Search NASA⌕ Search

Engineering topics

Ray, E. J.

Publications and source records attributed to Ray, E. J..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Review of design and operational characteristics of the 0.3-meter transonic cryogenic tunnel

The fundamentals of cryogenic testing are validated both analytically and experimentally employing the 0.3-m transonic cryogenic tunnel. The tunnel with its unique Reynolds number capability has been used for a wide variety of aerodynamic tests. Techniques regarding real-gas effects have been developed and cryogenic tunnel conditions are set and maintained accurately. It is shown that cryogenic cooling, by injecting nitrogen directly into the tunnel circuit, imposes no problems with temperature distribution or dynamic response characteristics.

Ray, E. J.↗
NASA NTRS1978

Effect of canard vertical location, size, and deflection on canard-wing interference at subsonic speeds

A generalized close-coupled canard-wing configuration was tested in a high speed 7 by 10 foot tunnel at Mach numbers of 0.40, 0.70, and 0.85 over an angle-of-attack range from -4 deg to 24 deg. Studies were made to determine the effects of canard vertical location, size, and deflection and wing leading-edge sweep on the longitudinal characteristics of the basic configuration. The two wings tested had thin symmetrical circular-arc airfoil sections with characteristically sharp leading edges swept at 60 deg and 44 deg. Two balances which allow separation of the canard-forebody contribution from the total forces and moments were used in this study.

Gloss, B. B.↗
NASA NTRS1976

The cryogenic transonic wind tunnel for high Reynolds number research

Based on theoretical studies and experience with a low speed cryogenic tunnel and with the transonic cryogenic tunnel, the cryogenic wind tunnel concept has been shown to offer many advantages with respect to the attainment of full scale Reynolds number at reasonable levels of dynamic pressure in a ground based facility. The unique modes of operation available in a pressurized cryogenic tunnel make possible for the first time the separation of Mach number, Reynolds number, and aeroelastic effects.

Kilgore, R. A.↗
NASA NTRS1976

Investigation of minimum operating temperatures for cryogenic wind tunnels

Total temperatures corresponding to the onset of condensation effects were determined for flow over a 0.137-m NACA 0012-64 airfoil mounted in the Langley 1/3-m transonic wind tunnel. Tests were carried out at a total pressure range from 1.2 to 4.5 atm and at free-stream Mach numbers of 0.75, 0.85, and 0.95. No condensation effects were found to occur until total temperatures were below those associated with free-stream saturation. Significant increases in Reynolds number may apparently be obtained by operation at wind tunnel temperatures below those associated with local saturation over the airfoil but above those where effects first occur. For the 0.85 and 0.95 Mach numbers the increase in Reynolds number was at least 15% over those achieved at local saturation conditions for the same pressure range. Higher pressures may have had some detrimental effect in the 0.95 Mach number test.

Hall, R. M.↗
NASA NTRS1975

Analysis of validation tests of the Langley pilot transonic cryogenic tunnel

A pilot transonic cryogenic pressure tunnel has recently been developed and proof tested at the NASA Langley Research Center. In addition to providing an attractive method for obtaining high Reynolds number results at moderate aerodynamic loadings and tunnel power, this unique tunnel allows the independent determination of the effects of Reynolds number, Mach number, and dynamic pressure (aeroelasticity) on the aerodynamic characteristics of the model under test. The proof of concept experimental and theoretical studies are briefly reviewed. Experimental results obtained on both two- and three-dimensional models have substantiated that cryogenic test conditions can be set accurately and that cryogenic gaseous nitrogen is a valid test medium.

Ray, E. J.↗
NASA NTRS1975

Cryogenic nitrogen as a transonic wind-tunnel test gas

The test gas for the Langley Pilot Transonic Cryogenic Tunnel is nitrogen. Results from analytical and experimental studies that have verified cryogenic nitrogen as an acceptable test gas are reviewed. Real-gas isentropic and normal-shock flow solutions for nitrogen are compared to the ideal diatomic gas solutions. Experimental data demonstrate that for temperatures above the liquefaction boundaries there are no significant real-gas effects on two-dimensional airfoil pressure distributions. Results of studies to determine the minimum operating temperatures while avoiding appreciable effects due to liquefaction are included.

Adcock, J. B.↗
NASA NTRS1974

Simulation of flight test conditions in the Langley pilot transonic cryogenic tunnel

The theory and advantages of the cryogenic tunnel concept are briefly reviewed. The unique ability to vary temperature independently of pressure and Mach number allows, in addition to large reductions in model loads and tunnel power, the independent determination of Reynolds number, Mach number, and aeroelastic effects on the aerodynamic characteristics of the model. Various combinations of Reynolds number and dynamic pressure are established to represent accurately flight variations of aeroelastic deformation with altitude changes. The consequences of the thermal and caloric imperfections of the test gas under cryogenic conditions were examined and found to be insignificant for operating pressures up to 5 atm. The characteristics of the Langley pilot transonic cryogenic tunnel are described and the results of initial tunnel operation are presented. Tests of a two-dimensional airfoil at a Mach number of 0.85 show identical pressure distributions for a chord Reynolds number of 8,600,000 obtained first at a stagnation pressure of 4.91 atm at a stagnation temperature of 322.0 K and then at a stagnation pressure of 1.19 atm at a stagnation temperature of 116.5 K.

Kilgore, R. A.↗
NASA NTRS1974

The Langley cryogenic high Reynolds number wind-tunnel program

A pilot version of a new type of transonic tunnel was placed in operation in the fall of 1973. In the tunnel the cryogenic method is used to obtain a high Reynolds number. The cryogenic concept employs low temperatures to increase the Reynolds number through reducing the viscous forces rather than increasing the inertia forces. The cryogenic approach offers the desired Reynolds-number increase with no increase in dynamic pressure, and therefore no increase in model loads. A series of aerodynamic experiments have been made in the pilot tunnel to confirm the cryogenic concept at transonic speeds. A brief description is given of the project for a large tunnel which has evolved from the investigations.

Polhamus, E. C.↗
NASA NTRS1974

Test results from the Langley high Reynolds number cryogenic transonic tunnel

NASA has recently developed and proof tested a pilot cryogenic transonic pressure tunnel. In addition to providing an attractive method for obtaining high Reynolds number results at moderate aerodynamic loadings and tunnel power, this unique facility enables the independent determination of the effects of Reynolds number, Mach number, and aeroelasticity. The proof-of-concept experimental and theoretical studies are briefly reviewed. Experimental results are included which indicate pressure distributions for a two-dimensional airfoil and strain-gage balance characteristics for a three-dimensional delta wing model.

Ray, E. J.↗
NASA NTRS1974

Flight simulation characteristics of the Langley high Reynolds number cryogenic transonic tunnel

The characteristics of the Langley 34 cm (13.5 in.) pilot cryogenic transonic pressure tunnel are described, and the results of initial tunnel operation are presented. Tests of a two-dimensional airfoil at a Mach number of 0.85 show identical pressure distributions for a chord Reynolds number of 8,600,000 obtained first at a stagnation pressure of 4.91 atmospheres at a stagnation temperature of +120 F and then at a stagnation pressure of 1.19 atmospheres at a stagnation temperature of -250 F.

Kilgore, R. A.↗
NASA NTRS1973

Maneuver and buffet characteristics of fighter aircraft

Recent research efforts in the improvement of the maneuverability of fighter aircraft in the high-subsonic and transonic speed range are reviewed with emphasis on the factors affecting aerodynamic boundaries, such as maximum obtainable lift, buffet onset, pitchup, wing rock, and nose slice. The investigations were made using a general research configuration which encompassed a systematic matrix of wing-design parameters. These results illustrated the sensitivity of section and planform geometry to a selected design point. The incorporation of variable-geometry wing devices in the form of flaps or leading-edge slats was shown to provide controlled flow over a wide range of flight conditions and substantial improvements in maneuver capabilities. Additional studies indicated that the blending of a highly swept maneuver strake with an efficient, moderately swept wing offers a promising approach for improving maneuver characteristics at high angles of attack without excessive penalties in structural weight.

Ray, E. J.↗
NASA NTRS1973

Subsonic characteristics of a twin-jet swept-wing fighter model with maneuvering devices

An investigation has been conducted at Mach numbers ranging from 0.06 to 0.94 to determine the effects of various combinations of leading-edge slat devices on the static aerodynamic characteristics of a twin-jet swept-wing fighter model. The study also included a determination of the effects of wing leading-edge droop, trailing-edge chord-extensions, wing fences, and wing-planform and camber modifications. The angle-of-attack range generally extended from about minus 2 deg to 24 deg and the sideslip angles ranged from about minus 6 deg to 13 deg.

Ray, E. J.↗
NASA NTRS1972

Maneuver and buffet characteristics of fighter aircraft

The high subsonic and transonic characteristics of fighter aircraft and the factors affecting aerodynamic boundaries, such as maximum obtainable lift, buffet onset, pitchup, wing rock, and nose slice are discussed. Investigations were made using a general research configuration which encompassed a systematic matrix of wing design parameters. These results emphasized the sensitivity to section and planform geometry at the selected design point. The incorporation of variable-wing-geometry devices in the form of leading-edge slats or flaps was shown in a number of flight and wind-tunnel studies to provide controlled flow over a wide range of flight conditions and substantial improvements in maneuver capabilities. Additional studies indicated that the blending of a highly swept maneuver strake with an efficient moderately swept wing offers a promising approach for improving maneuver characteristics at high angles of attack without excessive penalties in structural weight.

Ray, E. J.↗