Search NASA⌕ Search

Engineering topics

Savinell, Robert

Publications and source records attributed to Savinell, Robert.

An All-Soluble Fe/Mn-Based Alkaline Redox Flow Battery System

Redox flow batteries (RFBs) are membrane-separated rechargeable flow cells with redox electrolytes, offering the potential for large-scale energy storage and supporting renewable energy grids. Yet, creating a cost-effective, high-performance RFB system is challenging. In this work, we investigate an Fe/Mn RFB alkaline system based on the [(TEA)Fe–O–Fe(TEA)] 3– / 4– and MnO 4 – / 2– redox couples with a theoretical cell voltage of ~1.43 V. This combination has not been systematically studied previously, but it can lead to a very low-cost and sustainable materials for high energy storage. Constant current cycling tests were performed at ±41 mA cm –2 between 20% and 80% SOC over 800 h (400 cycles) with an apparent Coulombic efficiency (CE) approaching 100%, while the voltage efficiency (VE) gradually decreased from ~75.3% to ~61.4% due to increasing internal resistances. Finally, the voltage efficiency loss can be mitigated through a periodic acid treatment to remove MnO 2 deposits from the separator.

25 ENERGY STORAGE↗

Solvation Dynamics of Wet Ethaline: Water is the Magic Component

The past two decades witnessed the development of a new type of solvent system, named deep eutectic solvents, which have become increasingly investigated because they offer new and potentially favorable properties, such as wide tunability in electrochemical, mechanical, and transport properties. Deep eutectic solvent (DES) systems are composed of at least one main solvent and an additional component that is meant to interrupt the original solvent/solvent interactions, thereby introducing lower melting points relative to each individual component. Ethaline (a 1:2 mole% mixture of choline chloride and ethylene glycol) is one of the most promising DES systems. However, it is also known to be very hygroscopic, which is a constant concern because water absorption during the use of ethaline alters its properties. Within this work, we demonstrate that modest amounts of water addition (1-10%) to ethaline are of little concern for practical use and can even lead to performance improvements, such as accelerated relaxation and solvation. In contrast, very small amounts of <1% of water lead to additional slowing of the solvent response. Thus, we suggest that the attempt to dry ethaline below 1% moisture is rather counter-productive if one attempts to achieve effective solvation and charge transport properties from DESs. This study investigates the effect of water content on the diffusional relaxation dynamics of ethaline. A set of independent spectroscopic experiments and computational simulations are aimed to provide insight into the solvent response of the DES system using femtosecond time-resolved absorption spectroscopy (fs-TA), broadband dielectric spectroscopy (BDS), nuclear magnetic resonance (NMR) diffusometry and broadband relaxometry, and molecular dynamics simulations (MDS) on ethaline with 0, 0.1, 1, 10, and 28.5wt% added water. For dry ethaline, we identify choline chloride as the rate-limiting solvation component in ethaline. However, the role of the solvent components changes gradually as water is added. Further, we provide quantitative solvent relaxation rates using the different presented time-resolved spectroscopic techniques and find remarkable agreement between them. Based on the solvent relaxation rates and combined with MDS, we develop a molecular understanding of the individual solvent components and their interactions in dry and wet ethaline with varying amounts of water content.

25 ENERGY STORAGE↗

The electrolyte challenge for a direct methanol-air polymer electrolyte fuel cell operating at temperatures up to 200 C

Novel polymer electrolytes are being evaluated for use in a direct methanol-air fuel cell operating at temperatures in excess of 100 C. The evaluation includes tests of thermal stability, ionic conductivity, and vapor transport characteristics. The preliminary results obtained to date indicate that a high temperature polymer electrolyte fuel cell is feasible. For example, Nafion 117 when equilibrated with phosphoric acid has a conductivity of at least 0.4 Omega(exp -1)cm(exp -1) at temperatures up to 200 C in the presence of 400 torr of water vapor and methanol vapor cross over equivalent to 1 mA/cm(exp 2) under a one atmosphere methanol pressure differential at 135 C. Novel polymers are also showing similar encouraging results. The flexibility to modify and optimize the properties by custom synthesis of these novel polymers presents an exciting opportunity to develop an efficient and compact methanol fuel cell.

Savinell, Robert↗