Engineering topics

Lee, Teh-Hong

Publications and source records attributed to Lee, Teh-Hong.

5 records

NASA NTRS1992

Critical range evaluation using a diagonal flat plate

A novel technique is presented to image stray signals in RCS measurement ranges. In this technique, the scattered fields of a flat plate in the diagonal plane are measured in a range for various frequencies and look angles. The scattered field data is then processed to generate an inverse synthetic aperture radar (ISAR) image of the diagonal flat plate. It is shown that scattering mechanisms associated with various stray signals can be identified by using the ISAR image. This leads to better understanding of the range and possible chamber improvements. Scattering mechanisms as small as 90 dB below the plate broadside scattered field level have been observed in the image domain due to the high directivity and low sidelobe characteristics associated with the diagonal flat plate backscattered fields. The results obtained from evaluating the two compact range facilities at The Ohio State University ElectroScience Laboratory are presented to illustrate the virtues of this new range evaluation technique.

Lee, Teh-Hong↗

NASA NTRS1991

Stray signal requirements for compact range reflectors based on RCS measurement errors

The authors present a performance criterion for compact range reflectors such that their edge diffracted stray signal levels meet a reasonable radar cross section (RCS) measurement error requirement. It is shown by example that one of the significant error sources is the diffracted fields emanating from the edges or junctions of the reflector. This measurement error is demonstrated by placing a diagonal square flat plate in the target zone and rotating it to appropriate angles. These angles are determined by bisecting the plane wave and stray signal directions. This results in a peak bistatic measurement of the edge diffracted stray signal. It is proposed that the diagonal flat plate be used to evaluate new reflector designs as well as existing systems. A reasonable stray signal performance level has been developed so that new reflector systems can be characterized in terms of an RCS measurement error requirement.

Lee, Teh-Hong↗

NASA NTRS1989

A diagnostic technique used to obtain cross-range radiation centers from antenna patterns

A diagnostic technique for obtaining cross-range radiation centers based on antenna radiation patterns is presented. The method is similar to the synthetic aperture processing of scattered fields in the radar application. Coherent processing of the radiated fields is used to determine the various radiation centers associated with the far-zone pattern of an antenna for a given radiation direction. The technique can be used to identify an unexpected radiation center that creates an undesired effect in a pattern; on the other hand, it can improve a numerical simulation of the pattern by identifying other significant mechanisms. Cross range results for two 8' reflector antennas are presented to illustrate as well as validate that technique.

Lee, Teh-Hong↗

NASA NTRS1989

A surface distortion analysis applied to the hoop/column deployable mesh reflector antenna

A practical approach is demonstrated for the deterministic analysis of surface distortions in reflector antennas, based on a first-order approximation to the aperture field phase. Measured pattern results from a 15-m-diameter hoop/column deployable mesh reflector antenna are used to demonstrate the accuracy which can be obtained with this surface distortion analysis. The only practical limitation of the first-order approximation is determined by the slope derivations of the distorted surface from the best-fit paraboloid.

Lee, Teh-Hong↗

NASA NTRS1987

A new approach for shaping of dual-reflector antennas

The shaping of 2-D dual-reflector antenna systems to generate a prescribed distribution with uniform phase at the aperture of the second reflector is examined. This method is based on the geometrical nature of Cassegrain and Gregorian dual-reflector antennas. The method of syntheses satisfies the principles of geometrical optics which are the foundations of dual-reflector designs. Instead of setting up differential equations or heuristically designing the subreflector, a set of algebraic equations is formulated and solved numerically to obtain the desired surfaces. The caustics of the reflected rays from the subreflector can be obtained and examined. Several examples of 2-D dual-reflector shaping are shown to validate the study. Geometrical optics and physical optics are used to calculate the scattered fields from the reflectors.

Lee, Teh-Hong↗