Engineering topics

Scholl, Marija S.

Publications and source records attributed to Scholl, Marija S..

22 records · Page 2

NASA NTRS1988

Measurement of small temperature fluctuations at high average temperature

Both absolute and differential temperature measurements were simultaneously performed as a function of time for a pixel on a high-temperature, multi-spectral, spatially and temporally varying infrared target simulator. A scanning laser beam was used to maintain a pixel at an on-the-average constant temperature of 520 K. The laser refresh rate of up to 1 kHz resulted in small-amplitude temperature fluctuations with a peak-to-peak amplitude of less than 1 K. The experimental setup to accurately measure the differential and the absolute temperature as a function of time is described.

Scholl, James W.↗

NASA NTRS1987

Time- and position-varying infrared scene simulation

Rapidly changing infrared scenes can be generated as a function of position using thermally produced irradiance. This can be done most conveniently by using a variable dwell-time, variable diameter, and scanning laser beam to deposit a predetermined amount of laser energy, as a function of position, on the target surface. An infrared target simulator has been designed and tested to perform within stringent temperature simulation requirements: heating rate of over 100 K/sec is achieved, and temperature gradients of 200 K/mm can be maintained. Problems with heat transfer between adjacent elements at different temperatures are solved by modeling the thermal layer on the target surface as a low-pass filter, which cuts off all the frequencies above the thermal cutoff frequency. When the system approach is taken to the infrared simulation design, the optical system limited performance results in the best realizable performance. In this case, the thermal layer on the target surface is designed so that the thermal cutoff frequency is above the optical cutoff frequency.

Scholl, Marija S.↗

NASA NTRS1987

Cockpit readiness for night vision goggles

The introduction of night vision goggles into the cockpit environment may produce incompatibility with existing cockpit optoelectronic instrumentation. The methodology used to identify the origin of the spurious signal is demonstrated with the example of an electronic display. The amount of radiation emitted by a gray body in the wavelength region of goggle sensitivity is calculated. A simple procedure for preflight testing of cockpit instrumentation using a commercially available infrared camera is recommended. Other recommendations include the specification of cocklpit instrumentation for compatibility with night vision devices.

Scholl, Marija S.↗

NASA NTRS1987

Three beam-combining schemes in a color projection display

Several beam-combining schemes for on-axis and off-axis optical system layout are presented. The on-axis approaches include two crossed plates with dichroic coatings placed at 90 deg, with respect to each other, and a pentaprism arrangement. The off-axis layout of the cathode ray tubes requires that the images be combined at the display screen. These image-combining approaches are compared for the standard television rates of 525 lines and the high-resolution television at 1200/2000 lines under development in Japan. It is concluded that, for the high-performance, high-color fidelity, and high-resolution projection systems, which are expected to fit into a small volume of space such as a Space Station display or a cockpit panoramic display, a folded configuration with either crossed plates or pentaprism plates will result in an optimum color display.

Scholl, Marija S.↗