Search NASA⌕ Search

Engineering topics

Steger, Joseph L.

Publications and source records attributed to Steger, Joseph L..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

3D Euler flow solutions using unstructured Cartesian and prismatic grids

A hyperbolic prismatic grid generation technique is combined with a background Cartesian grid for the study of inviscid three-dimensional flows. The mathematics of the hyperbolic prismatic grid generation algorithm are described, and some simple inviscid demonstration cases are presented. By combining the simplicity of the Cartesian background grid with the geometric flexibility and computational efficiencies inherent to prismatic grids, this approach shows promise for improving computational aerodynamic simulations.

Melton, John E.↗
NASA NTRS1992

CFD goes to school

The part that universities should play in the future development of CFD, which must be evaluated in light of CFD's pacing elements and challenges, is discussed. Attention is given to CFD pacing items that must be in place before routine aerodynamic simulation can be performed including grid generation and geometry surface definition, solution adaptive meshing, more efficient time-accurate simulation, modeling of real-gas effects, multiple relative body motion, and prediction of transition and turbulence modeling. As universities have contributed to research in CFD from its inception, this research should continue to enhance and motivate teaching, improve CFD as a discipline, and stimulate faculty and students.

Steger, Joseph L.↗
NASA NTRS1991

A General-Coordinate Formulation For Boundary-Layer Flow

Formulation for solution of equations of boundary-layer flow in general body-fitted curvilinear coordinates retains velocities in Cartesian coordinates. Increases stability of numerical simulations by avoiding coordinate source terms. In formulation, curvilinear coordinates do not have to be orthogonal, and much of software developed previously for use in numerical simulations of flow based on Navier-Stokes equations used.

Steger, Joseph L.↗
NASA NTRS1991

Computational Fluid Dynamics In Aerospace

Report reviews recent progress in computational fluid dynamics (CFD). Addresses state of art in terms of methods, examples of solutions, and computer technology. Provides examples of CFD solutions of aerospace and fluid-physics problems to illustrate recent progress. Aerospace solutions include rotor/stator velocity vectors from three-dimensional Navier-Stokes code for turbomachinery, pressure distributions from simulation of aeroelasticity of wing surface-pressure contours on four-bladed helicopter rotor in forward flight, and particle traces about several aerospace vehicles. Computer technology covers supercomputers, scientific work stations, local supercomputing networks, and remote access to supercomputers.

Kutler, Paul↗
NASA NTRS1991

Thoughts on the chimera method of simulation of three-dimensional viscous flow

The chimera overset grid is reviewed and discussed relative to other procedures for simulating flow about complex configurations. It is argued that while more refinement of the technique is needed, current schemes are competitive to unstructured grid schemes and should ultimately prove more useful.

Steger, Joseph L.↗
NASA NTRS1991

Collar grids for intersecting geometric components within the Chimera overlapped grid scheme

A method for overcoming problems with using the Chimera overset grid scheme in the region of intersecting geometry components is presented. A 'collar grid' resolves the intersection region and provides communication between the component grids. This approach is validated by comparing computed and experimental data for a flow about a wing/body configuration. Application of the collar grid scheme to the Orbiter fuselage and vertical tail intersection in a computation of the full Space Shuttle launch vehicle demonstrates its usefulness for simulation of flow about complex aerospace vehicles.

Parks, Steven J.↗
NASA NTRS1991

A generalized scheme for three-dimensional hyperbolic grid generation

A hyperbolic grid generation scheme formulated from grid orthogonality and cell volume specification is generalized such that high quality three-dimensional grids can be obtained for a wide variety of geometries. The speed of the scheme is one to two orders of magnitude faster than typical elliptic grid generation methods. The robustness of the scheme is significantly enhanced by several new techniques. By using a spatially variable smoothing coefficient, orthogonality and smoothness of the grid are maintained around complex concave and convex surface topologies. A metric correction procedure is employed to guarantee that the grid marches out of a corner by bisecting the angles subtended by the neighboring points. Extra robustness at severe convex corners is achieved by special local treatments. Different extrapolation methods are used to provide smoothness at floating edges and axis regions. The versatility of the new hyperbolic grid generation scheme is demonstrated by three-dimensional grids generated for external components of the intergrated Space Shuttle vehicle and the SOFIA telescope.

Chan, William M.↗
NASA NTRS1990

Numerical simulation of three-dimensional transonic flows

The three-dimensional flow over a projectile has been computed using an implicit, approximately factored, partially flux-split algorithm. A simple composite grid scheme has been developed in which a single grid is partitioned into a series of smaller grids for applications which require an external large memory device such as the SSD of the CRAY X-MP/48 or multi-tasking. The accuracy and stability of the composite grid scheme have been tested by numerically simulating the flow over an ellipsoid at an angle of attack and comparing the solution with a single-grid solution. The flow field over a projectile at M = 0.96 and 1.1, and 4-deg angle of attack has been computed using a fine grid and compared with experiment.

Sahu, Jubaraj↗
NASA NTRS1989

Numerical aerodynamic simulation of the space shuttle ascent environment

After the STS 51-L accident, an extensive review of the Space Shuttle Orbiter's ascent aerodynamic loads uncovered several questionable areas that required further analysis. The insight gained by comparing the Shuttle ascent CFD numerical simulations, obtained by the NASA Ames Space Shuttle Flow Simulation Group, to the current IVBC-3 aerodynamic loads database was instrumental in resolving uncertainties on the Orbiter payload bay doors and fuselage. Initial confidence in the numerical simulations was gained by comparing them with the limited flight data that had been obtained during the Orbiter Flight Test (OFT) program. Current CFD results exist for Mach numbers 0.6, 0.9, 1.05, 1.55, 2.0, and 2.5. Since the pre STS-1 wind tunnel test program (IA-105) often yields considerable differences when compared to STS-5 flight data, the M(sub infinity) = 1.05 transonic case is the most investigated. The IA308 mated-vehicle hot gas plume wind tunnel test, recently completed at AEDC 16T (transonic) and Lewis (hypersonic), is also used to compare with the computation where applicable.

Slotnick, Jeff P.↗
NASA NTRS1989

Navier-Stokes and viscous-inviscid interaction

Some considerations toward developing numerical procedures for simulating viscous compressible flows are discussed. Both Navier-Stokes and boundary layer field methods are considered. Because efficient viscous-inviscid interaction methods have been difficult to extend to complex 3-D flow simulations, Navier-Stokes procedures are more frequently being utilized even though they require considerably more work per grid point. It would seem a mistake, however, not to make use of the more efficient approximate methods in those regions in which they are clearly valid. Ideally, a general purpose compressible flow solver that can optionally take advantage of approximate solution methods would suffice, both to improve accuracy and efficiency. Some potentially useful steps toward this goal are described: a generalized 3-D boundary layer formulation and the fortified Navier-Stokes procedure.

Steger, Joseph L.↗
NASA NTRS1989

Generation of three-dimensional body-fitted grids by solving hyperbolic and parabolic partial differential equations

Hyperbolic grid generation procedures are described which have been used in external flow simulations about complex configurations. For many practical applications a single well-ordered (i.e., structured) grid can be used to mesh an entire configuration, in other problems, composite or unstructured grid procedures are needed. Although the hyperbolic partial differential equation grid generation procedure has mainly been utilized to generate structured grids, extension of the procedure to semiunstructured grids is briefly described. Extensions of the methodology are also described using two-dimensional equations.

Steger, Joseph L.↗
NASA NTRS1989

Generation of three-dimensional body-fitted grids by solving hyperbolic partial differential equations

Hyperbolic grid generation procedures are described which have been used in external flow simulations about complex configurations. For many practical applications a single well-ordered (i.e., structured) grid can be used to mesh an entire configuration, in other problems, composite or unstructured grid procedures are needed. Although the hyperbolic partial differential equation grid generation procedure has mainly been utilized to generate structured grids, an extension of the procedure to semiunstructured grids is briefly described. Extensions of the methodology are also described using two-dimensional equations.

Steger, Joseph L.↗
NASA NTRS1989

Basic numerical methods

Some of the basic finite-difference schemes that can be used to solve the nonlinear equations that describe unsteady inviscid and viscous transonic flow are reviewed. Numerical schemes for solving the unsteady Euler and Navier-Stokes, boundary-layer, and nonlinear potential equations are described. Emphasis is given to the elementary ideas used in constructing various numerical procedures, not specific details of any one procedure.

Steger, Joseph L.↗
NASA NTRS1988

A formulation for the boundary-layer equations in general coordinates

This is a working paper in which a formulation is given for solving the boundary-layer equations in general body-fitted curvilinear coordinates while retaining the original Cartesian dependent variables. The solution procedure does not require that any of the coordinates be orthogonal, and much of the software developed for many Navier-Stokes schemes can be readily used. A limited number of calculations has been undertaken to validate the approach.

Steger, Joseph L.↗
NASA NTRS1988

Numerical investigation of a jet in ground effect using the fortified Navier-Stokes scheme

One of the flows inherent in VSTOL operations, the jet in ground effect with a crossflow, is studied using the Fortified Navier-Stokes (FNS) scheme. Through comparison of the simulation results and the experimental data, and through the variation of the flow parameters (in the simulation) a number of interesting characteristics of the flow have been observed. For example, it appears that the forward penetration of the ground vortex is a strong inverse function of the level of mixing in the ground vortex. Also, an effort has been made to isolate issues which require additional work in order to improve the numerical simulation of the jet in ground effect flow. The FNS approach simplifies the simulation of a single jet in ground effect, but it will be even more effective in applications to more complex topologies.

Vandalsem, William R.↗
NASA NTRS1988

Computational fluid dynamics in aerospace

The status of computational fluid dynamics (CFD) is addressed in terms of methods, examples of CFD solutions, and computer technology. The examples are divided into aerospace applications and fluid physics applications, with the aerospace applications section being further divided into internal and external flows. The role CFD is expected to play in supporting the goals set forth by the Aeronautical Policy Review Committee established by the Office of Science and Technology Policy is noted.

Kutler, Paul↗
NASA NTRS1987

On the use of composite grid schemes in computational aerodynamics

Some of the composite grid approaches used in aerodynamic applications and the associated advantages and difficulties are reviewed. In particular, attention is given to patched grid schemes, overset grid schemes, and the computational aspects of composite grid schemes. As an example of a computational procedure, an algorithm is presented for constructing a hole in a grid caused by a body overset onto another grid.

Steger, Joseph L.↗