Search NASA⌕ Search

Engineering topics

Loo, R. Y.

Publications and source records attributed to Loo, R. Y..

16 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1987

Calculations of the displacement damage and short-circuit current degradation in proton irradiated (AlGa)As-GaAs solar cells

A theoretical model for computing the displacement damage defect density and the short-circuit current (I sub sc) degradation in proton-irradiated (AlGa)As-GaAs p-n junction solar cells is presented. Assumptions were made with justification that the radiation induced displacement defects form an effective recombination center which controls the electron and hole lifetimes in the junction space charge region and in the n-GaAs active layer of the irradiated GaAs p-n junction cells. The degradation of I sub sc in the (AlGa)As layer was found to be negligible compared to the total degradation. In order to determine the I sub sc degradation, the displacement defect density, path length, range, reduced energy after penetrating a distance x, and the average number of displacements formed by one proton scattering event were first calculated. The I sub sc degradation was calculated by using the electron capture cross section in the p-diffused layer and the hole capture cross section in the n-base layer as well as the wavelength dependent absorption coefficients. Excellent agreement was found between the researchers calculated values and the measured I sub sc in the proton irradiated GaAs solar cells for proton energies of 100 KeV to 10 MeV and fluences from 10 to the 10th power p/square cm to 10 to the 12th power p/square cm.

Yeh, C. S.↗
NASA NTRS1985

Evaluation of AlsubxGasub1-xsubAs solar cells

Single junction GaAs solar cells have already attained an efficiency of 19% AMO which could potentially be increased to approx 20%, with some optimization. To achieve the higher efficiency the concept of multibandgap solar cells which utilizes a wider region of the solar spectrum should be sed. One of the materials for fabricating the top cell in a multibandgap solar cell is AlGaAs because it is compatible with GaAs in bandgap and lattice match. This is a very important consideration from the materials technology point of view, and the viability of this approach is evaluated.

Loo, R. Y.↗
NASA NTRS1985

DLTS analysis of radiation-induced defects in one-MeV electron irradiated germanium and Alsub0.17Gasub0.83As solar cells

The radiation-induced deep-level defects in one-MeV electron-irradiated germanium and AlxGal-xAs solar cell materials using the deep-level transient spectroscopy (DLTS) and C-V techniques were investigated. Defect and recombination parameters such as defect density and energy levels, capture cross sections and lifetimes for both electron and hole traps were determined. The germanium and AlGaAs p/n junction cells were irradiated by one-MeV electrons. The DLTS, I-V, and C-V measurements were performed on these cells. The results are summarized as follows: (1) for the irradiated germanium samples, the dominant electron trap was due to the E sub - 0.24 eV level with density around 4x10 to the 14th power 1/cu cm, independent of electron fluence, its origin is attributed to the vacancy-donor complex defect formed during the electron irradiation; (2) in the one-MeV electron irradiated Al0.17Ga0.83 as sample, two dominant electron traps with energies of Ec-0.19 and -0.29 eV were observed, the density for both electron traps remained nearly constant, independent of electron fluence. It is shown that one-MeV electron irradiation creates very few or no new deep-level traps in both the germanium and AlxGa1-xAs cells, and are suitable for fabricating the radiation-hard high efficiency multijunction solar cells for space applications.

Li, S. B.↗
NASA NTRS1984

Recent advances in LPE GaAs-based solar cells

Several modifications were made to an infinite solution liquid phase epitaxy system that help fabricate both GaAs-based cells and thin cells that effectively reduce power-to-weight ratio for space applications. The most important development is the multiwell crucible for multilayer growth. Using a split crucible in one system, as many as five layers were grown in succession with varying Al levels and dopants. The structures grown were used to produce thin GaAs cells only 10 to 20 microns thick and also to grow cascade cell components. Results of these studies are presented and their applications to the future development of GaAs-based cells are discussed.

Kamath, G. S.↗
NASA NTRS1984

Defect studies in one MeV electron irradiated GaAs and in Al/sub x Ga/sub l-x As P-N junction solar cells

Deep level transient spectroscopy reveals that the main electron traps for one-MeV electron irradiated GaAs cells are E9c)-0.31, E(c)-0.90 eV, and the main hole trap is due to the level. Electron trap density was found to vary from 3/tens-trillion ccm for 2/one quadrillion cm 3/3.7 quadrillion cm for 21 sextillion cm electron fluence for electron fluence; a similar result was also obtained for the hole trap density. As for the grown-in defects in the Al(x)Ga(1-x)As p-n junciton cells, only two electron traps with energies of E(c)-0.20 and E(c)-0.34 eV were observed in samples with x = 0.17, and none was found for x 0.05. Auger analysis on the Al(x)Ga(1-x) As window layer of the GaAs solar cell showed a large amount of oxygen and carbon contaminants near the surface of the AlGaAs epilayer. Thermal annealing experiment performed at 250 C for up to 100 min. showed a reduction in the density of both electron traps.

Li, S. S.↗
NASA NTRS1983

GaAs solar cells for concentrator systems in space

Cells for operation in space up to more than 100 suns were made, and an AMO efficiency of 21% at 100 suns with these cells was obtained. The increased efficiency resulted not only from the higher open circuit voltage associated with the higher light intensity (higher short circuit current); it also benefitted from the increase in fill factor caused by the lower relative contribution of the generation recombination current to the forward bias current when the cell's operating current density is increased. The experimental cells exhibited an AMO efficiency close to 16% at 200 C. The prospect of exploiting this capability for the continuous annealing of radiation damage or for high temperature missions (e.g., near Sun missions) remains therefore open. Space systems with concentration ratios on the order of 100 suns are presently under development. The tradeoff between increased concentration ratio and increased loss due to the cell's series resistance remains attractive even for space applications at a solar concentrator ratio of 100 suns. In the design of contact configuration with low enough series resistance for such solar concentration ratios, the shallow junction depth needed for good radiation hardness and the thin AlGaAs layer thickness needed to avoid excessive optical absorption losses have to be retained.

Loo, R. Y.↗
NASA NTRS1982

Medium energy proton radiation damage to (AlGa)As-GaAs solar cells

The performance of (AlGa)As-GaAs solar cells irradiated by medium energy 2, 5, and 10 MeV protons was evaluated. The Si cells without coverglass and a number of GaAs solar cells with 12 mil coverglass were irradiated simultaneously with bare GaAs cells. The cell degradation is directly related to the penetration of depth of protons with GaAs. The influence of periodic and continuous thermal annealing on the GaAs solar cells was investigated.

Loo, R. Y.↗
NASA NTRS1982

Defects and annealing studies in 1-Me electron irradiated (AlGa)As-GaAs solar cells

The deep-level defects and recombination mechanisms in the one-MeV electron irradiated (AlGa)As-GaAs solar cells under various irradiation and annealing conditions are discussed. Deep-level transient spectroscopy (DLTS) and capacitance-voltage (CV) techniques were used to determine the defect and recombination parameters such as energy levels and defect density, carrier capture cross sections and lifetimes for both electron and hole traps as well as hole diffusion lengths in these electron irradiated GaAs solar cells. GaAs solar cells used in this study were prepared by the infinite solution melt liquid phase epitaxial (LPE) technique at Hughes Research Lab., with (Al0.9Ga0.1)-As window layer, Be-diffused p-GaAs layer on Sn-doped n-GaAs or undoped n-GaAs active layer grown on n(+)-GaAs substrate. Mesa structure with area of 5.86x1000 sq cm was fabricated. Three different irradiation and annealing experiments were performed on these solar cells.

Li, S. S.↗
NASA NTRS1982

Effect of electron flux on radiation damage in GaAs solar cells

The objective of this work was to evaluate the effect of electron flux and temperature on radiation damage in GaAs solar cells. The defect levels and the power ratio of the GaAs solar cells under various irradiation conditions are compared. In a 200 C continuous annealing experiment, the GaAs solar cells which were irradiated at a flux of 2 x 10 to the 9th e/sq cm s suffered less power degradation than the cells which were irradiated at the same temperature at a higher flux of 4 x 10 to the 10th e/sq cm s. After the continuous annealing experiment, a single-step post annealing at 200 C was performed for 40 hr on these irradiated cells. An additional improvement in power recovery was observed only on those cells irradiated at the high flux of 4 x 10 to the 10th e/sq cm s. DLTS data indicate that the defect density decreases with lower electron flux. Both of these observations strongly suggest that the continuous annealing in GaAs cells can be effective at temperatures as low as 150 C, or even less in a space environment such as geosynchronous orbit.

Loo, R. Y.↗
NASA NTRS1981

Effects of low temperature periodic annealing on the deep-level defects in 200 keV proton irradiated AlGaAs-GaAs solar cells

The GaAs solar cell has shown good potential for space applications. However, degradation in performance occurred when the cells were irradiated by high energy electrons and protons in the space environment. The considered investigation is concerned with the effect of periodic thermal annealing on the deep-level defects induced by the 200 keV protons in the AlGaAs-GaAs solar cells. Protons at a fluence of 10 to the 11th P/sq cm were used in the irradiation cycle, while annealing temperatures of 200 C (for 24 hours), 300 C (six hours), and 400 C (six hours) were employed. The most likely candidate for the E(c) -0.71 eV electron trap observed in the 200 keV proton irradiated samples may be due to GaAs antisite, while the observed E(v) +0.18 eV hole trap has been attributed to the gallium vacancy related defect. The obtained results show that periodic annealing in the considered case does not offer any advantages over the one time annealing process.

Li, S. S.↗
NASA NTRS1980

Development of space-qualified GaAs solar cells

Cells 2 cm x 2 cm were produced having an efficiency of 16% at 100 C and 12% at 200 C. They were superior to silicon cells under 1 MeV electron bombardment up to fluences in excess of 10 to the 15th power electron per sq cm, and to protons with an energy in excess of 1 MeV. The possibility of producing cells in quantity using a graphite wafer holder is mentioned.

Knechtli, R. C.↗
NASA NTRS1980

Effects of thermal annealing on the deep-level defects and I-V characteristics of 200 keV proton irradiated AlGaAs-GaAs solar cells

Detailed characterization of deep-level defects and analysis of dark I-V data in 200 keV proton irradiated AlGaAs-GaAs solar cells have been carried out for several proton fluences (5 x 10 to the 11th, 10 to the 12th, and 10 to the 13th P/sq cm), using DLTS, C-V, and I-V measurement techniques. To study the effect of low temperature thermal annealing on the deep-level defect properties, these irradiated samples were annealed in vacuum at 300 C for one hour. Comparison was then made on the measured defect parameters (i.e., defect energy levels and densities) and the dark I-V characteristics for both the annealed and unannealed samples.

Li, S. S.↗
NASA NTRS1980

Periodic annealing of radiation damage in GaAs solar cells

Continuous annealing of GaAs solar cells is compared with periodic annealing to determine their relative effectiveness in minimizing proton radiation damage. It is concluded that continuous annealing of the cells in space at 150 C can effectively reduce the proton radiation damage to the GaAs solar cells. Periodic annealing is most effective if it can be initiated at relatively low fluences (approximating continuous annealing), especially if low temperatures of less than 200 C are to be used. If annealing is started only after the fluence of the damaging protons has accumulated to a high value 10 to the 11th power sq/pcm), effective annealing is still possible at relatively high temperatures. Finally, since electron radiation damage anneals even more easily than proton radiation damage, substantial improvements in GaAs solar cell life can be achieved by incorporating the proper annealing capabilities in solar panels for practical space missions where both electron and proton radiation damage have to be minimized.

Loo, R. Y.↗
NASA NTRS1980

Deep-level defects and recombination parameters in proton irradiated AlGaAs-GaAs solar cells

The deep-level defects produced in high efficiency AlGaAs-GaAs solar cells by proton energies of 50, 100, 200, and 290 keV are investigated. Proton fluences were from 10 to the 10th to 10 to the 13th p/sq cm. The results show that the diode ideality factor varies between 1.9 and 2.1, indicating that the dominant current component is due to the recombination of electron-hole pairs via deep-level traps in the junction space charge region of these diodes. The recombination current increases with increasing proton fluence and proton energy. The reduction of open circuit voltage, short circuit current, and conversion efficiency in the irradiated cells relates directly to the density of the deep-level defects induced by proton irradiation.

Li, S. S.↗