Engineering topics

Martin, Daniel M.

Publications and source records attributed to Martin, Daniel M..

3 records

NASA NTRS1992

Aerodynamic Spring and Damping of Free-Pitching Tips on a Semispan Wing

A test was conducted in the NASA Ames 7- by 10-Foot Wind Tunnel to derive aerodynamic spring and damping estimates for free-pitching tips on a semispan wing. The test model was a rectangular planform semispan wing with wing tips that had a single rigid-body pitch degree of freedom with respect to the inboard wing. A number of different tip planform geometries were tested, incorporating a range of quarter-chord sweep angles and taper ratios. The wing-tip dynamic response characteristics were measured at several wing angles of attack and tunnel dynamic pressures. The tip oscillations were initiated by releasing the tips from prescribed angles of attack. A new method to isolate Coulomb damping from aerodynamic damping from these tip-motion time histories is developed and applied. Correlations were performed between the experimentally derived wing-tip aerodynamic spring and damping values and predictions from a semiempirical analysis based on steady-state tip aerodynamic loads.

Young, Larry A.↗

NASA NTRS1990

Analysis and design of sidestick controller systems for general aviation aircraft

A method to design sidestick controllers for general aviation aircraft with reversible flight controls is proposed. The use of a sidestick in this type of flight vehicle generally increases the stick forces required for maneuvering; this is due to a reduction in the moment arm of application of the force. In the present study, the reduction of stick forces is achieved by incorporating geared tabs in the control-surface design. A complete analysis using the rigid-body aircraft longitudinal equations of motion and stick-force equation in coupled form is carried out. Lateral stick forces are predicted by solving the single-degree-of-freedom roll approximation and aileron stick-force equations. Data are presented for configurations with various tab areas and a wide range of gearing ratios. The results indicate that the method can be used successfully for geared-tab design and stick-force prediction. It is shown that gearing-ratio selection is critical but that tab area does not have a significant impact on the magnitude of stick forces and stick force to stick deflection gradients.

Martin, Daniel M.↗

NASA NTRS1987

VSAERO analysis of structurally decoupled tip planforms for a semispan wing

A numerical analysis has been conducted with the three-dimensional panel code VSAERO for two interacting lifting surfaces that are separated in the spanwise direction by a narrow gap, with the angle of attack of the outboard section being set independently of the inboard section, as in the 'free tip' rotor blade system proposed for helicopters. Computed values of tip surface lift and pitching moment coefficients are correlated with experimental data to determine the most suitable method for modeling the gap region between the surfaces. It is shown that the induced drag of the tip surface is reduced for negative incidence angles relative to the inboard section.

Martin, Daniel M.↗