Search NASA⌕ Search

Engineering topics

Park, H.

Publications and source records attributed to Park, H..

At least 37 records · Page 2

Verification and Validation Tests of Gamma Library of MC2-3 for Coupled Neutron and Gamma Heating Calculation

For the accurate assessment of the heat generation rate in fast reactors, the gamma library of MC2 -3 and the MC2 -3 + GAMSOR procedure employing the coupled neutron and gamma heating calculation has been thoroughly verified against Monte Carlo results and validated using the ZPPR-15D gamma dose measurement data. NJOY outputs are post-processed in a consistent way with the NJOY procedure to avoid any missing data or double counting of data. Prompt heating for 379 out of 391 isotopes in the gamma library was verified against MCNP6.2 to within 1% relative error in total heating for most isotopes. For both a simple one-dimensional slab problem representing a sodium cooled fast reactor and the Experimental Breeder Reactor II (EBR-II) benchmark problem, the root-mean-square values of assembly power error were less than 0.5% for fuel assemblies, ~1% in blankets and ~1 to ~3% in reflectors compared to MCNP6.2 results. The most plausible cause for the 3% error in a reflector assembly is believed to be the error in the multigroup neutron cross sections for the reflector assembly. For validation, gamma doses measured with thermoluminiscent dosimeters (TLDs) in the ZPPR-15D experiment were calculated using GAMSOR. Due to the uncertainty in the TLD measurement with regards to the energy deposition of photons and neutrons, the validation data leads to a 12.7% uncertainty on the experimental measurement. With this uncertainty bound, the calculated doses all fell within one standard deviation of the measured value. Combined with the accurate calculation of reaction rate distributions and neutron spectrum measurements, these results indicate good agreement for the neutron and gamma heating calculations that were performed.

coupled neutron and gamma heating↗

Structural and electronic properties of the first iridium containing mixed B-site spinel oxide: Cu [ Ir 1.5 Cu 0.5 ] O 4

Geometrically frustrated systems populated with large spin-orbit coupled ions are an ideal setting for the exploration of novel exotic states of matter. In this study we present an example of iridium on a mixed B-site spinel oxide structure: Cu [ Ir 1.498 ( 2 ) Cu 0.502 ( 2 ) ] O 4 . Synchrotron XRD refinements reveal a face-centered-cubic structure with space group F d 3 ¯ m and mixed Cu-Ir site disorder within the B 2 O 4 rocksalt substructure. Electrical properties reveal a metallic state within the 50–600-K range with a Kondo effect at T < 50 K . X-ray absorption spectroscopy (XAS) measurements show a mixed Cu 1 + / 2 + and Ir 3 + / 4 + charge partitioned picture, which suggests a metallic/band description with reduced on-site Coulomb interactions. Spin-glass-like freezing is seen at T g = 49 K , and the hysteresis behavior for T > T g resembles that of a strongly frustrated magnet. DFT calculations show sizable hybridization between the Cu 3 d and Ir 5 d states with an effective mixed Ir 3 + / 4 + charge partitioned picture, supporting the electronic and XAS results.

36 MATERIALS SCIENCE↗

Design of an RF-Dipole Crabbing Cavity System for the Electron-Ion Collider

The Electron-Ion Collider requires several crabbing systems to facilitate head-on collisions between electron and proton beams in increasing the luminosity at the interaction point. One of the critical rf systems is the 197 MHz crabbing system that will be used in crabbing the proton beam. Many factors such as the low operating frequency, large transverse voltage requirement, tight longitudinal and transverse impedance thresholds, and limited beam line space makes the crabbing cavity design challenging. The rf-dipole cavity design is considered as one of the crabbing cavity options for the 197 MHz crabbing system. The cavity is designed including the HOM couplers, FPC and other ancillaries. This paper presents the detailed electromagnetic design, mechanical analysis, and conceptual cryomodule design of the crabbing system.

De Silva, S. U.↗

Iridium valence variation and carrier sign tuning in ( Ca , Ba ) x La 2 – x CuIrO 6 double perovskites

Here, we report the structure and properties of ( Ca , Ba ) x La 2 – x CuIrO 6 . The rock-salt double perovskite structure goes through a P 1 ¯ to P 2 1 / n phase transition with increasing Ba content but not with Ca content. In both cases, the Ir ion is oxidized from 4 + to 5 + with increasing substitution. Transport and magnetic properties measurements reveal that all compositions are insulating with hysteretic spin-freezing magnetic behavior. Seebeck coefficient measurements reveal a large thermopower change from + 176 μ V /K in La 2 CuIrO 6 to – 223 μ V /K with increasing Ba content in Ba x La 2 – x CuIrO 6 . This behavior is modeled well by the Heikes formula for correlated hopping conduction. ( Ca , Ba ) x La 2 – x CuIrO 6 provides a model system for investigations of other systems with similar carrier sign tuning, with applications toward semiconductors and thermoelectric materials.

36 MATERIALS SCIENCE↗

A Framework for International Collaboration on ITER Using Large-Scale Data Transfer to Enable Near-Real-Time Analysis

The global nature of the ITER project along with its projected ~ petabyte per day data generation presents a unique challenge, but also an opportunity for the fusion community to rethink, optimize, and enhance our scientific discovery process. Recognizing this, collaborative research with computational scientists was undertaken over the past several years to create a framework for large-scale data movement across wide-area networks (WANs), to enable global near-real time analysis of fusion data. This would broaden the available computational resources for analysis/simulation, and increase the number of researchers actively participating in experiments. An official demonstration of this framework for fast, large data transfer and real-time analysis was carried out between the KSTAR tokamak in Daejeon, Korea and PPPL in Princeton, USA. Streaming large data transfer, with near real-time movie creation and analysis of the KSTAR Electron Cyclotron Emission imaging (ECEI) data, was performed using the I/O framework ADIOS, and comparisons made at PPPL with simulation results from the XGC1 code. These demonstrations were made possible utilizing an optimized network configuration at PPPL, which achieved over 8.8 Gbps (88% utilization) in throughput tests from NFRI to PPPL. This demonstration showed the feasibility for large-scale data analysis of KSTAR data, and provides a nascent framework to enable use of globally distributed computational and personnel resources in pursuit of scientific knowledge from the ITER experiment.

43 PARTICLE ACCELERATORS↗

Clocking Auger electrons

Intense X-ray free-electron lasers (XFELs) can rapidly excite matter, leaving it in inherently unstable states that decay on femtosecond timescales. The relaxation occurs primarily via Auger emission, so excited-state observations are constrained by Auger decay. In situ measurement of this process is therefore crucial, yet it has thus far remained elusive in XFELs owing to inherent timing and phase jitter, which can be orders of magnitude larger than the timescale of Auger decay. Here we develop an approach termed ‘self-referenced attosecond streaking’ that provides subfemtosecond resolution in spite of jitter, enabling time-domain measurement of the delay between photoemission and Auger emission in atomic neon excited by intense, femtosecond pulses from an XFEL. FUrthermore, using a fully quantum-mechanical description that treats the ionization, core-hole formation and Auger emission as a single process, the observed delay yields an Auger decay lifetime of \(2.2_{ - 0.3}^{ + 0.2}\) fs for the KLL decay channel.

47 OTHER INSTRUMENTATION↗

Direct Evidence of the Competing Nature between Electronic and Lattice Breathing Order in Rare-Earth Nickelates

Correlated electrons give rise to both exotic electronic and magnetic properties in rare-earth nickelates. IN this research, we introduce evidence of the interfacial coupling between two nickelate systems, EuNiO 3 (ENO) and LaNiO 3 (LNO), with different electronic and magnetic properties but with compatible structural registry giving rise to an electrostructural transition, unobserved in each constituent. Nominally, LNO remains in a paramagnetic-metallic R 3 ¯ c phase while orthorhombic ENO undergoes antiferromagnetic and insulating transitions. However, the ENO/LNO heterostructure displays a uniform rotational symmetry set by an entwined interface. This leads to an anomalous reduction of bond disproportionation in the ENO layer through the metal to insulator transition and concomitantly charge disproportionation opens the gap accompanied by antiferromagnetic ordering. Our findings resolve a long-standing question in the physics of rare-earth nickelates, herein demonstrating that charge and bond disproportionation are competing mechanisms for the charge localization process in the rare-earth nickelate system.

36 MATERIALS SCIENCE↗

Multiphysics Coupling of PROTEUS-NODAL and SAM for Molten Salt Reactor Simulation

The purpose of this report is to document the new features and capabilities that have been implemented in the PROTEUS-NODAL code and the coupling procedure of PROTEUS-NODAL with SAM to analyze MSRs. This report is organized as follows. Section 2 presents the variational nodal P 1 solver for cylindrical geometries and its verification test results. Section 3 discusses the transient analysis capability implemented in the P 1 solvers of PROTEUS-NODAL. The solution methods for the coupled system of TFSP and precursor drift equations, the coarse mesh finite difference (CMFD) acceleration, the kinetics parameter evaluation method, and the thermal feedback are discussed. The verification test results against the SP 3 solutions are also discussed. Section 4 describes the coupling scheme of PROTEUS-NODAL and SAM under the MOOSE framework for MSR applications. The developed MOOSE applications named “TreeFrog” and “TreeKangaroo” are discussed. Verification test results for the coupled system are also discussed by comparing the MSFR steady state solution with that obtained from a manually coupled PROTEUS-NODAL and ANSYS CFX computational fluid dynamics (CFD) calculations and the MSFR transient analysis results with the open literature solutions and the PROTEUS-NODAL solutions obtained with the standalone thermal-hydraulics solver. Section 5 provides conclusions and future works.

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗

A Super-Jupiter Orbiting A Late-Type Star: A Refined Analysis of Microlensing Event OGLE-2012-BLG-0406

We present a detailed analysis of survey and follow-up observations of microlensing event OGLE-2012-BLG-0406 based on data obtained from 10 different observatories. Intensive coverage of the light curve, especially the perturbation part, allowed us to accurately measure the parallax effect and lens orbital motion. Combining our measurement of the lens parallax with the angular Einstein radius determined from finite-source effects, we estimate the physical parameters of the lens system. We find that the event was caused by a 2.73 plus or minus 0.43 M (sub J) planet orbiting a 0.44 plus or minus 0.07 solar mass early M-type star. The distance to the lens is 4.97 plus or minus 0.29 kpc and the projected separation between the host star and its planet at the time of the event is 3.45 plus or minus 0.26 AU. We find that the additional coverage provided by follow-up observations, especially during the planetary perturbation, leads to a more accurate determination of the physical parameters of the lens.

microlensing↗