Engineering topics

Ouazzani, Jalil

Publications and source records attributed to Ouazzani, Jalil.

12 records

NASA NTRS1993

Numerical simulation of thermocapillary flow under zero and low gravity conditions

This paper discusses the numerical solution methods and results of steady and unsteady thermocapillary (surface-tension) and buoyancy driven flows in 2D cavities and liquid columns. The 2D cavity was assumed to be square with one free surface with a zero Capillary number (i.e., the free surface was constrained to be flat). A pseudospectral method was used to solve steady and unsteady surface tension-driven and mixed buoyancy-surface tension flows in a square cavity. For the liquid column a finite-difference scheme based on a Picard iteration was used to solve for the flow, temperature and free surface shape. The surface of the liquid column was allowed to deform and, as for the 2D cavity, the surface tension was assumed to depend on temperature.

Alexander, J. I. D.↗

NASA NTRS1992

Flow transitions in a 2D directional solidification model

Flow transitions in a Two Dimensional (2D) model of crystal growth were examined using the Bridgman-Stockbarger me thod. Using a pseudo-spectral Chebyshev collocation method, the governing equations yield solutions which exhibit a symmetry breaking flow tansition and oscillatory behavior indicative of a Hopf bifurcation at higher values of Ra. The results are discussed from fluid dynamic viewpoint, and broader implications for process models are also addressed.

Larroude, Philippe↗

NASA NTRS1992

Numerical analysis of the sensitivity of crystal growth experiments to spacecraft residual acceleration

An analysis is conducted of the sensitivity of the Bridgman-Stockbarger crystal growth method, using an idealized model for a range of operating and boundary conditions over a variety of accelerations. Attention is given to the dopant nonuniformity at the melt-crystal interface. The largest compositional nonuniformities are found to occur for disturbances whose amplitudes are greater than 10 exp 6 g, and frequencies below 0.1 Hz.

Alexander, J. I. D.↗

NASA NTRS1990

Process modelling for Space Station experiments

Examined here is the sensitivity of a variety of space experiments to residual accelerations. In all the cases discussed the sensitivity is related to the dynamic response of a fluid. In some cases the sensitivity can be defined by the magnitude of the response of the velocity field. This response may involve motion of the fluid associated with internal density gradients, or the motion of a free liquid surface. For fluids with internal density gradients, the type of acceleration to which the experiment is sensitive will depend on whether buoyancy driven convection must be small in comparison to other types of fluid motion, or fluid motion must be suppressed or eliminated. In the latter case, the experiments are sensitive to steady and low frequency accelerations. For experiments such as the directional solidification of melts with two or more components, determination of the velocity response alone is insufficient to assess the sensitivity. The effect of the velocity on the composition and temperature field must be considered, particularly in the vicinity of the melt-crystal interface. As far as the response to transient disturbances is concerned, the sensitivity is determined by both the magnitude and frequency of the acceleration and the characteristic momentum and solute diffusion times. The microgravity environment, a numerical analysis of low gravity tolerance of the Bridgman-Stockbarger technique, and modeling crystal growth by physical vapor transport in closed ampoules are discussed.

Alexander, J. Iwan D.↗

NASA NTRS1990

Modelling crystal growth: Convection in an asymmetrically heated ampoule

The objective was to develop and implement a numerical method capable of solving the nonlinear partial differential equations governing heat, mass, and momentum transfer in a 3-D cylindrical geometry in order to examine the character of convection in an asymmetrically heated cylindrical ampoule. The details of the numerical method, including verification tests involving comparison with results obtained from other methods, are presented. The results of the study of 3-D convection in an asymmetrically heated cylinder are described.

Alexander, J. Iwan D.↗

NASA NTRS1990

Three-dimensional modelling of horizontal chemical vapor deposition. I - MOCVD at atmospheric pressure

A systematic numerical study of the MOCVD of GaAs from trimethylgallium and arsine in hydrogen or nitrogen carrier gas at atmospheric pressure is reported. Three-dimensional effects are explored for CVD reactors with large and small cross-sectional aspect ratios, and the effects on growth rate uniformity of tilting the susceptor are investigated for various input flow rates. It is found that, for light carrier gases, thermal diffusion must be included in the model. Buoyancy-driven three-dimensional flow effects can greatly influence the growth rate distribution through the reactor. The importance of the proper design of the lateral thermal boundary conditions for obtaining layers of uniform thickness is emphasized.

Ouazzani, Jalil↗

NASA NTRS1990

Three-dimensional numerical modelling of transport in horizontal MOCVD reactors

A systematic three-dimensional study for the MOCVD of gallium arsenide is presented. Numerical solutions, obtained for the system of equations governing the steady state heat, momentum, and mass transfer in horizontal reactors with large and small aspect ratio, are compared with experimental growth rate distributions. The effects on layer thickness uniformity of lateral thermal boundary conditions and susceptor tilt are explored. The validity of a parabolic flow approximation of the equations is also investigated by comparison with the complete three-dimensional treatment.

Ouazzani, Jalil↗

NASA NTRS1989

Analysis of the low gravity tolerance of Bridgman-Stockbarger crystal growth. I - Steady and impulse accelerations

The effects of steady and impulse-type residual accelerations on dopant distributions during directional solidification in 2D and 3D 'generic' models of the Bridgman-Stockbarger technique are investigated using numerical methods. The calculations are based on the thermophysical properties of molten germanium doped with a low concentration of gallium. A Chebyshev collocation pseudospectral method is used for the solution of the governing momentum-, mass-, species-, and heat-transfer equations. Only convection caused by temperature gradients is considered. It is found that lateral nonuniformity in composition is very sensitive to the orientation of the steady component of the residual gravity vector and to the particular operating conditions under consideration. It is also found that laterally or radially averaged composition profiles are alone insufficient to describe the extent of residual convection in a spacecraft environment. The effects of impulse-type disturbances can be severe and can extend for times on the order of 1000 sec after the termination of the impulse.

Alexander, J. Iwan D.↗

NASA NTRS1989

A pseudo-spectral collocation method applied to the problem of convective diffusive transport in fluids subject to unsteady residual accelerations

The problem of determining the sensitivity of Bridgman-Stockbarger directional solidification experiments to residual accelerations of the type associated with spacecraft in low earth orbit is analyzed numerically using a pseudo-spectral collocation method. The approach employs a novel iterative scheme combining the method of artificial compressibility and a generalized ADI method. The results emphasize the importance of the consideration of residual accelerations and careful selection of the operating conditions in order to take full advantages of the low gravity conditions.

Alexander, J. Iwan↗

NASA NTRS1988

On the two-dimensional modelling of horizontal CVD reactors and its limitations

In order to clarify under what conditions two-dimensional theoretical models can realistically account for the actual growth rate distribution in horizontal CVD reactors, a systematic numerical study was performed, and the results were compared with published experimental data for the MOCVD of gallium arsenide. Three models of increasing complexity were studied. It is shown that two-dimensional models can produce realistic predictions only for reactors with large width-to-height (aspect) ratios, that are operated at subcritical Rayleigh number,i.e., under dominant forced flow conditions. But even then, depending on the carrier gas, thermal (Soret) diffusion must be included in the model. Furthermore, velocity corrections for finite aspect ratios must be made, and buoyancy effects can be significant in the entrance region. On the other hand, the results are relatively insensitive to axial diffusion, temperature dependence of transport properties (versus averaged properties), and an assumed Poiseuille velocity profile (versus a rigorous solution of the velocity field). Yet, boundary layer approximations are prone to give unrealistic results at the low Reynolds numbers typical for CVD operations.

Ouazzani, Jalil↗

NASA NTRS1988

Response of convective-diffusive transport to spatial and temporal variations in effective gravity

The response of heat, mass, and momentum transport to conditions characteristic of the microgravity environment is studied. It is found that the orientation of the experiment with respect to the steady component of the residual gravity is a crucial factor in determining the suitability of the spacecraft as a means of suppressing or eliminating unwanted effects caused by buoyant fluid motion. The process is highly sensitive to transient disturbances.

Alexander, J. Iwan D.↗

NASA NTRS1988

Analysis of low gravity tolerance of model experiments for space station: Preliminary results for directional solidification

It has become clear from measurements of the acceleration environment in the Spacelab that the residual gravity levels on board a spacecraft in low Earth orbit can be significant and should be of concern to experimenters who wish to take advantage of the low gravity conditions on future Spacelab missions and on board the Space Station. The basic goals are to better understand the low gravity tolerance of three classes of materials science experiments: crystal growth from a melt, a vapor, and a solution. The results of the research will provide guidance toward the determination of the sensitivity of the low gravity environment, the design of the laboratory facilites, and the timelining of materials science experiments. To data, analyses of the effects of microgravity environment were, with a few exceptions, restricted to order of magnitude estimates. Preliminary results obtained from numerical models of the effects of residual steady and time dependent acceleration are reported on: heat, mass, and momentum transport during the growth of a dilute alloy by the Bridgman-Stockbarger technique, and the response of a simple fluid physics experiment involving buoyant convection in a square cavity.

Alexander, J. Iwan D.↗