Search NASASearch

Engineering topics

Mojarradi, M.

Publications and source records attributed to Mojarradi, M..

At least 19 records

Carbon Nanotube-Based Digital Vacuum Electronics and Miniature Instrumentation for Space Exploration

JPL has developed high performance cold cathodes using arrays of carbon nanotube bundles that produce > 15 A/sq cm at applied fields of 5 to 8 V/micron without any beam focusing. They have exhibited robust operation in poor vacuums of 10(exp -6) to 10(exp -4) Torr- a typically achievable range inside hermetically sealed microcavities. Using these CNT cathodes JPL has developed miniature X-ray tubes capable of delivering sufficient photon flux at acceleration voltages of <20kV to perform definitive mineralogy on planetary surfaces; mass ionizers that offer two orders of magnitude power savings, and S/N ratio better by a factor of five over conventional ionizers. JPL has also developed a new class of programmable logic gates using CNT vacuum electronics potentially for Venus in situ missions and defense applications. These digital vacuum electronic devices are inherently high-temperature tolerant and radiation insensitive. Device design, fabrication and DC switching operation at temperatures up to 700 C are presented in this paper.

Carbon Nanotube

JPL micro-thrust propulsion activities

Formation flying and microspacecraft constellation missions pose new propulsion requirements. Formationflying spacecraft, due to the tight positioning and pointing control requirements, may need thrust control within 1- 20 uN to an accuracy of 0.1 uN for LISA and ST-7, for example. Future missions may have extended thrust ranges into the sub - mN range. However, all do require high specific impulses (>500 sec) due to long required thruster firings.

micro-thrust propulsion micropropulsion formation

Integration of Passive Components for Spacecraft Avionics

The NASA roadmap outlining future deep space missions to Europa and other outer planetary destinations calls for continued reductions in the mass and volume of the spacecraft avionics. Spacecraft power electronics, including the power switches and converters, remain difficult to miniaturize due to the need for large numbers of discrete passive components such as resistors, capacitors, inductors and transformers. As part of the System-on-a-chip program at the Center for Integrated Space Microsystems and at the University of Arkansas, we are working to develop integrated or embedded passive components geared specifically for use in power management and distribution (PMAD) in future avionics over the next five to ten years. This will not only enable a scaling down of the power subsystems, but will make possible new architectures such as "distributed" PMAD. Additional information is contained in the original extended abstract.

Brandon, E. J.