Search NASA⌕ Search

Engineering topics

Tapriyal, Deepak

Publications and source records attributed to Tapriyal, Deepak.

At least 19 records

Caprock Remains Water Wet Under Geologic CO 2 Storage Conditions

Abstract Carbon storage technology is primarily targeted in saline formations, which is a porous rock matrix filled with brine, sealed with a low permeability caprock. There are significant variations of CO 2 wetting properties, typically reported in the literature as contact angle of CO 2 and brine interacting with a rock material, suggesting that CO 2 could become wetting under geostorage conditions and negatively impact containment effectiveness. Here, we performed the first controlled laboratory measurements of CO 2 ‐brine contact angles on shale rocks from low permeability sealing formations with distinctive mineralogic properties—calcite‐rich, quartz‐rich, and dolomite‐rich. We targeted temperatures at 40° and 100°C, pressures at 8.3, 34.5, and 62.1 MPa, and salinity at 35,000 and 260,000 ppm. Results show no significant change in contact angle with mineralogy, temperature, pressure, salinity, and CO 2 bubble size. We conclude that caprocks will remain water‐wet at geologic CO 2 storage conditions and will not lose their capillary sealing capacity.

Tapriyal, Deepak↗

Initial Laboratory Measurements Probing Hydrogen Interactions with Eagle Ford Shale and Pyrite: Potential Implications for Subsurface Hydrogen Storage

Hydrogen (H 2 ) has the potential to be a transformative technology as an enabler to a low-carbon future and promoter of renewable energy. When H 2 is injected and stored in the subsurface, it has the potential to interact with the caprock (usually shale) which overlies and seals the storage reservoir. Here, this study examines geochemical reactions or changes in surface morphology to Eagle Ford Shale, a proxy for caprock, upon exposure to H 2 at 50°C and 10.3 MPa. Reactions were also performed with N 2 to provide an experimental control. Scanning Electron Microscopy with Energy Dispersive Spectroscopy (SEM-EDS), Atomic Force Microscopy (AFM), and Optical Photothermal-Infrared (O-PTIR) Spectroscopy were applied to quantify changes on the microscale and nanoscale level. Fluid chemistry changes were monitored with Ion Chromatography (IC) and Inductively Coupled Plasma Mass Spectrometry (ICP-MS). Exposure of Eagle Ford Shale to H 2 gas alone did not result in any alterations to the shale chemically or any changes in the surface morphology. Exposure of Eagle Ford Shale to both H 2 and water as well as N 2 and water resulted in changes to the surface morphology because of gypsum dissolution and reprecipitation, thus indicating that H 2 is not necessary to promote changes. Pure pyrite was the most reactive with H 2 possibly resulting in a reduction to pyrrhotite. These initial studies suggest that the extent of reactions activated by hydrogen with caprock are minor under the temperature and pressure conditions that would represent underground hydrogen storage.

08 HYDROGEN↗

H2 Wettability, Permeability, and Diffusion

This presentation provides experimental results for H2 wetting, permeability and diffusion with reservoir caprock, reservoir rock, and wellbore cement.

Hanson, Angela Goodman↗

EOR in Shale Resources

This work provides an overview of the research conducted at NETL and the University of Pittsburgh related to improving the perfornace of CO2 huff-and-puff enhanced oil recovery (EOR) in fractured shale and fractured tight formations. CO2-soluble wettability-altering surfactants will be dissolved in high pressure CO2 during the "huff" stages in an attempt to shift the wettability of shale surfaces away from oil-wet toward CO2-wet. Such a change should promote additinal oil recovery during the depressurization of the formation that occurs during the "puff" stages. Surfactant soubility in CO2, CO2-oil IFT, CO2-rock-oil contact angle, and core-scale huff and puff oil recovery results are presented.

Enick, Robert↗

CO 2 -Soluble Nonionic Surfactants for Enhanced CO 2 Storage via In Situ Foam Generation

Geologic carbon storage (GCS) is a rapidly evolving technology with the potential to reduce the environmental impact of fos-sil fuels. Saline aquifers, which comprise a sandstone matrix with brine in the pores, make up much of the pore space availa-ble for CO 2 storage in the United States. When CO 2 is injected in saline aquifers, however, capillary fingering occurs and only a small percentage of the pore space is filled with CO 2 . This is due to the low viscosity of CO 2 , which is roughly ten times less viscous than brine. To address this problem, we tested the ability of inexpensive, commercially available nonionic surfactants to be dissolved in the injected CO 2 and increase the apparent viscosity of CO 2 by generating CO 2 -in-water foams in situ.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Using high pressure solutions of polyfluoroacrylate and CO 2 to Seal cement cracks for improved wellbore integrity

Polyfluoroacrylate (PFA) is a hydrophobic and oleophobic polymer that is soluble in high pressure carbon dioxide (CO 2 ). In this study, the ability of PFA-CO 2 solutions to greatly reduce the apparent permeability of split or cracked Portland cement cylindrical samples is assessed. The apparent permeability values of confined samples were determined before and after treatment with PFA-CO 2 solutions. In four tests, PFA-CO 2 solutions were continuously displacing pure CO 2 from the cracked cement and the decrease in apparent permeability due to PFA adsorption and wettability alteration was monitored. The lowest apparent permeability cracked cement sample (81 nD) was completely sealed with a very small amount of solution. Samples with initial apparent permeabilities of 89 μD and 29.4 mD exhibited 92% and 99% reductions in permeability, respectively, before the experiments had to be stopped because of the excessively large increase in pressure drop. A 50% reduction in apparent permeability was observed with a 3.80 mD sample. Four other split cement samples (bound together with tape) with an initial apparent permeability in the 9.0–70 mD range were removed from the core holder and immersed in a PFA-CO 2 solution for 24 h to allow for PFA adsorption. Then the PFA-CO 2 solution was depressurized, allowing for the deposition of additional PFA from the solution within the crack as the pressure fell below the cloud point pressure of the PFA-CO 2 solution. These four samples were then confined again in a core holder and apparent permeability reductions of 29–93% were observed. Finally, results from these eight experiments indicates that the more substantial reductions in the nD – mD apparent permeability of the cracked cement correlated to lower initial crack permeability, higher PFA concentration, and slower injection rate of the PFA-CO 2 solution into the crack.

58 GEOSCIENCES↗

Dissolving Nonionic Surfactants in CO 2 to Improve Oil Recovery in Unconventional Reservoirs via Wettability Alteration

CO 2 injection is a promising method for enhanced oil recovery (EOR) in unconventional shale reservoirs. Here, in this work, we postulate that CO 2 EOR may be improved by the dissolution of surfactants into CO 2 . Although CO 2 is a relatively good solvent for oil, we show that CO 2 and Eagle Ford oil are immiscible at compositions above 70 wt % CO 2 , even at pressures as high as 62 MPa. The presence of a CO 2 –oil interface at reservoir conditions indicates that the addition of a surfactant has the potential to improve oil recovery–via wettability alteration from oil-wet to CO 2 -wet, CO 2 –oil interfacial tension (IFT) reduction, or both. Three nonionic surfactants (branched tridecyl ethoxylate Indorama SURFONIC TDA-9, branched nonylphenol ethoxylate Indorama SURFONIC N-100, and linear dodecyl ethoxylate Indorama SURFONIC L12-6) were evaluated for CO 2 -solubility, shale wettability alteration, effect on CO 2 –oil IFT, ability to generate CO 2 –oil foams, and ability to increase oil extraction from Eagle Ford, Mancos, and Bakken shale cores. Each surfactant dissolved in CO 2 up to 1 wt % at pressures and temperatures commensurate with CO 2 EOR. CO 2 -dissolved surfactants did not significantly affect CO 2 –oil IFT or generate CO2–oil foams, but they did induce a dramatic change in the contact angle of an oil droplet on an oil-aged shale chip in CO 2 from strongly oil-wet (11°) toward intermediate CO 2 –oil wettability (82°) (at 80 °C, 27.6 MPa). The branched tridecyl ethoxylated surfactant, SURFONIC TDA-9, afforded the highest oil recovery in core soaking experiments–75%, compared to 71% by pure CO 2 . Analysis of oil extracts by gas chromatography revealed that heavier oil components were produced when the surfactant was added to CO 2 . These results indicate that CO 2 -dissolved surfactants may increase oil recovery from shale by wettability alteration from oil-wet toward CO 2 -wet.

04 OIL SHALES AND TAR SANDS↗

Contact Angle Measurements Using Sessile Drop and Micro-CT Data from Six Sandstones

Numerous sessile drop and micro-computed tomography (micro-CT) studies have been conducted to quantify Geologic Carbon Storage formation wettability by measuring static contact angles (θ); however, the influence of pore geometry remains unknown. In this work, six sandstones (Bandera Brown, Berea, Bentheimer, Mt. Simon, Navajo, and Nugget) are used to measure θ using the two aforementioned experimental methods at identical testing conditions (45°C and 12.41 MPa). The range of θ measured at in situ conditions (micro-CT) exceeds those the range at ex situ (sessile drop method) conditions for all sandstones. However, when droplets with more representative in situ diameters are analyzed, θ averages show ex situ θ exceed those of in situ θ. Pore geometry does influence local θ, but the size of ex situ droplets relative to pore size appears to influence θ. This is an important to consider for future sessile drop studies used for analysis of CO 2 behavior in carbon storage reservoirs.

36 MATERIALS SCIENCE↗

CO 2 –Brine Contact Angle Measurements on Navajo, Nugget, Bentheimer, Bandera Brown, Berea, and Mt. Simon Sandstones

In this study, contact angles were measured for CO 2 bubbles on six different sandstones (Navajo, Nugget, Bentheimer, Bandera Brown, Berea, and Mt. Simon) that could potentially represent properties of CO 2 storage depositional environments. The impacts of pressure and temperature were studied by focusing on the CO 2 phase behavior in three different scenarios: gaseous, liquid, and supercritical conditions. Despite controlling the sample preparation and cleanliness, CO 2 -brine equilibration conditions, and pressure and temperature, there were inconsistencies in contact angle trends that could largely be attributed to natural sample heterogeneity resulting from localized variations in topography, surface roughness, and mineral composition across the surface. Despite these variations, the analysis of 298 measurements from this study showed that 81% of the contact angles were below 40° representing strongly water-wet to (moderately) water-wet behaviors. Also, 17.3% of the measurements were between 40° and 60° (weakly water-wet) and primarily belonged to small CO 2 bubbles (< 500 μm) that were heavily impacted by localized surface heterogeneity in natural sandstone samples. Additionally, only 1.7% of the measurements had angles greater than 60° and could be classified as CO 2 -wet behavior, but these measurements occurred on extremely small bubbles (100-200 μm) that were very dependent on localized surface heterogeneity. While some of the detailed physics of the CO 2 -brine-sandstone interface is still poorly understood, from an application standpoint, the sandstones of this study were best characterized as strongly water-wet to (moderately) water-wet.

03 NATURAL GAS↗

High-Temperature, High-Pressure Volumetric Properties of Propane, Squalane, and Their Mixtures: Measurement and PC-SAFT Modeling

This study reports the high-temperature, high-pressure density data for propane, squalane, and their binary mixtures for five compositions, at temperatures to 520 K and pressures to 260 MPa. The density measurements are obtained with a floating-piston, variable-volume, high-pressure view cell. From the density data, the isothermal and isobaric excess molar volumes upon mixing are computed. For the mixture compositions studied here, the excess volume is mostly negative at 0.6550 mole fraction of propane and becomes less negative as the propane concentration increases. The perturbed-chain statistical associating fluid theory (PC-SAFT) equation of state (EoS) provides good representation for the experimental data, which on average is within 1.6%, when using pure-component parameters obtained from the literature. In addition, the PC-SAFT EoS also provides reasonable modeling performance, within 2.0% on average, when using group contribution methods to predict the pure-component parameters.

03 NATURAL GAS↗