in azimuth shifts in the mapping of the scene onto the SAR image.

Larson, R. W.

Absolute calibration for SAR systems

Absolute calibration of synthetic aperture radar data is desirable for space and time continuity in earth resource investigations. For this purpose, a calibration signal is used to compare data from a calibration flight, during which precision reflectors are imaged, to data from subsequent SAR flights. The calibration signal duplicates the SAR response from a point source. This signal is amplified and converted by the radar system and processed in precisely the same way as data.

Jackson, P. L.

Delta K measurements with synthetic aperture radar data

Delta K measurements are obtained from the interference of two electromagnetic waves of different frequencies. Constructive interference occurs when 2pi phase differences between the two frequencies correspond to a surface wavelength. Previous Delta K measurements have used two discrete frequencies for this purpose. Range pulses and Doppler signatures of a synthetic aperture radar system were filtered to obtain a sequence of Delta K values. Those Delta K values which correspond to the wavelengths of known surfaces show maximum constructive interference. SAR data can therefore be used for Delta K measurements, indicating the possibility of selective Delta K filtering during data gathering.

Larson, R. W.

Verification of L-band SAR calibration

Absolute calibration of a digital L-band SAR system to an accuracy of better than 3 dB has been verified. This was accomplished with a calibration signal generator that produces the phase history of a point target. This signal relates calibration values to various SAR data sets. Values of radar cross-section (RCS) of reference reflectors were obtained using a derived calibration relationship for the L-band channel on the ERIM/CCRS X-C-L SAR system. Calibrated RCS values were compared to known RCS values of each reference reflector for verification and to obtain an error estimate. The calibration was based on the radar response to 21 calibrated reference reflectors.

Larson, R. W.

SAR calibration: A technology review

Various potential applications of amplitude-calibrated SAR systems are briefly described, along with an estimate of calibration performance requirements. A review of the basic SAR calibration problem is given. For background purposes and to establish consistent definition of terms, various conventional SAR performance parameters are reviewed along with three additional parameters which are directly related to calibrated SAR systems. Techniques for calibrating a SAR are described. Included in the results presented are: calibration philosophy and procedures; review of the calibration signal generator technology development with results describing both the development of instrumentation and internal calibration measurements for two SAR systems; summary of analysis and measurements required to determine optimum retroreflector design and configuration for use as a reference for the absolute calibration of a SAR system; and summary of techniques for in-flight measurements of SAR antenna response.

Larson, R. W.

SAR calibration technology review

Synthetic Aperture Radar (SAR) calibration technology including a general description of the primary calibration techniques and some of the factors which affect the performance of calibrated SAR systems are reviewed. The use of reference reflectors for measurement of the total system transfer function along with an on-board calibration signal generator for monitoring the temporal variations of the receiver to processor output is a practical approach for SAR calibration. However, preliminary error analysis and previous experimental measurements indicate that reflectivity measurement accuracies of better than 3 dB will be difficult to achieve. This is not adequate for many applications and, therefore, improved end-to-end SAR calibration techniques are required.

Walker, J. L.

Radar monitoring of surface and internal glacial flow and iceberg movement

The paper is concerned with the monitoring of glaciers, icebergs, and ice shelves by the use of synthetic aperture radar, buried electromagnetic transponders, and surface data collection platforms. Procedures for determining surface and internal glacial flow vectors and for tracking individual icebergs are described. The design, emplacement, and discrimination of radar targets are considered.

Drake, B.

Space shuttle search and rescue experiment using synthetic aperture radar

The feasibility of a synthetic aperture radar for search and rescue applications was demonstrated with aircraft experiments. One experiment was conducted using the ERIM four-channel radar and several test sites in the Michigan area. In this test simple corner-reflector targets were successfully imaged. Results from this investigation were positive and indicate that the concept can be used to investigate new approaches focused on the development of a global search and rescue system. An orbital experiment to demonstrate the application of synthetic aperture radar to search and rescue is proposed using the space shuttle.

Sivertson, W. E., Jr.

Space shuttle search and rescue experiment using synthetic aperture radar

Langley Research Center, NASA, is developing a concept for using a spaceborne synthetic aperture radar with passive reflectors for search and rescue applications. The feasibility of a synthetic aperture radar for search and rescue applications has been demonstrated with aircraft experiments. One experiment was conducted using the ERIM four-channel radar and several test sites in the Michigan area. In this test simple corner-reflector targets were successfully imaged. Results from this investigation were positive and indicate that the concept can be used to investigate new approaches focused on the development of a global search and rescue system. An orbital experiment to demonstrate the application of synthetic aperture radar to search and rescue is proposed using the space shuttle.

Sivertson, W. E., Jr.

The application of airborne imaging radars (L and X-band) to earth resources problems

A multiplexed synthetic aperture Side-Looking Airborne Radar (SLAR) that simultaneously images the terrain with X-band (3.2 cm) and L-band (23.0 cm) radar wavelengths was developed. The Feasibility of using multiplexed SLAR to obtain useful information for earth resources purposes. The SLAR imagery, aerial photographs, and infrared imagery are examined to determine the qualitative tone and texture of many rural land-use features imaged. The results show that: (1) Neither X- nor L-band SLAR at moderate and low depression angles can directly or indirectly detect pools of water under standing vegetation. (2) Many of the urban and rural land-use categories present in the test areas can be identified and mapped on the multiplexed SLAR imagery. (3) Water resources management can be done using multiplexed SLAR. (4) Drainage patterns can be determined on both the X- and L-band imagery.

Drake, B.

Investigation of microwave hologram techniques for application to earth resources

An investigation of microwave hologram techniques for application to earth resources was conducted during the period from June 1971 to November 1972. The objective of this investigation has been to verify the feasibility of an orbital microwave holographic radar experiment. The primary advantage of microwave hologram radar (MHR) over the side-looking airborne radar (SLAR) is that of aspect or viewing angle; the MHR has a viewing angle identical with that of photography and IR systems. The combination of these systems can thus extend the multispectral analysis concept to span optical through microwave wavelengths. Another advantage is the capacity of the MHR system to generate range contours by operating in a two-frequency mode. It should be clear that along-track resolution of an MHR can be comparable with SLAR systems, but cross-track resolution will be approximately an order of magnitude coarser than the range resolution achievable with an arbitrary SLAR system. An advantage of the MHR over the SLAR is that less average transmitter power is required. This reduction in power results from the much larger receiving apertures associated with MHR systems.

Larson, R. W.

Multispectral microwave imaging radar for remote sensing applications

A multispectral airborne microwave radar imaging system, capable of obtaining four images simultaneously is described. The system has been successfully demonstrated in several experiments and one example of results obtained, fresh water ice, is given. Consideration of the digitization of the imagery is given and an image digitizing system described briefly. Preliminary results of digitization experiments are included.

Larson, R. W.

Application of dielectric constant measurements to radar imagery interpretation

The author has identified the following significant results. Although it is readily recognized that there is a need for ground truth to provide adequate guidance for remote sensing data interpretation, it is noted that, in terms of radar remote sensing, this ground truth is often inadequate. It is necessary to make basic electrical and physical measurements of the surface and to some depth below it. A brief outline is presented of a ground truth scheme which uses measurements of the dielectric constant. Two portable instruments were designed specifically for this purpose; these were: (1) a Q-meter for measurement of dielectric constant and loss tangent; and (2) an instrument to measure electrical properties of the two operating frequencies of the imaging radar. Although extensive data are lacking, several general cases of radar-earth surface and interaction are described; also, examples of radar imagery and some data on ice and snow are presented. It is concluded that the next logical step is to begin to quantify the radar ground truth in preparation for machine interpretation and automatic data processing of the radar imagery.

Bryan, M. L.

Application of dielectric constant measurements to radar imagery interpretation

A ground-truth scheme is briefly outlined, specifically, the measurement of the dielectric constant. Two portable instruments were designed specifically for this purpose: a Q-meter for measurement of dielectric constant and loss tangent, and an instrument to measure electrical properties of the two operating frequencies of the imaging radar. Several general cases of radar-earth surfaces interaction are described; also, examples of radar imagery and some data on ice and snow are presented.

Bryan, M. L.

Quick, easy to prepare freeze-dried soups

Major advantages of soups are that they totally rehydrate in less than five minutes in water at approximately 150 deg F, maintain flavor and quality stability for two weeks in a 100 F environment, and remain stable for considerably longer at ambient temperatures. They are suitable for either household or field use.

Ramirez, R. V.