Engineering topics

Shah, Biren

Publications and source records attributed to Shah, Biren.

11 records

NASA NTRS2022

Cross-Cutting Flight Infrastructure Improvements on M2020

Mars2020 (M2020) was formulated as a mission that leveraged as much Mars Science Laboratory (MSL) heritage as possible, while focusing major new development efforts on the original and unique elements needed to accomplish the different mission objectives. Well publicized examples of high profile new developments include precision landing, the sampling and caching system, the specific instrument suite, improved mobility via Autonomous Navigation, and later the addition of the Ingenuity helicopter. Less well known are the refinements to the core flight infrastructure, primarily in the cross-cutting functions of Telecom, Avionics, Data Management, Communications Behaviors, and Parameter Management. These enhancements are introduced predominately via flight software, and represent increases in capability that justified their inclusion in an otherwise heritage-focused project environment.Perseverance’s cross-cutting flight infrastructure improvements fall into and across the following five categories. First is a trimming of the software footprint of infrastructure modules, in order to make room for memory demands elsewhere in the system. Second is the minimization of data volume to be downlinked, through various methods such as the incorporation of new compression options. Third is the maximization of the available downlink bandwidth for data, by curtailing content-less data (fill) and introducing an improved UHF proximity link protocol. Fourth is a reduction in vulnerabilities, through increased file system redundancy, robustness, and software process monitoring. Fifth is an increase in operations efficiency by lowering file system mount times, improving parallelism between simultaneous events, minimizing the time to recover from file system errors, streamlining the purging of obsolete data, and reducing the number of commands to service parameters by a factor of 100.Individually, none of the cross-cutting infrastructure improvements are likely to garner headlines, but collectively they appreciably improve the safety and operability of Perseverance over its predecessor. This paper will describe the improvements, their promise, and where applicable, their actual impact in operations.

Bohannon, Emily↗

NASA NTRS2016

Evolution of the Mars Relay Network End-To-End Information System in the Mars Human Era (2016-2040)

In order to help the reader understand this evolution from the current to the future MRN state in the Mars human era, we will provide a description of the current communication infrastructure supporting Mars mission users, and how we envision it to change in order to meet the needs and challenges of supporting both human and robotic communication by 2030-2040. This includes the introduction of new data types like audio and video, and new in-situ relay services for communications and navigation services.

Kazz, Greg↗

NASA NTRS2016

Evolution of the Mars Relay Network End-to-End Information System in the Mars Human Era (2030-2040)

Kazz, Greg J.↗

NASA NTRS2010

A High-Throughput, Adaptive FFT Architecture for FPGA-Based Space-Borne Data Processors

Historically, computationally-intensive data processing for space-borne instruments has heavily relied on ground-based computing resources. But with recent advances in functional densities of Field-Programmable Gate-Arrays (FPGAs), there has been an increasing desire to shift more processing on-board; therefore relaxing the downlink data bandwidth requirements. Fast Fourier Transforms (FFTs) are commonly used building blocks for data processing applications, with a growing need to increase the FFT block size. Many existing FFT architectures have mainly emphasized on low power consumption or resource usage; but as the block size of the FFT grows, the throughput is often compromised first. In addition to power and resource constraints, space-borne digital systems are also limited to a small set of space-qualified memory elements, which typically lag behind the commercially available counterparts in capacity and bandwidth. The bandwidth limitation of the external memory creates a bottleneck for a large, high-throughput FFT design with large block size. In this paper, we present the Multi-Pass Wide Kernel FFT (MPWK-FFT) architecture for a moderately large block size (32K) with considerations to power consumption and resource usage, as well as throughput. We will also show that the architecture can be easily adapted for different FFT block sizes with different throughput and power requirements. The result is completely contained within an FPGA without relying on external memories. Implementation results are summarized.

Nguyen, Kayla↗

NASA NTRS2009

Generating Ka-Band Signals Using an X-Band Vector Modulator

A breadboard version of a transmitter for radio communication at a carrier frequency of 32 GHz (which is in the Ka band) utilizes a vector modulator operating at a carrier frequency of 8 GHz (the low end of the X band) to generate any of a number of advanced modulations that could include amplitude and/or phase modulation components. The 8-GHz modulated signal is mixed with a 24-GHz signal generated by an upconverter to obtain the desired 32-GHz modulated output. The transmitter is being developed as a prototype of downlink transmitters for transmission of data from spacecraft to Earth at high rates (>100 Mb/s). The transmitter design could also be adapted to terrestrial and Earth/satellite communication links. The advanced modulations (which can include M-ary phase-shift keying (M-PSK), offset phase-shift keying (OPSK), and M-ary quadrature amplitude modulation (M-QAM). These modulations are needed because for a given amount of signal bandwidth, they enable transmission of data at rates greater than those of older, simpler modulation schemes. The transmitter architecture (see figure) was chosen not only to enable generation of the required modulations at 32 GHz but also to reduce the number of components needed to implement the transmitter. Instead of incorporating an 8-GHz signal source, the transmitter utilizes an 8-GHz signal generated by a voltage-controlled oscillator that is part of an X-band transponder with which the fully developed version of this transmitter would be used in the original intended spacecraft application. The oscillator power is divided onto two paths, one of which goes through the vector modulator, the other through amplifiers and a 3 frequency multiplier. Band-pass filters are included downstream of the frequency multiplier to suppress unwanted harmonics.

Smith, Scott↗

NASA NTRS2007

Wide Tuning Capability for Spacecraft Transponders

A document presents additional information on the means of implementing a capability for wide tuning of microwave receiver and transmitter frequencies in the development reported in the immediately preceding article, VCO PLL Frequency Synthesizers for Spacecraft Transponders (NPO- 42909). The reference frequency for a PLL-based frequency synthesizer is derived from a numerically controlled oscillator (NCO) implemented in digital logic, such that almost any reference frequency can be derived from a fixed crystal reference oscillator with microhertz precision. The frequency of the NCO is adjusted to track the received signal, then used to create another NCO frequency used to synthesize the transmitted signal coherent with, and at a specified frequency ratio to, the received signal. The frequencies can be changed, even during operation, through suitable digital programming. The NCOs and the related tracking loops and coherent turnaround logic are implemented in a field-programmable gate array (FPGA). The interface between the analog microwave receiver and transmitter circuits and the FPGA includes analog-to-digital and digital-toanalog converters, the sampling rates of which are chosen to minimize spurious signals and otherwise optimize performance. Several mixers and filters are used to properly route various signals.

Lux, James↗

NASA NTRS2004

Onboard FPGA-based SAR processing for future spaceborne systems

We present a real-time high-performance and fault-tolerant FPGA-based hardware architecture for the processing of synthetic aperture radar (SAR) images in future spaceborne system. In particular, we will discuss the integrated design approach, from top-level algorithm specifications and system requirements, design methodology, functional verification and performance validation, down to hardware design and implementation.

spaceborne systems↗

NASA NTRS1995

Buffered Telemetry Demodulator

Buffered telemetry demodulator (BTD) is radio receiver designed mainly for recovery of low-rate data binery phase-modulated onto square-wave subcarrier on sinusoidal or suppressed sinusoidal carrier signal and received at low symbol-to-noise ratio. In BTD, received signal not only processed in real time but also recorded and subsequently reprocessed to recover data otherwise lost. BTD could be implemented on general-purpose computer workstation.

Tsou, Haiping↗

NASA NTRS1995

Comparison Of Full-Spectrum And Complex-Symbol Combining

Report presents theoretical study of anticipated performances of two methods of combining S-band signals from Galileo spacecraft received in multiple antennas of NASA's Deep Space Network (DSN). Signal transmitted by spacecraft consists of binary data signal phase-modulated onto square-wave subcarrier that is, in turn, amplitude-modulated onto S-band carrier.

Million, Samson↗

NASA NTRS1993

Application of multirate digital filter banks to wideband all-digital phase-locked loops design

A new class of architecture for all-digital phase-locked loops (DPLL's) is presented in this article. These architectures, referred to as parallel DPLL (PDPLL), employ multirate digital filter banks (DFB's) to track signals with a lower processing rate than the Nyquist rate, without reducing the input (Nyquist) bandwidth. The PDPLL basically trades complexity for hardware-processing speed by introducing parallel processing in the receiver. It is demonstrated here that the DPLL performance is identical to that of a PDPLL for both steady-state and transient behavior. A test signal with a time-varying Doppler characteristic is used to compare the performance of both the DPLL and the PDPLL.

Sadr, Ramin↗

NASA NTRS1990

The split symbol moments SNR estimator in narrow-band channels

The split symbol moments estimator is an algorithm that is designed to estimate symbol SNR in the presence of additive white Gaussian noise. The performance of the algorithm in band-limited channels is examined, and the effects of the resulting intersymbol interference are quantified. All results obtained are in closed form and can be easily evaluated numerically for performance-prediction purposes. The results are also validated through digital simulations.

Shah, Biren↗